What is the standard tire pressure for the Buick Excelle?

1 Answers
StTaylor
07/29/25 11:10pm
The standard tire pressure for the Buick Excelle is between 2.4-2.5 bar. Due to seasonal factors, the tire pressure can be increased by 0.2 bar in winter and reduced by 0.1 bar in summer. How to check the tire pressure on a Buick Excelle: Press the MENU button to switch to the vehicle information menu. If a speeding alarm is displayed, rotate the knob at the top of the left lever to the tire pressure monitoring information to view the tire pressure of all four tires. If the tire pressure monitoring indicator light comes on (a yellow symbol with an irregular circle, no stamp on top, four small spikes at the bottom, and an exclamation mark inside), there are generally three possible reasons: 1. Abnormal tire pressure. The system typically alerts when the pressure is below 1.8 bar or above 3.0 bar. In this case, the tires need to be checked and the pressure adjusted. 2. The tire pressure monitoring system has not been reset. After inflating the tires, if the tire pressure reset is not performed promptly, the system will still record the previous data, causing the tire pressure monitoring indicator to light up. Simply perform a tire pressure reset to resolve this issue. 3. The tire pressure sensor is damaged. The tire pressure sensor, which monitors tire pressure, is installed inside the tire and connected to the tire inflation valve. If the sensor is damaged due to impact while driving, it can also trigger the tire pressure warning light. In case of sensor damage, the only solution is to replace it with a new component.
Was this review help?
17
1
Share
More Forum Discussions

What is the tire model for the 2017 Vezel?

2017 Vezel tires are 215/55R17 and 215/60R16. The first number 215 indicates the tire width is 215MM, 55 represents the aspect ratio of the tire section is 55%, meaning the section height is 55% of the width, and 17 indicates the rim diameter is 17 inches. The middle letters or symbols have special meanings: "X" denotes high-pressure tires; "R" and "Z" denote radial tires; "-" denotes low-pressure tires. Fuel consumption is 7.1L per 100km. In addition to the model, tires are also marked with the following common data: Tire cord material: Indicated by Chinese pinyin, such as M-cotton cord, R-rayon cord, N-nylon cord, G-steel cord, ZG-steel radial cord tire. Speed rating: Indicates the maximum speed at which the tire can carry a specified load under specified conditions. Letters A to Z represent the certified speed ratings of tires from 4.8km/h to 300km/h. Common speed ratings include: Q: 160km/h; H: 210km/h; V: 240km/h; W: 270km/h; Y: 300km/h; Rim specification: Indicates the rim specification compatible with the tire for practical use, such as "Standard rim 5.00F".
18
5
Share

Where is the tire pressure displayed on Model-X?

Model-X's tire pressure is displayed in the lower right corner of the screen. Here are some detailed introductions about it: 1. Introduction 1: Model-X combines the spaciousness of an MPV, the advantages of an SUV, and the benefits of an electric vehicle. 2. Introduction 2: In terms of interior, similar to Model-S, it adopts a white-based color scheme, which looks very simple. 3. Introduction 3: It is equipped with a pure electric system, with two motors installed on the front and rear axles respectively, capable of accelerating from 0-60 mph (0-96.56 km/h) in 4.4 seconds, and is 10% heavier than Model-S.
5
2
Share

What is the officially announced fuel consumption of the Xingyue L?

The officially announced comprehensive fuel consumption is 7.8L per 100 kilometers. Here are some related introductions about fuel consumption: 1. Habits and road conditions: Fuel consumption is greatly related to driving habits and road conditions. Avoid heavy acceleration and start gradually for the most fuel efficiency. To save fuel, avoid pressing the accelerator heavily when starting, as heavy acceleration consumes 2 to 3 times more fuel than starting at a normal speed. 2. Braking: Maintaining distance and avoiding frequent braking can save more fuel. If you don't maintain distance, you may need to brake frequently on the road. When braking, the gear of an automatic transmission car will drop, and the car will have to accelerate again from a lower gear. Starting from a standstill or a lower gear requires the engine to consume more fuel.
7
1
Share

What to Do When the Coolant Light Comes On?

When the coolant warning light comes on, pull over immediately if it is safe to do so. After the engine has cooled down, open the front hood to inspect. Below are the specific reasons for the coolant warning: 1. The coolant warning is usually caused by a lack of coolant. For example, if the vehicle has been parked overnight and the coolant warning appears when starting the engine the next morning, check the vehicle's chassis for any traces of antifreeze. If there are traces, it indicates a leak in the coolant lines, which requires repair. If there is no leak, simply replenishing the antifreeze should resolve the issue. 2. If the coolant warning suddenly comes on during high-speed driving, it is often accompanied by a water temperature warning. This situation likely indicates a problem with the engine's cooling system, such as: damaged water pump impeller preventing proper circulation for cooling, a malfunctioning cooling fan, or clogged radiator condenser surfaces impairing heat dissipation, all of which can cause the coolant light to illuminate.
10
4
Share

How to Judge the Left and Right Distance of the Car Front While Driving?

Here are specific methods to judge the distance while driving: 1. Use fixed reference points on the car to determine the left-side distance. When the midpoint of the vehicle's left rearview mirror aligns with the left sideline, the distance between the vehicle and the sideline is 1.5 meters. When the first wiper node is on the left sideline, the left wheel of the vehicle is pressing on the sideline. 2. When the white line is at the midpoint of the engine hood, the right wheel of the vehicle is already pressing the line. When the white line is at the halfway point on the right side of the engine hood, the vehicle is 30 centimeters away from the right sideline. When the line is at the one-third point on the right side of the engine hood, the vehicle is 60 centimeters away from the right sideline. 3. When the distance between the vehicle and an obstacle vehicle is 20 centimeters, the lowest visible point of the obstacle vehicle is at 80 centimeters. For sedans, 80 centimeters is roughly below the door handle, while for SUVs, it is around the lower edge of the headlights. Therefore, when approaching an obstacle vehicle, ensure you can see below the door handle or the lower edge of the headlights.
5
4
Share

What is Ambient Lighting in Cars?

Here is a detailed introduction to ambient lighting in cars: 1. The brightness of ambient lighting is not too intense, serving only a decorative purpose. 2. Ambient lighting typically uses LED light sources, which are integrated into areas such as the car's dashboard and doors, and comes in both single-color and multi-color options. 3. Beyond creating ambiance, ambient lighting can also help prevent driver fatigue, thereby enhancing driving safety to some extent. 4. When modifying a car's ambient lighting, it's crucial to engage reputable modification shops due to the need for altering the vehicle's original electronic circuits, to avoid potential safety hazards arising from quality issues later on.
15
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.