What is the tire size of the Zotye T600?

1 Answers
ParkerMarie
07/29/25 10:29pm
Its length, width, and height are 4631mm, 1893mm, and 1694mm respectively, with a wheelbase of 2807mm. Below is the relevant introduction about the tires of the Zotye T600: 1. The tire model of the Zotye T600 is 235/60R18. Tire models are commonly represented by a set of numbers, where the first number indicates the tire section width, and the latter indicates the rim diameter in inches. Some tires also contain other letters or symbols with special meanings, such as X for high-pressure tires, C for reinforced tires, and B for bias tires. The Zotye T600 is a mid-size SUV under the Zotye brand. In terms of power, the vehicle is equipped with a 1.5L turbocharged engine, with a maximum power of 119kw and a peak torque of 215nm, paired with a 5-speed manual transmission. 2. The tires used on the T600 are from Qingdao Luhang. For most consumers, Qingdao Luhang tires are not a well-known brand. The CLV2 series used in the sports version is defined by Luhang as a full-condition SUV-specific tire, paired with 18-inch double five-spoke wheels for a sporty and visually appealing effect.
Was this review help?
3
0
Share
More Forum Discussions

What is a Tire Code?

Tire code is an alphanumeric sequence that marks the fundamental information of a tire. Taking 205/55R1691V205 as an example: from left to right, it represents the tire width, sidewall thickness, corresponding rim diameter, and the maximum speed limit the tire can withstand. Internationally standardized tire codes use millimeters to denote section width and aspect ratio percentage. For instance, 235 indicates the tire width is 235mm, 55 means the tire's aspect ratio is 55% (section height being 55% of the width), 17 represents the corresponding rim diameter, 99 stands for the load index, and V indicates the speed rating.
9
2
Share

What Causes Difficulty in Shifting Gears When the Car is Warm?

Reasons for difficulty in shifting gears when the car is warm: Deteriorated or expired transmission fluid, damaged synchronizers in the transmission, improper clutch adjustment, or issues with the clutch three-piece set can all lead to difficulty in shifting gears after the car has warmed up. Below is relevant information: Reason for warming up the car: After the car has been parked for an extended period, the engine oil flows back into the oil pan at the bottom of the engine. Therefore, when starting the engine after a long period of inactivity (such as overnight), the upper part of the engine is without oil and lacks lubrication. It takes approximately 30 seconds after starting for the oil pump to circulate the oil to the parts of the engine that need lubrication the most, such as the pistons, connecting rods, and crankshaft. However, even if you start driving immediately after starting the engine, as long as you avoid aggressively pressing the accelerator and maintain low-speed operation, the effect is the same as idling.
7
3
Share

What Causes Lack of Power When the Car is Warm?

The reason for the lack of power when the car is warm is an electronic throttle failure, and it is necessary to promptly visit the car's 4S store or a repair shop to inspect and repair the electronic throttle. Dirty throttle position sensors or voltage imbalances can cause electronic throttle failure, resulting in the situation where the throttle is fully pressed but the speed does not increase. If the fault in the electronic throttle is ruled out, the issue may shift to the engine's intake, fuel system, or ignition system. Any component failure or abnormality in one of these systems could lead to the situation where the car's throttle is fully pressed but the engine speed does not increase. The throttle position sensor signal is part of the intake system. For the engine to work properly, it requires sufficient air. If there is a leak or blockage in the intake system, the car may experience reduced power, inability to increase engine speed, and body shaking when accelerating. The engine's fuel system is also crucial. Using poor-quality gasoline can lead to fuel pump burnout, catalytic converter failure, piston failure, etc., directly affecting engine power and potentially causing engine stalling, inability to accelerate, and other phenomena.
14
4
Share

Is a Wheel Alignment Necessary After Tire Repair?

Is a wheel alignment necessary after tire repair? Yes, if the abnormal tire wear is severe enough to affect the chassis data, a wheel alignment is required to correct the data. However, if the tire replacement is due to normal wear (tread completely worn out) or damage, a wheel alignment is not necessary, as this situation only involves the tire and wheel rim without affecting the chassis data. Wheel alignment is based on the four-wheel parameters of the vehicle, adjusted to ensure optimal driving performance and reliability. For passenger cars, the installation of the steering wheels, steering knuckles, and front axle has a specific relative positioning, known as steering wheel alignment or front wheel alignment.
16
1
Share

What brand is yonking tire?

yonking tire is known as Yongjin Tire in Chinese, which is a product of Shandong Yongjin Rubber Co., Ltd. The company is a high-tech enterprise specializing in the research, development, production, sales, and international trade of semi-steel radial tires. The symbols in the tire model represent different meanings. Taking 195/55/R1685V as an example: 195 represents the tire width, which is 195mm; 55 represents the aspect ratio, meaning the section height is 55% of the width; R indicates that the tire is a radial tire, meaning the inner layer is manufactured using the radial tire method; 15 represents the rim diameter, which is 15 inches; 85 is the load index, with 85 indicating a maximum load capacity of 515 kilograms, and the total load capacity for four tires is 2060 kilograms; V represents the speed rating, which is 240 kilometers per hour.
20
4
Share

What are the symptoms of a car misfiring?

Here is a detailed introduction to the symptoms of a car misfiring: 1. Shaking: The most obvious symptom of a misfiring engine is shaking. During operation, because one or more cylinders are not working, the engine's balance is disrupted, causing a noticeable drop in engine speed. The power output during operation becomes uneven and intermittent, leading to significant fluctuations in speed. In addition to feeling the misfire in the engine, it can also be observed on the tachometer, where the needle will fluctuate up and down. 2. Increased fuel consumption: After a misfire, fuel consumption will rise significantly. Unburned fuel in the engine is wasted, and even if the engine performs the same amount of work, its power output will noticeably decrease. When this fault occurs, it can be detected through the car's dashboard, as the engine warning light will illuminate. In such cases, it is recommended that the owner take the car to a repair shop or a 4S store for inspection and repair.
6
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.