What is the stock code of Great Wall Motors?

What is the fuel consumption of the Mustang 2.3t?

The fuel consumption of the Mustang 2.3t is 12.3-15L/100km. The currently available Mustang 2.3t models include the 2021 2.3L EcoBoost, Shadow Performance Edition, Lightening Replica Limited Edition, and Black Shadow Special Edition. The official NEDC combined fuel consumption is slightly lower than the actual fuel consumption, ranging from 8.6-12.2L/100km. Among vehicles in the same class, the Audi R8 has an NEDC combined fuel consumption of 13.2L/100km, the BMW Z4 ranges from 6.4-10.1L/100km, the Aventador ranges from 17.9-18.4L/100km, the Porsche 718 ranges from 7.2-8.3L/100km, and the Continental ranges from 10.6-16.6L/100km. The fuel consumption of a car is directly related to five major factors: driving habits, the car itself, road conditions, natural wind, and environmental temperature. The details are as follows: Driving habits: Aggressive driving, such as sudden acceleration, frequent overtaking, or not easing off the throttle before a red light, increases fuel consumption. The car itself: Cars with larger displacements generally consume more fuel than those with smaller displacements because larger displacements usually mean higher power, requiring more gasoline for combustion. Heavier cars also have higher fuel consumption because greater weight demands more driving torque. Road conditions: Driving on dirt roads, muddy roads, soft surfaces, or mountainous roads increases resistance and fuel consumption. Natural wind: Driving against the wind or on windy days increases the car's resistance and fuel consumption. Low environmental temperatures: When the engine block is cold, the injected gasoline is harder to atomize, requiring more gasoline for combustion, which increases fuel consumption. Additionally, in low temperatures, the engine's computer will control the engine to run at higher RPMs to warm up, further increasing fuel consumption.

12

3

Share

Why does the car's turn signal flash quickly?

The reasons for the car's turn signal flashing quickly are as follows: 1. A burnt-out right turn signal: Generally, turn signals such as the right front turn signal, right front fender light, cornering light, or right rear turn signal may cause the flashing frequency to become too fast if any of these bulbs are burnt out; 2. Poor contact in the right turn signal: For example, loose bulbs or poorly connected plugs; 3. Inconsistent power or model of the right turn bulb: Some car owners may use bulbs of different specifications or power when replacing turn signal bulbs, leading to this issue. Car turn signals are flashing indicators that are activated when the vehicle is turning, warning pedestrians or vehicles in front or behind about the intended direction of travel.

8

5

Share

Is tire repair at a 4S store free?

4S stores charge for tire repairs and the cost is relatively high. You can opt for other auto repair shops for tire repairs at a more reasonable price. Below are three tire repair methods: 1. Plug method: During high summer temperatures, the plug can melt and separate, potentially popping out under high-speed bumps. Additionally, the plug is directly exposed to the external environment and may degrade or deform over time, leading to air leakage. 2. Patch repair method: This method is currently widely used and has a high safety factor. However, the puncture wound on the tire surface remains, and with exposure to rain and mud infiltration, car owners still need to regularly monitor the tire to prevent patch leakage. 3. Mushroom plug repair method: This method offers high safety, reliability, and the longest tire lifespan. It is the most advanced tire repair technique, as it seals the tire wound, preventing erosion from rain and mud, thereby reducing tire wear and prolonging its lifespan.

18

1

Share

What Gear to Use When Waiting at a Traffic Light?

When waiting at a traffic light: For automatic transmission vehicles, if the expected waiting time is less than 30 seconds, keep the gear in D and use the foot brake; if the expected waiting time is more than 30 seconds, shift to N and use the hand brake; if the expected waiting time exceeds 2 minutes, shift to N, use the hand brake, and turn off the engine. For manual transmission vehicles, during short waits, press the clutch and brake fully in first gear; for longer waits, shift to neutral and use the hand brake. Below are detailed waiting time instructions: 1. Short waiting time: Keep the gear lever in D position and only press the brake pedal with your foot. This way, the vehicle can start again simply by releasing the foot. 2. Slightly longer waiting time: You can also keep the gear lever in D position, but do not follow the car in front too closely. Use both the foot brake and hand brake to avoid close contact with the vehicle ahead. 3. Long waiting time: Shift the gear lever to N position and use the hand brake to reduce driver fatigue and prevent the ATF (automatic transmission fluid) from overheating, which could affect oil quality.

3

5

Share

What are the advantages of waterless antifreeze?

The advantages of waterless antifreeze are that it eliminates the need for repeatedly adding coolant, while also featuring high boiling point, low freezing point, strong thermal conductivity, cleanliness, and environmental friendliness. It completely resolves the persistent issues in cooling systems caused by traditional coolants, such as corrosion, scale formation, cavitation, and overheating, thereby extending the engine's service life. The basic indicators of antifreeze are freezing point and boiling point. On the market, antifreeze comes in several specifications with freezing points of -15℃, -25℃, -30℃, and -40℃. It is generally advisable to choose a product with a freezing point at least 10℃ lower than the lowest temperature in your region. Antifreeze composition: The main components of antifreeze are: 50% pure water, 40% methanol, and 10% other substances. Functions of antifreeze: Antifreeze is a coolant containing special additives, primarily used in liquid-cooled engine cooling systems. It offers excellent performance in preventing freezing in winter, boiling in summer, and resisting scale formation and corrosion throughout the year.

6

4

Share

What is the fuel consumption of the BYD Song Pro?

According to the comprehensive fuel consumption data from the Ministry of Industry and Information Technology, the BYD Song Pro's fuel consumption is around 8.9L/100km. However, based on actual measurements from some BYD Song Pro owners, the fuel consumption is generally around 10L/100km. Here is a partial introduction to factors affecting the BYD Song Pro's fuel consumption: 1. Engine displacement: The larger the engine displacement, the greater the car's power and the more fuel it requires, so fuel consumption is certainly higher. 2. Road conditions: Generally, a car's fuel consumption is relatively low when driving on highways because the engine operates more stably and at lower RPMs. When driving in congested areas or cities, frequent starts and stops lead to higher fuel consumption. 3. Driver's driving habits: Gentle driving results in lower fuel consumption, while aggressive driving leads to higher fuel consumption.

18

3

Share

What is the stock code of Great Wall Motors?

What is the fuel consumption of the Mustang 2.3t?

Why does the car's turn signal flash quickly?

Is tire repair at a 4S store free?

What Gear to Use When Waiting at a Traffic Light?

What are the advantages of waterless antifreeze?

What is the fuel consumption of the BYD Song Pro?

What is the proper tire pressure for a motorcycle?

Can I Add Tap Water to Windshield Washer Fluid?

What should I pay attention to when starting to learn to drive?

Does Car Heater Consume Fuel?