What is the top model of the Infiniti ESQ?

What is the problem when a Mercedes-Benz makes abnormal noise when shifting gears?

Mercedes-Benz cars make abnormal noise when shifting gears for the following reasons: 1. Damaged transmission housing: The transmission housing and bearing seat holes are worn and deformed over time. This noise is loudest when shifting into low gear and gradually decreases as higher gears are engaged, with direct drive producing the least noise. 2. Broken gear teeth: This causes impact during meshing. When shifting into this gear, strong impact and vibration occur, leading to resonance in the transmission housing. 3. Improper transmission assembly: Improper replacement of gears, needle bearings, or bushings in a certain gear of the transmission, or abnormal assembly clearance, results in poor gear meshing and abnormal noise during transmission.

6

4

Share

Is It Necessary to Install a Shark Fin on a Car?

It is not necessary to install a shark fin on a car. If the shark fin is original, it may have advantages such as enhancing the car's communication signals and shielding static electricity. However, if it is installed later, the shark fin only serves a decorative purpose and has no other functions. Here is some information about shark fins: Shark fin antennas overcome the shortcomings of traditional telescopic rod antennas, whip antennas, and car glass antennas. They integrate all the functions of ordinary antennas using the latest electronic technology, including discharging static electricity, amplifying communication signals, reducing turbulence, and improving the accuracy of the GPS system. Additionally, they serve as FM radio antennas, GSM communication antennas, and GPS antennas.

6

5

Share

What Causes Abnormal Noises When Driving on Rough Roads?

Abnormal noises when driving on rough roads can be attributed to the following reasons: 1. Friction between car components: It may be caused by the friction sound from the fixed rubber sleeve of the suspension lateral stabilizer bar, or related components of the interior trim panel rubbing against each other. 2. Lack of lubrication in the steering column dust cover: Insufficient lubrication in the steering column dust cover can lead to dry friction sounds. Applying some grease inside the dust cover can eliminate the noise. 3. Abnormal noise from the steering column universal joint: The front end of the steering column is equipped with a universal joint. Lack of lubrication in the universal joint can cause abnormal noises, which can be resolved by lubricating the universal joint.

20

2

Share

Should the Negative Terminal of the Car Battery Be Disconnected When the Car Is Not Used for a Long Time?

When a car is not used for a long time, it is necessary to disconnect the negative terminal of the battery to prevent battery drain. Generally, if the car is not used for more than a month, the negative terminal should be disconnected. If the period is not very long, there is no need to disconnect the negative terminal. Here is some information about car batteries: 1. A car battery is a type of battery, also known as a storage battery, which works by converting chemical energy into electrical energy. 2. The commonly referred-to car battery is a lead-acid battery, which mainly uses lead and its oxides as electrodes and sulfuric acid solution as the electrolyte.

11

0

Share

What is the maximum speed of the Corolla 12t on the highway?

The Corolla 12t can reach a maximum speed of 120 km/h on the highway, but traffic regulations must be observed. Factors affecting maximum speed: The maximum speed is largely related to the road surface and is also subject to the road's speed limit. Discussing maximum speed alone is not meaningful. Speed regulations: Motor vehicles must not exceed the speed limit signs on the road. On roads without a centerline, the speed limit is 30 km/h in urban areas and 40 km/h on highways. On roads with only one lane in the same direction, the speed limit is 50 km/h in urban areas and 70 km/h on highways. When turning, the maximum speed of a motor vehicle must not exceed 30 km/h.

12

4

Share

What is the issue when the fault light of Chery E3 is on?

Chery E3 engine fault light may be on due to sensor failure, intake pressure sensor failure, or unstable circuit in the engine fuel injection system. Sensor failure: The system reports a fault code, but it works normally, which may be caused by an operation beyond the control range of the computer. Solution: You can first clear the fault code and then check if it reappears. Unstable circuit in the engine fuel injection system: Loose or broken connections in the engine fuel injection system can also cause the fault light to come on. Solution: It is recommended to go to a 4S repair shop for inspection and repair.

14

5

Share

What is the top model of the Infiniti ESQ?

What is the problem when a Mercedes-Benz makes abnormal noise when shifting gears?

Is It Necessary to Install a Shark Fin on a Car?

What Causes Abnormal Noises When Driving on Rough Roads?

Should the Negative Terminal of the Car Battery Be Disconnected When the Car Is Not Used for a Long Time?

What is the maximum speed of the Corolla 12t on the highway?

What is the issue when the fault light of Chery E3 is on?

How Long is the Shelf Life of Motorcycle Engine Oil?

What does ECON on car air conditioning mean?

What are the symptoms of a faulty idle control valve?

Is Vehicle Inspection and Pickup Not on the Same Day?