What is the top speed of the domestic Ninja?

1 Answers
LaLaura
07/30/25 12:49am
On a closed section of about two kilometers, the highest speed in sixth gear is approximately 118 km/h, and it might reach 120 km/h when going downhill. Power at top speed for the Ninja: The domestic Ninja is equipped with a Delphi EFI system meeting China IV emission standards, a V-Twin liquid-cooled Weslake 400CC engine, using French imported Motul 7100 10W-40 viscosity oil, American imported Prestone antifreeze, and Japanese imported NGK iridium spark plugs. Fuel consumption at top speed for the Ninja: The domestic Ninja is a twin-cylinder 250CC motorcycle produced by Taromoto, with a fuel consumption of approximately 3.7 to 4.0 liters per 100 kilometers.
Was this review help?
5
1
Share
More Forum Discussions

What Causes a Car Compressor to Stop Working?

Here are the specific reasons why a car air conditioning compressor may stop working: 1. Electrical system failure. A short circuit or open circuit in the wiring directly disrupts the power transmission path, preventing the electromagnetic clutch from properly controlling the compressor's operation. 2. Lack of refrigerant. The refrigerant mixes with the compressor oil and circulates back to the compressor through the system. If the Freon in the refrigerant is depleted, it can lead to insufficient oil return, reducing lubrication and causing the compressor to seize or fail. 3. Mechanical wear of the compressor. Prolonged operation under high-speed and heavy-load conditions can cause premature mechanical wear of compressor components, rendering it inoperable. 4. Over-tightened drive belt. An excessively tight drive belt can directly prevent the compressor from running, so it's important to regularly check the belt's tension. Conversely, a loose drive belt can cause the compressor's power transmission to slip, resulting in intermittent cooling and reduced efficiency.
6
0
Share

What is the solution for the P0366 trouble code?

p0366 trouble code solution is: 1. Turn the ignition switch to the ON position; 2. Disconnect the camshaft position sensor connector on the harness, and use a multimeter to check whether the voltage between pin 1 of the connector and the ground is around 12V; 3. Disconnect the camshaft position sensor connector on the harness, and use a multimeter to check whether the voltage between pin 2 of the connector and the ground is around 11.5V; 4. Use a multimeter to check whether there is an open circuit or short circuit between pin 79 of the ECU and pin 2 of the sensor connector; 5. Disconnect the camshaft position sensor connector on the harness, and use a multimeter to check whether there is continuity between pin 3 of the connector and the ground; 6. Connect the sensor connector and start the engine; 7. Use an oscilloscope to check whether there is a square wave signal output of around 6V on the No. 2 signal line.
17
5
Share

What are the causes of intermittent shaking in Wuling Hongguang?

The causes of intermittent shaking in Wuling Hongguang are: 1. Tire-related faults; 2. Severe engine carbon buildup; 3. Issues with the ignition system. Taking the 2020 Wuling Hongguang as an example, it belongs to the microvan category with body dimensions of: length 4390mm, width 1660mm, height 1750mm, a wheelbase of 2720mm, a fuel tank capacity of 50 liters, and a curb weight of 1185kg. The 2020 Wuling Hongguang features a MacPherson strut front suspension and a leaf spring rear suspension. It is equipped with a 1.2L naturally aspirated engine producing a maximum horsepower of 76PS, a maximum power of 56kW, and a maximum torque of 110Nm, paired with a 5-speed manual transmission.
14
3
Share

How many kilometers does a car need to travel before requiring a wheel alignment?

Wheel alignment for cars is a maintenance service with no strict requirement on frequency, primarily determined by the actual usage conditions of the vehicle. Below is an introduction to car wheel alignment: 1. Wheel alignment adjusts the angles and relative positions between the car tires, steering system, suspension system, and front and rear axles to ensure stable straight-line driving. As mileage increases, tire wear occurs, and some impacts may alter the originally fixed angles and positions, necessitating a wheel alignment to ensure driving safety and stability. 2. Wheel alignment is required under the following circumstances: (1) When driving on a straight road, if you need to grip the steering wheel tightly to prevent the car from veering, it indicates a need for wheel alignment. (2) If one side of the front or rear tires shows particularly severe wear, a wheel alignment is needed. (3) If the car feels floaty or unstable during normal driving, similar to when turning or driving on rough roads, it suggests a need for wheel alignment. (4) After installing new tires or following collision repairs, steering, or suspension system maintenance.
3
1
Share

How to Determine the Position of the Car While Driving?

Here are the specific methods to determine the position of the car: 1. Use the wiper nodes of the vehicle to determine the position of the wheels. This method is not suitable for all vehicle models, as the size of the wipers varies among different models, and the driver's sitting posture also differs, which may lead to slight errors when judging the position of the wheels. 2. Use the steering wheel to determine the position of the left wheels. Since the steering wheel is on the left side in China, it is easier to determine the position of the left front wheel. The extended straight line from the leftmost part of the steering wheel indicates the position of the left wheels. If it coincides with the road markings, it means the vehicle is driving on the line. 3. Use the emergency hazard light button switch in the vehicle. Nowadays, the emergency hazard light switches in many vehicles are designed in the center of the dashboard. While driving, the extended line from the position of the hazard light switch can be used to determine the position of the right wheels.
8
1
Share

Where is the trunk switch of Volkswagen Bora?

The trunk switch of the Volkswagen Bora is located on the main driver's door, and pressing it can open the trunk lid; there is also a button on the remote key that can open the trunk lid. The Bora is a compact sedan under the Volkswagen brand. In terms of body dimensions, the car has a length of 4663 mm, a width of 1815 mm, a height of 1462 mm, and a wheelbase of 2688 mm. In terms of power, the Bora is equipped with three engines: a 1.5-liter naturally aspirated engine, a 1.2-liter turbocharged engine, and a 1.4-liter turbocharged engine. The 1.5-liter naturally aspirated engine has a maximum power of 83 kW and a maximum torque of 145 Nm; the 1.2-liter turbocharged engine has a maximum power of 85 kW and a maximum torque of 200 Nm; the 1.4-liter turbocharged engine has a maximum power of 110 kW and a maximum torque of 250 Nm.
19
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.