What is the tire pressure for Jetta VS5?

2 Answers
Esther
07/25/25 5:24am
The normal tire pressure range for the Jetta VS5 is 2.4-2.5 bar. Due to seasonal factors, the tire pressure can be appropriately increased by 0.2 bar in winter and decreased by 0.1 bar in summer. This data is based on the international GBT2978-2008 standard. The tire pressure monitoring system of the Jetta VS5 can be viewed on the central control screen. The vehicle comes equipped with a tire pressure monitoring system that provides automatic alarm alerts without manual operation. This tire pressure monitoring system uses ABS wheel speed sensors to compare the rotational speed differences between tires to determine if there is abnormal tire pressure, issuing immediate alerts if any abnormalities are detected. The module is integrated into the ABS pump. Generally, tire pressure above 2.8 bar is considered too high, and tire pressure below 2.0 bar is considered too low. Hazards of overinflated tires: Reduced tire friction and adhesion, affecting braking performance; causes steering wheel vibration and deviation, reducing driving comfort; accelerates wear on the central tread of the tire, shortening tire lifespan; increases vehicle vibration, indirectly affecting the lifespan of other components; overextends the tire cords, reducing tire elasticity and increasing the load on the vehicle during driving. Hazards of underinflated tires: Increases friction with the road surface, leading to higher fuel consumption; makes the steering wheel heavy and prone to deviation, compromising driving safety; increases movement of tire components, causing abnormal heat due to excessive rolling; reduces the functionality of cords and rubber, leading to delamination or cord breakage and excessive friction with the rim, damaging the tire bead area and causing abnormal wear; multiplies friction between the tire and the ground, sharply increasing tire temperature, softening the tire, and drastically reducing its strength. High-speed driving may result in a tire blowout. If the tire pressure monitoring indicator light comes on (a yellow symbol with an irregular circle, no seal on top, four small spikes at the bottom, and an exclamation mark inside), there are generally three possible reasons: Abnormal tire pressure. Typically, the system will alert if the pressure is below 1.8 bar or above 3.0 bar. In this case, tire inspection and pressure adjustment are required. Tire pressure monitoring not reset. After inflating the tires, if the tire pressure is not reset promptly, the system will still record the previous data, causing the tire pressure monitoring light to illuminate. Simply reset the tire pressure to resolve this issue. Damaged tire pressure sensor. The tire pressure sensor, which monitors tire pressure, is directly installed inside the tire and connected to the tire inflation valve. If the sensor is damaged during driving, the tire pressure warning light will illuminate. For sensor damage issues, the only solution is to replace the sensor with a new one.
Was this review help?
20
3
Share
RebeccaDella
08/10/25 5:44pm
I've been driving the Jetta VS5 for several years, and tire pressure is something you really need to pay attention to. The standard tire pressure is generally around 2.3 to 2.5 bar, with the exact value written on the label on the driver's side door frame. For my car, both front and rear tires are at 2.4 bar, but the SUV version might go up to 2.5 bar if equipped with all-terrain tires. You can't just guess this value—too low and it can wear out the tire sidewalls and increase fuel consumption; too high and it makes the ride bumpy and unstable, affecting safety. I recommend buying a handheld tire pressure gauge to check it yourself, taking a quick look every month or when refueling. Don't inflate too much in hot summer weather, as temperature changes cause tire pressure to fluctuate. Always adjust before long trips or when carrying heavy loads—for passenger loads, the rear tires can go slightly higher to 2.6 bar for better stability. In short, referring to the owner's manual is the most reliable. Safe driving depends on these small details—it saves money and hassle, so don't overlook it.
Was this review help?
13
0
Share
Expand All
More Forum Discussions

Is the Chevrolet Tracker a Three-Cylinder Engine?

The Chevrolet Tracker is equipped with a three-cylinder engine, featuring a 1.3-liter turbocharged engine. The 1.3-liter turbocharged engine in the Chevrolet Tracker delivers 165 horsepower and a maximum torque of 240 Nm. This engine can output its maximum power at 5,600 rpm and reach its peak torque between 1,500 to 4,000 rpm. It incorporates direct fuel injection technology and utilizes an aluminum cylinder head and block. The Chevrolet Tracker is a compact SUV with dimensions of 4,411 mm in length, 1,803 mm in width, and 1,633 mm in height, with a wheelbase of 2,640 mm. The front suspension of the Chevrolet Tracker uses a MacPherson independent suspension, while the rear suspension employs a torsion beam non-independent suspension.
1
3
Share

How to Adjust the Seat Height of the Touareg?

The method to adjust the seat height of the Touareg is as follows: 1. Open the door and enter the vehicle's driver compartment; 2. Use the left knob to adjust the lumbar support effect of the vehicle seat; 3. Push the middle switch up and down to adjust the seat height; 4. Push the middle switch forward and backward to adjust the seat's front and rear distance; 5. The switch on the right is used to adjust the seat backrest angle. Taking the Touareg 2020 Facelift Two-Wheel Drive Comfort Edition as an example, its dimensions are: length 5039mm, width 1989mm, height 1773mm, wheelbase 2980mm. It is equipped with a 2.0T turbocharged engine and transmission, with a maximum power of 137 kW and a maximum torque of 320 Nm.
17
3
Share

Where is the Borgward car engine from?

Borgward car engines are made in China. Taking the Borgward BX5 2020 Automatic Two-WDrive New Edge model as an example, it is a compact 5-door 5-seat SUV with body dimensions of: length 4490mm, width 1877mm, height 1675mm, wheelbase of 2685mm, and a fuel tank capacity of 60 liters. The Borgward BX5 2020 Automatic Two-WDrive New Edge model is equipped with a 1.4T turbocharged engine and a 6-speed automatic manual transmission, with a maximum power of 110 kilowatts and a maximum torque of 250 Newton meters. Its drive mode is front-wheel drive, with a front suspension using MacPherson independent suspension and a rear suspension using multi-link independent suspension.
2
0
Share

Can I directly apply for an A1 driver's license now?

You cannot directly apply for an A1 driver's license. Here is extended information: 1. Introduction to driver's licenses: There are 15 types of motor vehicle driver's licenses, with the most common being the C license. Similar to the three categories under the C license, the A license also has three categories, among which the A1 license refers to large passenger vehicles and includes the driving permissions for A3, B1, and B2. 2. Conditions for applying for a driver's license: For the first application, you can only apply for a C1 (for motor vehicles with fewer than 9 seats), B2 (large trucks), or A3 (city buses). To obtain an A1 license, you must upgrade step by step, meeting certain conditions, including a certain period of driving experience, no full-point record in two scoring cycles, and being at least 26 years old.
9
2
Share

What are the reasons why the Zotye T600 throttle cannot be increased?

The reasons why the Zotye T600 throttle cannot be increased are: 1. Poor performance of the engine ignition system and electronic fuel injection system; 2. Ignition timing is too early or too late; 3. Weak spark, or the mixture being too rich or too lean. Taking the 2019 Zotye T600 as an example, it belongs to a mid-size SUV with body dimensions of: length 4676mm, width 1893mm, height 1696mm, and a wheelbase of 2807mm. The 2019 Zotye T600 features a MacPherson strut front suspension and a multi-link independent rear suspension. It is equipped with a 1.5L turbocharged engine, delivering a maximum horsepower of 143PS, a maximum power of 105kW, and a maximum torque of 207Nm, paired with a 5-speed manual transmission.
20
2
Share

What are the installation steps for the Wuling Hongguang Plus navigation system?

The installation steps for the Wuling Hongguang Plus navigation system are as follows: 1. Pry open the edges of the storage box trim panel, remove the screws beneath the storage box, and take off the decorative strip; 2. Unscrew the screws on the central control panel, support the head unit with both hands and remove it; 3. Pass the dedicated power cable and DVD cable of the car navigation system through the space between the two air vents, and properly position the GPS antenna; 4. Connect the car navigation system, secure the navigation unit above the CD head unit, and restore all removed trim components to their original positions. Taking the 2021 Wuling Hongguang Plus as an example, its body dimensions are: length 4720mm, width 1840mm, height 1810mm, wheelbase 2800mm, and fuel tank capacity 53L.
5
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.