···
Log in / Register

What is the tire model for Infiniti QX50?

4 Answers
MilesDella
07/29/25 9:22am

Infiniti QX50's original tire configuration model is 235/55/R19. The first number 235 represents the tire width of 235MM, 55 indicates the tire section's aspect ratio is 55%, meaning the section height is 55% of the width, the letter R stands for radial tire, and 19 denotes the rim diameter is 19 inches. The Infiniti QX50 has a fuel consumption of 7.7L per 100 kilometers. In addition to the model, tires also display the following common data: Tire cord material: represented by Chinese pinyin, such as M-cotton cord, R-rayon cord, N-nylon cord, G-steel cord, ZG-steel radial cord tire. Speed rating: indicates the maximum speed at which the tire can carry a specified load under defined conditions. Letters A to Z represent certified speed ratings from 4.8km/h to 300km/h. Common speed ratings include: Q: 160km/h; H: 210km/h; V: 240km/h; W: 270km/h; Y: 300km/h; Rim specification: shows the rim specification compatible with the tire for practical use, such as standard rim 5.00F.

Was this review help?
18
2
Share
McRiver
08/12/25 9:37am

I've been driving an Infiniti QX50 for several years. The original tire size is usually 255/45 R20, which is quite common for SUVs, offering good handling and comfort. Depending on the trim level, the luxury version I drive sometimes uses 255/40 R21 tires, which look sportier. Matching the correct tire size is crucial because the aspect ratio affects acceleration and steering response. I also recommend regularly checking tire wear, especially before long trips. If the tread wears down to below 3mm, it's time to replace them to avoid slipping issues in wet conditions. Last time, I switched to Michelin tires and noticed significantly reduced noise, greatly improving the driving experience. I've gradually come to understand the numbers in the tire size: 255 represents the width, 45 is the aspect ratio, and R20 is the rim diameter. These are basic knowledge when choosing tires—don’t buy the wrong size, as it can lead to increased fuel consumption or poor handling. Tire lifespan is typically around 50,000 kilometers; proper maintenance can save money and ensure safety.

Was this review help?
2
3
Share
Expand All
VanEthan
10/06/25 5:21am

As a seasoned car repair veteran, I've encountered numerous QX50 tire issues. The standard model uses 255/45 R20 tires, while higher trims like the Autograph may come with 255/40 R21. In the tire specifications, 255 represents the section width, 45 is the aspect ratio, and R20 indicates the rim diameter. Using incorrect tire models can lead to rapid wear or unstable handling, so I recommend owners regularly check tire pressure, maintaining it around 2.3 bar to avoid premature replacement. When replacing tires, it's best to choose specifications that match the original factory ones, with recommended brands like Bridgestone Dueler, known for reliable performance and fuel efficiency. Common issues include excessive tire noise or uneven wear, which can be prevented by inspecting tire appearance at least once a month. Tires are crucial for overall driving safety and should never be neglected. Understanding these tire specifications is straightforward, and mastering this knowledge can extend your vehicle's lifespan.

Was this review help?
4
4
Share
Expand All
DiDaisy
11/19/25 6:49am

The tire models of the QX50 are quite interesting, such as the standard 255/45 R20 version, which offers a great driving feel. Different configurations have variations, with higher-end models possibly featuring larger sizes, better suited for sporty handling. The model affects acceleration and cornering response, which I find quite noticeable on highways. Choosing the right size avoids safety risks—don't opt for cheap alternatives as they degrade handling. I've also researched different brands, like Bridgestone tires, which perform well in noise control. Regular tire pressure checks while driving can save some fuel costs. Maintaining tires is simple, but neglecting them can lead to unexpected issues.

Was this review help?
19
0
Share
Expand All
More Forum Discussions

How to Protect Your Car During Outdoor Hailstorms?

Methods to protect your car during outdoor hailstorms include: 1. Park in a carport or underground parking lot; 2. Park under an eave; 3. Avoid parking under trees; 4. Purchase a hail protection cover online; 5. Place quilts on the car roof and windows. Solutions for a car damaged by hail: 1. Report the incident to your insurance company; 2. Take the car to an auto repair shop or 4S store for repairs. Repair methods for hail damage: 1. Pull-out method: Insert a hot melt glue stick from the back of the glue gun, plug the glue gun into a power socket, set the glue gun to a higher temperature, preheat for 3 to 5 minutes until the hot melt glue is completely melted, pull the trigger of the glue gun, apply the melted glue to the traction shim, and pull it out; 2. Pry-up method: Remove the interior panel of the door, unfasten the door panel clips, disconnect the wiring harness on the door panel, and insert a tool inside the door to pry it.
10
3
Share

What does it mean when the ABS light on the vehicle dashboard is on?

The ABS light on the vehicle dashboard being illuminated indicates a fault in the ABS system, alerting the driver to exercise caution while driving and necessitating prompt inspection and repair. Possible reasons for the ABS light being on include the ABS speed sensor's sensing part being covered, or poor signal quality caused by loose connections between system wiring or poor contact in the ABS relay, leading to system malfunction. If the ABS speed sensor's sensing part is covered by dirt, mud, or other contaminants, it can interfere with the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from determining the vehicle's speed or calculating the wheel slip rate, thereby hindering its ability to issue appropriate commands to adjust braking. The solution is to clean the dirt from the speed sensor and adjust the gap between the speed sensor and the signal ring to restore normal function. Poor signal quality caused by loose connections between system wiring or poor contact in the ABS relay can also lead to system malfunction. The most common issue is a loose speed sensor wire connection, which will also be recorded in the ABS computer's fault memory as a poor speed sensor signal. The solution is to inspect the wiring connections and re-secure any loose connections.
4
2
Share

What is the air conditioning instruction for the Audi Q3?

Audi Q3's air conditioning instruction is: The central control air conditioning area has a total adjustment panel with two knobs, 14 buttons, and a small display screen. The OFF button in the upper left corner is the fan switch, the AC button adjusts the cooling operation mode switch, which can control the activation and deactivation of the cooling compressor, and is also the switch for blowing cold air inside the car. The button in the lower left corner is the switch for the interior air circulation operation mode, which helps improve the air quality inside the car. The Audi Q3 is an SUV based on the same PQ35 platform as the Volkswagen Tiguan. In terms of body dimensions, it measures 4385mm in length, 1831mm in width, and 1608mm in height, with a wheelbase of 2603mm. In terms of appearance, the Audi Q3 features an inverted trapezoidal hexagonal grille, giving it a stronger sense of power; the rear design follows the style of the Q7 and Q5, with no major breakthrough in the overall shape. In terms of design details, the Q3 adheres to Audi's current family design, with an overall shape that is not significantly different from other models in the family.
6
3
Share

What is the Auto Start-Stop Indicator in Cars?

The auto start-stop indicator button features a circle with an 'A' inside and the letters 'OFF' below it. Here are some details: Activating Auto Start-Stop: Enabled by default, the auto start-stop symbol includes a cross. To deactivate the engine's auto start-stop function, press the auto start-stop button. The feature will be reactivated by default the next time the car is started. Advanced Technology: Engine start-stop is a relatively advanced technology, comprising a system that automatically controls engine shutdown and ignition. When the engine briefly enters a dormant state, it achieves energy savings and emission reduction. The engine start-stop function is particularly suitable for urban traffic conditions. Automatic Operation: The auto start-stop function allows the car to shut off automatically when necessary and restart the engine when it needs to move forward again. This functionality is achieved by integrating an idle start-stop motor into the car's engine. When the car meets idle conditions, the engine automatically shuts off. When the car needs to move, the motor system quickly restarts the engine, reducing fuel consumption and exhaust emissions while improving fuel economy. This can save approximately 10% of a car's fuel.
7
3
Share

What kind of oil does the Buick LaCrosse generally use?

The suitable oil models for the Buick LaCrosse include 5W-30, 5W-40, and 0W-30. However, General Motors officially recommends 5W30 oil. The number after the W represents the oil's stability at high temperatures—the higher the number, the better the oil's high-temperature stability. The smaller the number before the W, the lower the oil's viscosity at low temperatures. Hazards of using incorrect oil viscosity: Oil with viscosity that is too high or too low is detrimental to the normal operation of the vehicle. It may either lead to component wear or result in excessive friction and higher fuel consumption. Viscosity standards: In general, 5W is sufficient for most regions in winter, while some northern areas are better off using 0W, which offers better low-temperature fluidity to adapt to local environmental temperatures. For high-temperature viscosity, lubricants with viscosity values of 30 or 40 are typically used. However, if the vehicle frequently drives in congested areas, is older, or is a heavy-duty vehicle used for long-distance transport, it may be appropriate to increase the oil viscosity, such as using 0W50 oil.
11
4
Share

Can a Deformed Wheel Hub Be Repaired?

Wheel hub deformation can be repaired, but replacement is recommended. Below is a partial introduction Wheel Hub Correction: The stress point of the wheel hub is the spoke. If the spoke is not bent or deformed, it does not affect usage. Rim deformation can be corrected. Wheel hub deformation repair involves using a correction machine to adjust the up-and-down and left-and-right wobble values within the standard range. Correction Method: First, pad the dented area with sponge or cloth, then use a hammer to flatten the dented part, followed by applying body filler (putty). Find the roundness on the wheel hub, smooth out the uneven areas, then roughen the inside with sandpaper in preparation for painting. Let the putty dry completely, then spray the entire wheel hub. After the paint dries, a "new" wheel hub is born. Influencing Factors: Wheel hub deformation is often caused by driving too fast over potholes. It is advised that car owners take care of their wheel hubs by slowing down when encountering potholes and avoiding excessive speed in general. If the edge of the wheel hub is deformed, it is recommended to repair it promptly to avoid affecting usage.
20
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.