What is the tire model of Hyundai Elantra?

2 Answers
JackFitz
07/29/25 8:29pm
Elantra's tire model is 195/65r15. Below is relevant information about tire pressure: Tire Pressure: Both overinflation and underinflation will affect the service life of tires. Winter tire pressure can be slightly higher than summer tire pressure. Recommended summer tire pressure is between 2.2-2.5bar, while winter tire pressure should not exceed 2.8bar. Adjust the pressure appropriately according to load conditions. Underinflation: Insufficient tire inflation pressure can also cause excessive tire wear, poor vehicle control, reduced fuel economy, and may lead to wheel deformation. Therefore, tire inflation pressure should be maintained within the specified value. Overinflation: Excessive tire inflation pressure will result in uncomfortable ride, excessive wear in the center of tire treads, and increase the possibility of tire damage on hazardous road surfaces.
Was this review help?
17
2
Share
HaleyDella
08/14/25 5:21pm
I've driven quite a few Hyundai Verna models, and the tire specifications for this car are quite particular. The standard factory-fitted size is usually 195/65 R15, but it depends on which year's model you have—for example, older versions might have a width of 185. I recommend checking the owner's manual or the side door plate to confirm. The specific number combination, like 195, refers to the tire width in millimeters; 65 is the aspect ratio percentage; R stands for radial construction; and 15 is the rim diameter in inches. Don't underestimate these numbers—choosing the wrong size can affect braking performance and safety. Also, make sure to maintain tire pressure around 2.4 bar for fuel efficiency and to prevent blowouts. When replacing tires, it's best to stick with factory-matched brands like Hankook or Kumho, which offer good value for money. Regular checks and maintenance can extend tire lifespan.
Was this review help?
14
4
Share
Expand All
More Forum Discussions

What is the replacement method for the rear wiper of the Ford Kuga?

Lift the wiper arm, insert the interface into the slot, press the dovetail inward, press down the wiper blade, wait for the dovetail to pop up, and the rear wiper installation is complete. The following is a related introduction to the wiper: 1. Function: The wiper is an important accessory installed on the windshield, used to remove rain, snow, and dust that obstruct the view on the windshield, playing a crucial role in driving safety. 2. Usage precautions: It is strictly prohibited to operate the wiper blade when the windshield is dry, as this may scratch the glass, damage the wiper blade, or burn out the wiper motor. If the wiper needs to be activated when the glass is dry, first spray windshield washer fluid.
3
4
Share

How to Lock the Handlebar of the Sai 600?

Sai 600 handlebar locking method is as follows: First turn the handlebar all the way to the left, then insert the ignition key and turn it to the left. Below is an introduction to the Sai 600: 1. Exterior: The engine and frame feature fully adjustable KYB suspension front and rear, Brembo brakes with Bosch dual-channel ABS, imported Japanese SUNSTAR brand front dual and rear single brake discs, separate handlebars with direct push master cylinder, plus a split seat, giving it a strong sports bike feel. 2. Configuration: Equipped with a 600CC four-cylinder water-cooled 16-valve engine, with a maximum power of 60kw/11000rpm and a maximum torque of 55Nm/85rpm.
10
5
Share

Is It Normal for a Motorcycle Engine to Get Hot?

It is normal for a motorcycle engine to get hot. Here is some relevant information about motorcycles: 1. Introduction: A motorcycle is a two- or three-wheeled vehicle driven by a gasoline engine and steered by handlebars to control the front wheel. It is lightweight, flexible, and fast, widely used for patrol, passenger and cargo transportation, and also serves as sports equipment. 2. Classification: Broadly speaking, motorcycles are divided into street bikes, road racing motorcycles, off-road motorcycles, cruisers, and touring bikes, among others. 3. Basic Components: A motorcycle consists of five main parts: the engine, transmission system, running gear, steering, braking system, and electrical instrumentation equipment.
4
3
Share

What are the reasons for the Volkswagen New Santana stalling immediately after starting?

It is due to fuel supply interruption. Possible causes include: aging fuel pump with unreliable pumping; fuel pump power failure; check valve sticking resulting in insufficient fuel injection; or incorrect ECU feedback. Electrical circuit faults: This may occur due to low-voltage power interruption while driving, causing stalling. In this case, primarily inspect the ignition and starter switches, as well as the fuse box. Electrical component failures: This issue typically involves the ignition coil, capacitor, or electronic ignition module. The vehicle may start initially but stall after a while, then restart only to stall again. Fuel system faults: Possible causes include: damaged fuel pump, fuel line rupture, carburetor inlet blockage, or empty fuel tank. In such cases, the vehicle may restart but with great difficulty.
5
4
Share

What type of oil does the Buick Excelle use?

The original oil for the Buick Excelle 1.4T is Mobil 1 5W-30 full synthetic oil, while the Buick Excelle 1.5L uses the factory-recommended 5W-30 semi-synthetic oil, with a filling capacity of approximately 3.7L. If you want to change the oil during later maintenance, you can choose from brands such as Shell or Castrol. The viscosity of the oil changes with temperature, so special attention should be paid to its performance under both low and high temperatures. For example, in 5W-30, the first number indicates low-temperature fluidity, with 5W representing the ability to withstand temperatures as low as -30°C. The smaller this number, the better the low-temperature fluidity, ensuring smoother cold starts for the car. The second number represents the kinematic viscosity of the oil at 100°C. A higher value means the oil can maintain its viscosity index better at high temperatures, which can also be understood as better lubrication performance under high-temperature conditions. The method for changing the oil in a Buick Excelle is as follows: Wait for the engine temperature to cool down, allowing the oil to flow back into the oil pan; Use a wrench to loosen the oil drain plug and place an oil pan underneath to catch the old oil until it stops flowing. Start the engine for about 30 seconds to allow the oil in the main oil passages to drain out; Use a specialized wrench to remove the oil filter; Apply oil to the seal of the new oil filter and hand-tighten it clockwise; Pour the new oil into the engine through the valve cover filler port, typically filling about three-quarters of a standard oil container; Start the engine and let it run for 5 minutes, checking for any leaks around the oil drain plug and oil filter. If leaks are found, perform necessary repairs; After stopping the engine, pull out the oil dipstick to check that the oil level is within the standard range.
5
0
Share

Does engine oil have an expiration date?

Engine oil has different expiration periods under various conditions: unopened engine oil lasts for 5 years; leftover oil after maintenance has a shelf life of 1 year; oil poured into the engine lasts for 6 months. Storage conditions: Under proper storage conditions, engine oil can last for 4 to 5 years. Once opened, if sealed properly, it generally lasts about a year. The main factor affecting the shelf life of engine oil is the storage conditions. The greater the temperature fluctuations and humidity in the storage environment, the faster the oil deteriorates. For every 10-degree Celsius increase in temperature, the oil's lifespan is halved. Never leave the oil cap open and expose the oil to sunlight. The correct practice is to store the oil in a sealed, cool place. Poor sealing can lead to oxidation when the oil comes into contact with air, and high temperatures accelerate this oxidation. Additionally, significant temperature fluctuations can easily cause condensation, and water can cause the lubricant to deteriorate. If the oil has been stored for more than 3 months, it is recommended to use new oil the next time. If the oil in the car has been used for a relatively long time, such as having covered half the usual maintenance interval mileage, the storage time should be reduced. It is advisable to use new oil after storing for more than 3 months.
19
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.