What is the tire model for the Ford EcoSport?

1 Answers
VonEsther
07/30/25 7:00am
The tire specification for the Ford EcoSport is 205/50R17. The first number, 205, represents the tire width of 205MM. The number 50 indicates the aspect ratio of the tire's cross-section is 50%, meaning the height of the cross-section is 50% of the width. The number 17 represents the rim diameter of 17 inches. The letters or symbols in the middle have special meanings: "X" indicates a high-pressure tire; "R" and "Z" indicate radial tires; "-" indicates a low-pressure tire. The Ford EcoSport uses Maxxis brand tires. If you want to replace the tires yourself, you can follow the steps below: Retrieve the spare tire and jack, place the jack under the vehicle frame near the tire to be replaced, ensuring the jack contacts the metal part of the frame; Raise the jack until it supports the car. The jack should be positioned under the vehicle, and ensure it is at a right angle to the ground; Remove the hubcap and loosen the nuts counterclockwise. Do not fully remove the nuts; just loosen them enough to eliminate resistance. When loosening the nuts for the first time, keeping the tire on the ground ensures that the nuts, not the tire, are turning; Turn the nuts counterclockwise until they are loose. Repeat this step for all lug nuts and then fully remove them; Place the new tire on the wheel hub, carefully aligning the tire rim with the wheel bolts. Install the lug nuts and tighten them by hand until all nuts are snug. The tire replacement is now complete. In addition to the model, tires also display the following common data: Tire cord material: Indicated by Chinese Pinyin, such as M for cotton cord, R for rayon cord, N for nylon cord, G for steel cord, and ZG for steel radial cord tires. Speed rating: Indicates the maximum speed at which the tire can carry a specified load under defined conditions. Letters A to Z represent certified speed ratings from 4.8 km/h to 300 km/h. Common speed ratings include: Q: 160 km/h; H: 210 km/h; V: 240 km/h; W: 270 km/h; Y: 300 km/h. Rim specification: Indicates the rim size compatible with the tire for practical use, such as standard rim 5.00F.
Was this review help?
13
5
Share
More Forum Discussions

Where is the cabin air filter located in a Jeep Wrangler?

The cabin air filter in a Jeep Wrangler is located inside the glove compartment on the passenger side. To replace it, you need to open the vehicle's glove box and remove the clips on both sides. The functions of the cabin air filter are: 1. Providing fresh air to the vehicle interior; 2. Ensuring safety and hygiene inside the vehicle; 3. Absorbing harmful substances; 4. Filtering solid impurities from the air. Taking the 2021 Jeep Wrangler as an example, its body dimensions are: 4334mm in length, 1894mm in width, and 1839mm in height, with a wheelbase of 2459mm, a minimum ground clearance of 251mm, a fuel tank capacity of 70 liters, and a curb weight of 1843kg.
9
1
Share

What Causes the Clutch Not to Spring Back?

The reasons for the clutch not springing back are: 1. Air entering the clutch pipeline system, causing excessive clutch travel and poor return; 2. Dirty clutch fluid with impurities, leading to severe internal wear of the clutch master cylinder or blockage of the return oil hole, preventing the clutch from returning; 3. As the vehicle mileage increases, insufficient or broken clutch return spring tension causes the clutch pedal not to return; 4. Excessive wear gap in the clutch linkage push rod results in poor return. The clutch is located in the flywheel housing between the engine and the transmission. The clutch assembly is fixed to the rear plane of the flywheel with screws, and the output shaft of the clutch is the input shaft of the transmission.
6
4
Share

How to Check the Battery Level of a Car Battery?

Methods to check the battery level of a car battery are: 1. Observe the battery level indicator, where black indicates the need for charging, green indicates good condition, and white indicates insufficient fluid and the need for replacement; 2. Check the appearance of the battery for obvious deformation or bulging on both sides, which indicates the need for replacement; 3. Perform a voltage test on the battery. Functions of the battery: 1. Supply power to the starting system, ignition system, and electronic fuel injection system when starting the engine; 2. Provide power to the car's electrical equipment when the engine is stopped or at low idle; 3. Participate in power supply when the power demand exceeds the generator's supply capacity; 4. Stabilize voltage and protect the electronic equipment in the car.
17
5
Share

What is the S gear in a car?

Car S gear is the sport mode of the car. In S gear mode, the torque output is high, providing greater acceleration, and the engine maintains high RPMs with delayed shift timing. S gear is mostly used for overtaking, climbing steep slopes, descending long slopes, traffic congestion, and clearing carbon deposits. However, S gear increases fuel injection, leading to higher fuel consumption. Prolonged driving in S gear can cause significant damage to the engine and transmission. The working principle of S gear: S gear is a mode that keeps the engine at high RPMs, with the transmission shifting up later and shifting down earlier, enhancing the car's dynamic performance. The function of S gear: In this mode, the engine performs gear shifts at very high RPMs, delivering excellent power performance during rapid acceleration and overtaking.
5
4
Share

Which car has a snake in its logo?

Logo with a snake is Alfa Romeo, whose models include: giulia, giulia Quadrifoglio, stelvi, stelvio Quadrifoglio, jiulias, etc. Taking the 2020 giulia as an example, its body length, width and height are: 4643mm, 1860mm, 1438mm, the wheelbase is 2820mm, and the fuel tank capacity is 58l. The 2020 giulia has a double-wishbone independent front suspension and a multi-link independent rear suspension. It is equipped with a 2.0t naturally aspirated engine with a maximum horsepower of 280ps, a maximum power of 206kw, and a maximum torque of 400nm, matched with an 8-speed automatic transmission.
20
1
Share

What are the differences between the Mercedes-Benz C-Class and E-Class?

The differences between the Mercedes-Benz C-Class and E-Class are: 1. Different positioning: The C-Class is merely an entry-level luxury model in the Mercedes-Benz lineup; the E-Class is the brand's flagship mid-to-large luxury sedan. 2. Different exterior and interior designs: The C-Class features a more youthful appearance and cabin styling; the E-Class emphasizes luxurious ambiance to highlight the elegance of a mid-to-large luxury sedan. 3. Different powertrains: As an entry-level model, the C-Class offers C180, C260, and C300 variants with 1.6T, 1.5T+48V mild hybrid, and 2.0T powertrains respectively; the E-Class provides E200, E260, E300, E350, and E320 variants equipped with low-power 2.0T, low-power 2.0T+48V mild hybrid, standard 2.0T, high-power 2.0T+48V mild hybrid, and 3.0T V6 powertrains respectively.
8
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.