What is the speed limit on the Rilan Expressway?

2 Answers
DiFaith
07/29/25 5:08am
Highway speed limits vary by lane. The speed limits on the Rilan Expressway are as follows: 1. Two lanes in the same direction: The minimum speed limit for the left lane is 100 km/h, and for the right lane is 60 km/h. 2. Three lanes in the same direction: The minimum speed limit for the far-left lane is 110 km/h, the middle lane is 90 km/h, and the far-right lane is 60 km/h. 3. Special requirements: The maximum speed limit for small passenger vehicles is 120 km/h, for other motor vehicles is 100 km/h, and for motorcycles is 80 km/h. If the lane speed limit differs from the posted signs, the posted signs take precedence.
Was this review help?
6
5
Share
WillowRose
08/12/25 8:46am
I've been driving for decades. The speed limit on the Rilan Expressway is usually 120 kilometers per hour, which is crucial for ensuring driving safety. However, in foggy or rainy conditions, the speed limit may be reduced to 100 kilometers, and certain sections like tunnel entrances have special signs that must be obeyed. Speeding not only results in high fines but also easily leads to accidents—I've witnessed many rear-end collisions. I recommend that new drivers pay close attention to in-car navigation prompts and maintain a safe following distance. The highway is not a racetrack; driving steadily brings more peace of mind. Regular vehicle maintenance is also essential, as worn tires can increase braking distance.
Was this review help?
12
0
Share
Expand All
More Forum Discussions

How to Remove Residual Adhesive from Car Window Film?

Methods to remove residual adhesive from car window film: 1. Alcohol removal: Prepare a soft and clean cloth, pour a small amount of alcohol onto the cloth, then wipe the area with residual film adhesive. Repeat the process several times; 2. Nail polish remover: Nail polish remover can effectively remove highly adhesive substances. Since nail polish and window film adhesive have similar properties, using nail polish remover is also effective; 3. Use a heat gun to warm the adhesive. Heating can significantly reduce the adhesive's stickiness, then use a soft, clean cloth to wipe it off thoroughly. Avoid using blades to prevent scratching the car glass.
1
3
Share

Should You Accelerate When Driving Through Flooded Roads?

When driving through flooded roads, you should not accelerate. According to Article 64 of the "Regulations for the Implementation of the Road Traffic Safety Law": When a motor vehicle passes through a flooded road or bridge, it should stop to check the water conditions and proceed at a low speed only after confirming safety. If the water level is below half of the tire height, the driver can first observe whether other vehicles passing through the water are moving smoothly. While driving, if you notice standing water on the road ahead, you should first slow down or stop to observe. If the water level reaches the bumper or two-thirds of the tire height, proceeding further poses certain risks. Higher speeds increase the actual depth of water the vehicle passes through, potentially allowing water to enter the cabin from the engine compartment or chassis. Additionally, drivers should avoid driving against the waves created by large vehicles. If the driver observes that the water level is too high, they should try to detour and avoid forcing their way through. Precautions when driving through flooded roads: During the crossing, pay special attention to slowing down and avoid staring at the changing water flow to prevent stopping midway. After crossing, intermittently press the brake pedal lightly to restore braking effectiveness.
18
0
Share

How to Use Car Rearview Mirrors

Methods for using car rearview mirrors: 1. When the rear vehicle occupies the entire mirror, the distance is about 3 meters; 2. When the rear vehicle occupies two-thirds of the mirror, the distance is about 5 meters; 3. When the rear vehicle occupies half of the mirror, the distance is about 9 meters; 4. When the rear vehicle occupies one-third of the mirror, the distance is about 12 meters; 5. When the left rearview mirror shows the middle of the rear wheel cover aligned with the ground, that indicates the position of the rear bumper; 6. To judge the distance of the rear vehicle through the interior rearview mirror by observing the lower edge of the rear windshield: if the upper edge of the rear vehicle's headlight is visible, the distance between the rear trunk and the vehicle is approximately 3.5 meters; if the junction between the rear vehicle's hood and windshield is visible, the distance is about 1 meter; if the top one-third of the rear vehicle's windshield is visible, it means the vehicle is very close.
9
5
Share

What kind of engine oil can be used for Honda Vezel?

Honda Vezel can use the original engine oil, with models including 0W20, 0W30, 5W30, and 10W30. Different models of engine oil cannot be mixed. Engine oil is a crucial factor affecting the engine's performance and lifespan. The quality of the engine oil must not only meet the requirements of the engine and exhaust purification system but also match the fuel quality. The Honda Vezel is a compact SUV under GAC Honda, with dimensions of 4328 mm in length, 1772 mm in width, and 1605 mm in height, and a wheelbase of 2610 mm. In terms of suspension, the Honda Vezel features a MacPherson strut independent front suspension and a torsion beam non-independent rear suspension.
9
3
Share

What engine is used in the Hongqi HS5?

The Hongqi HS5 is equipped with a 2.0T turbocharged engine, which has a maximum power output of 165 kW and a maximum torque of 340 N·m. This is a domestically produced engine that complies with the China VI emission standards. In terms of the transmission system, the engine is paired with a 6-speed automatic manual transmission. The Hongqi HS5 is an SUV that embodies the concept of new high-end refinement. The vehicle has dimensions of 4760 mm in length, 1907 mm in width, and 1700 mm in height, with a wheelbase of 2870 mm. Regarding safety features, the Hongqi HS5 is equipped with an active braking system that can detect the distance between the vehicle and the one in front in real-time. When it determines that a collision is imminent, the vehicle will automatically apply the brakes to avoid or mitigate the impact of a collision.
13
4
Share

How to Activate the Windshield Washer?

The method to activate the windshield washer: The washer switch is located on the wiper control lever on the right side of the steering wheel. Pull the wiper control lever towards the driver to spray water. If used frequently, remember to check the washer fluid level and replenish it in time when it's too low to avoid dry wiping. When the rain is not heavy and the rainwater on the windshield is not dense, set the wiper lever to the low-speed intermittent mode, marked as LO or LOW. When the rain intensifies and the windshield quickly gets covered with water, significantly impairing visibility, switch the wiper to the high-speed continuous mode, marked as HI or HIGH, to continuously clear water from the windshield.
4
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.