What is the tire size of the Audi Q5?

1 Answers
McAlexander
07/29/25 12:57am
The tire size of the Audi Q5 is 235/55R19. Tires are one of the components of a car, directly in contact with the road surface, working together with the car's suspension to cushion the impact during driving. The Audi Q5 is a mid-size SUV under FAW-Volkswagen Audi, with body dimensions of 4753 mm in length, 1893 mm in width, and 1659 mm in height, and a wheelbase of 2908 mm. The Audi Q5 is equipped with a 2.0T turbocharged engine, delivering a maximum power of 140 kW and a maximum torque of 320 Nm, paired with a 7-speed dual-clutch transmission. It features a front-engine, four-wheel-drive layout, with both front and rear suspensions using a five-link independent suspension system.
Was this review help?
18
2
Share
More Forum Discussions

Can You Carry a Passenger During the Motorcycle Break-in Period?

Motorcycles can carry passengers during the break-in period. Just avoid excessively high RPMs. Generally, the break-in period for a new motorcycle is 1,200 kilometers, and the engine should fully break in around 1,600-2,000 kilometers. Introduction to the Motorcycle Break-in Period: The break-in period of a motorcycle refers to the adaptation phase after purchasing a brand-new bike. Since the motorcycle is unused at the time of purchase, the engine components and endurance require some time to adjust—this is called the break-in period. During this time, it's best not to exceed speeds of 60 km/h or carry loads over 50 kilograms. Avoid continuous rides longer than two hours at a time, and remember to change the engine oil frequently. Break-in Period Precautions: During the break-in period, strictly adhere to speed limits, load restrictions, and scheduled maintenance to minimize wear on the engine and transmission components. This also helps optimize the new motorcycle's performance and extend its service life.
17
0
Share

How much is the percentage of speeding when driving at 100 in an 80 speed limit zone?

100-80=20, 20/80=0.25, which means the speeding percentage is 25%. Speeding is subject to penalties. Speeding levels and fines for highway section speed measurement: Speeding within 10% will not result in fines or penalty points, but will be handled with a warning from traffic police. A ticket with 0 penalty points and 0 fines, if not handled, will still affect the annual vehicle inspection. Speeding exceeding 6% of the speed limit: Driving at 85 in an 80 speed limit zone means exceeding the speed limit by about 6%. According to speeding penalty regulations, this will not result in fines or penalty points. However, you might still receive a ticket, which is a warning ticket with "0 points, 0 fines". Such a ticket must be handled; otherwise, it will affect the vehicle's annual inspection.
17
0
Share

Which vehicle has the right of way when meeting on an uphill or downhill slope?

On a narrow slope, the vehicle going uphill has the right of way; if the downhill vehicle has already entered the slope while the uphill vehicle hasn't started ascending, the downhill vehicle should proceed first. Advantages of uphill vehicles going first: When both uphill and downhill vehicles are at opposite ends of the slope, allowing the downhill vehicle to proceed first could be extremely dangerous due to its potentially higher speed on the descent. Conversely, if the uphill vehicle goes first, any potential accidents would likely result in less severe consequences compared to downhill vehicles. Example with manual transmission vehicles: When both vehicles meet midway on the slope, for manual transmission cars, making the uphill vehicle yield to the downhill vehicle could easily cause stalling and create dangerous situations like rolling backward on the slope. Moreover, uphill vehicles need to overcome slope resistance by pressing the accelerator harder to generate sufficient engine power and traction. In contrast, downhill vehicles only need to apply brakes temporarily when yielding.
14
3
Share

Can the Diesel Heater Be Installed Outside the Vehicle?

No. The diesel heater is installed near the cab, and it can be placed under the passenger seat by lifting the seat. Introduction to Diesel Heaters: A diesel heater, also known as a diesel parking heater, is a vehicle heating device primarily used for warming the cabs of trucks, operable both while driving and parked. When installing a diesel heater, it is essential to use formal channels and hire qualified technicians for the installation. Retrofitting a diesel heater into a vehicle requires modifications to the original fuel lines and electrical circuits. If the modifications are not standardized and fail to meet safety requirements, issues can easily arise. Installation Notes for Diesel Heaters: Most diesel heaters are installed with the heating outlet placed under the bunk and the exhaust outlet set beneath the cab. If the cab's bottom is not well-sealed, prolonged use while parked may allow exhaust gases to enter the cab, causing oxygen deprivation inside. People may not realize they are experiencing oxygen deprivation while asleep, which could lead to fatal dangers.
17
3
Share

Is It Correct to Fill Up Gas Until the Pump Nozzle Clicks Off?

Filling up until the first click-off is correct, as this is one way to achieve a full tank. Theoretically, you could fill up until the nozzle clicks off three times, but it's best not to go beyond the third click-off. For safety reasons: For safety, you should not fill up until the nozzle clicks off three times. Otherwise, gasoline may overflow through the vent hole, and if it comes into contact with an open flame, it could ignite instantly, causing irreversible damage. Additionally, overflowing gasoline can easily enter the pipelines, damaging the carbon canister and causing the spark plugs to malfunction, which may result in the vehicle failing to start. The purpose of the nozzle clicking off: The nozzle clicking off is actually intentional. When refueling, it's impossible to see how much gas is in the car's fuel tank. For safety reasons, the upper part of the fuel tank is designed with extra space to accommodate the nozzle, and this space is not included in the tank's rated capacity. Additionally, the nozzle is equipped with a click-off mechanism. When refueling, as the fuel level rises and reaches this mechanism, the nozzle automatically shuts off, stopping the flow of gas and causing the 'click-off' effect.
20
1
Share

Can I Add Antifreeze by Myself Directly?

Antifreeze can be added by yourself, but you need to choose the same brand, model, and specification of antifreeze product, and add it appropriately based on the remaining antifreeze content in the engine. Antifreeze Replacement Cycle: For vehicles that run for long periods, such as taxis, high-quality antifreeze should generally be replaced once a year. For vehicles with shorter running times, it can be replaced every two years or every 30,000 kilometers. To prevent excessive foam formation, which reduces the heat exchange efficiency between the antifreeze and engine components, ensure the product is within its validity period when adding it. Long-lasting antifreeze can have a validity period of up to three years. If suspended matter, sediment, or deterioration/discoloration is found in the antifreeze, it should be replaced promptly, and the system should be cleaned. Antifreeze Replacement Method: Before completely replacing the antifreeze, conduct a thorough inspection to check for any signs of leakage or cracks in the pipes, with a focus on the five-way hose. The five-way hose gets its name from having five connection interfaces to various parts. Antifreeze flows through the five-way hose and is distributed to different parts of the car to function. If there is any leakage of antifreeze in this part, the hose should be replaced or the interface re-secured as needed. Drain the old antifreeze, then clean the liquid channels with water. Add clean water to the antifreeze reservoir, then continuously inject water into the reservoir to allow it to flow through the engine cooling system. Start the engine and let it idle for 3 to 5 minutes to circulate the water. The water initially flowing out from the reservoir will be slightly pinkish. Continue injecting clean water until the water flowing out is clear. Note: Remember to remove the heater hose and drain the water from the heater core.
3
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.