What is the standard tire pressure for Mercedes-Benz E run-flat tires?

1 Answers
SanMaggie
07/30/25 5:05am
Mercedes-Benz E-Class has different normal tire pressures for different tires. For R16 and R17 tires, the normal tire pressure when half-loaded is 260 kPa for both front and rear tires. When fully loaded, the normal tire pressure for the front tires is 260 kPa, and for the rear tires, it is 330 kPa. Recommended tire pressure: The recommended tire pressure for Mercedes-Benz E-Class run-flat tires is 30 kPa higher than the normal tire pressure. Introduction to run-flat tire pressure: Run-flat tire pressure refers to the pressure in tires equipped with run-flat technology, which allows the vehicle to continue driving safely even when the tire is punctured, enabling the driver to reach a repair shop. Mercedes-Benz vehicles generally use run-flat tires, but drivers should not rely solely on them and should repair the tires promptly. Additionally, for safety reasons, it is best not to exceed the recommended run-flat tire pressure value but also not to let it drop below 210 kPa.
Was this review help?
10
4
Share
More Forum Discussions

Where is the AUX interface in the 2012 Crosstour?

The AUX interface in the 2012 Crosstour is located inside the armrest box. AUX is an audio input interface. The basic working principle of the AUX interface is that after connecting to it, the audio from electronic devices can be transmitted through the headphone jack and the AUX interface to the car audio system, allowing the audio to be played on the car's audio broadcasting facilities. The USB interface can be used to insert a USB drive for audio playback. When using it, connect one end to the AUX interface and the other end to a mobile phone, MP3, MP4, or other video players. This allows you to listen to songs or niche music anytime, anywhere, without being limited to car music CDs. However, if the playback device runs out of power, the music will stop (the interface is usually a standard 3.5mm headphone jack). Aux is short for Auxiliary, which refers to an additional signal line design. In general audio equipment, besides the standard output and input terminals, there are often several terminals labeled Aux, serving as backup connection points. When there is a special need, such as additional audio output or input, these terminals can be used. These backup terminals or lines, regardless of input or output, are collectively referred to as Aux. Function: The AUX port is an asynchronous port, mainly used for remote configuration, dial-up connections, or connecting with a MODEM via a transceiver. It supports hardware flow control. The AUX port and CONSOLE port are usually placed together because they are used in different configuration environments. The AUX interface establishes a command-line connection between the user and the device, enabling operations that are usually impossible in user mode, such as initialization, restoring default configurations, or correcting abnormal user modes. It provides a fixed port for the device, which can be used as a standard asynchronous serial port with a maximum speed of 115200bit/s. Using the AUX interface, remote configuration and line backup functions for hardware products can be achieved. Note: When using the AUX interface, ensure you purchase the correct connecting cable and avoid plugging the audio cable into the wrong port. It is best to follow the steps in the product's user manual when using the AUX interface. If you are still unsure, you can consult the product's official website or call for assistance.
1
5
Share

What are the regulations for changing lanes for motor vehicles?

When changing lanes, vehicles must not affect the normal passage of other vehicles or pedestrians and shall comply with the following regulations: 1. Yield to vehicles in the target lane: Give way to vehicles or pedestrians in the lane you intend to enter. 2. Avoid frequent lane changes: Drive in an orderly manner and refrain from frequently changing lanes. 3. No multiple lane changes at once: Do not change more than two lanes in one continuous movement. 4. Left lane yields to right lane: When vehicles from both the left and right lanes are changing into the same lane, the vehicle from the left lane must yield to the vehicle from the right lane.
2
4
Share

What are the three filters in automotive engine oil?

Automotive engine oil three filters refer to the air filter, oil filter, and fuel filter, each serving the following purposes: 1. Air filter: Ensures the air entering the engine is clean; 2. Oil filter: Filters the engine oil to ensure smooth engine operation; 3. Fuel filter: Ensures clean fuel supply and prevents vapor lock. Automotive engine oil plays a crucial role in filtering air and fuel for the engine, providing lubrication and protection, thereby enhancing engine efficiency. Regular cleaning of automotive engine oil can maximize engine performance, reduce the incidence of engine failures, and contribute to prolonging the engine's service life.
11
3
Share

What brand is Maximum tire?

Maximum tire is a Giti brand tire, and its maintenance methods are: 1. Regularly check tire pressure; 2. Regularly check for bulges, cracks, cuts, punctures, or abnormal wear; 3. Remove stones, metal pieces, and nails from tire treads; 4. Perform wheel alignment or tire balancing; 5. Tires are rubber products and will experience aging, with a general shelf life of 4 to 5 years. Tires are an important component of a vehicle, directly in contact with the road surface. Together with the vehicle suspension, tires help to absorb shocks during driving, ensuring good ride comfort and smooth driving.
11
2
Share

What Causes a Dash Cam to Restart Frequently?

Reasons for frequent dash cam restarts: 1. SD Card: If the SD card is faulty, try formatting it and restarting; 2. Firmware: The dash cam firmware may need updating—refer to the manual; 3. Battery: Battery issues may require draining it completely before reconnecting; 4. Wiring: Faulty wiring may necessitate replacing the power cable. Dash cam functionality: A device that records video, audio, and related data during vehicle operation. After installation, it captures the entire driving process, providing crucial evidence for traffic incidents.
14
4
Share

Can Alcohol Be Stored Inside a Car in Summer?

Alcohol should not be stored inside a car during summer as it is a flammable and explosive substance, and exposure to sunlight can easily lead to explosions. Here are some key points about alcohol: 1. Alcohol is a flammable and explosive material. When exposed to sunlight, the temperature inside a sealed car can rise to 50-60 degrees Celsius. In an unventilated environment, if exposed to an open flame or other flammable materials, it can cause an explosion. 2. If stored in glass containers, sunlight can create a magnifying glass effect, focusing light and igniting the alcohol, which is highly likely to result in an explosion. Additionally, perfumes containing alcohol should also not be used inside a car.
9
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.