What is the speed limit on expressways?

How to Determine if a Car is New When Buying?

When buying a car, you can determine if it is new by checking the vehicle identification plate located on the passenger side door or in the engine compartment. Below are specific details about the hazards of stock vehicles: Substandard Engine Oil: The lubricants and engine oil inside the vehicle may oxidize or absorb moisture, preventing the car from operating at optimal performance. Substandard engine oil can even damage the engine. Component Deformation: If a vehicle has been parked for an extended period, the relative movement directions of its mechanical components become consistent. Over time, this can lead to deformation or misalignment, making the vehicle dangerous to drive. Component Aging: If the vehicle has been stored outdoors, its rubber components may age or deform, potentially causing issues such as cracked windshield wipers, leaking seals, and reduced sound insulation. Battery Drain: The car battery relies on the engine running to recharge itself. If a stock vehicle has not been started for a long time, the battery may remain in a depleted state, significantly shortening its lifespan.

15

2

Share

Why does the Sagitar always have noise from the right rear wheel?

Sagitar right rear wheel noise may be caused by insufficient lubrication of the wheel hub bearing, unstable tire pressure, aging of the shock absorber rubber sleeve, and other reasons. Pay attention to tire pressure: Pressure is the lifeblood of tires. Both too high and too low pressure will shorten their service life. If the pressure is too low, the tire body deformation increases, cracks are prone to appear on the tire side, and flexing motion occurs, leading to excessive heat generation, promoting rubber aging, fatigue of the cord layer, and cord breakage. Too low pressure will also increase the tire contact area and accelerate shoulder wear. If the pressure is too high, the tire cords will be excessively stretched and deformed, the tire body elasticity will decrease, and the load on the car during driving will increase. Regularly check front wheel alignment: Front wheel alignment has a significant impact on tire service life, with front wheel toe-in and camber being the main factors. Front wheel camber mainly accelerates shoulder wear, i.e., uneven wear. Too much or too little front wheel toe-in mainly accelerates wear on the inner and outer sides of the tire.

2

5

Share

Is there any compensation for the JAC Refine S3 recall?

There is no compensation for the JAC Refine S3 recall; timely inspection and resolution of issues constitute good after-sales service. JAC Refine S3 Exterior: The exterior details complement the overall design, with the grille featuring three prominent chrome strips, which have become a signature of the Refine S3. The front and rear light designs, along with the window lines, are accentuated by chrome decorations on the windows and lower door sills. JAC Refine S3 Interior: The Refine S3 features an overall dark interior with red stitching, and the dashboard is adorned with a horizontal silver trim, giving it a sporty feel. The instrument cluster adopts a dual-dial design, displaying driving information clearly with adjustable brightness. The three-spoke multifunction steering wheel is wrapped in genuine leather and integrates audio controls, cruise control, and Bluetooth functionality for easy operation.

15

1

Share

Will the Model X be domestically produced?

Model X is unlikely to be domestically produced in the near future within the next few years. As one of Tesla's more significant models, its domestic production may occur relatively late. Model X configurations: The Model X is a high-performance, intelligent full-size SUV, featuring standard all-wheel drive and equipped with a 90kWh battery offering a range of 489 kilometers. It accelerates from 0 to 100 km/h in just 3.5 seconds, with a top speed of 250 km/h. Model X safety: The Model X is equipped with an active safety protection system that continuously monitors road conditions around the vehicle through cameras, radar, and sonar systems, providing real-time feedback to the driver to minimize the risk of accidents.

14

2

Share

What are the restricted hours for driving on highways?

According to relevant traffic regulations in China, long-distance passenger vehicles are prohibited from driving on highways between 2:00 AM and 5:00 AM, but this restriction does not apply to other types of vehicles. In other words, private cars (sedans) are allowed to drive on highways 24 hours a day without any restricted time periods. The primary reason for prohibiting long-distance passenger vehicles from using highways between 2:00 AM and 5:00 AM is to prevent driver fatigue and reduce the occurrence of traffic accidents. Many accidents involving long-distance passenger vehicles are closely related to fatigue driving during nighttime hours, which led traffic management authorities to establish this regulation. For long-distance passenger vehicles that enter the highway before 2:00 AM, they are not allowed to continue driving during the restricted hours. They must stop at nearby service areas for rest and can only resume driving on the highway when the restricted period ends. Although there are no explicit restricted hours for sedans and other vehicles on highways, there are clear regulations regarding drivers' driving and rest times: During daytime, drivers cannot drive continuously for more than 4 hours, and at night, they cannot drive continuously for more than 2 hours. Each rest stop must last at least 20 minutes; The total driving time within 24 hours cannot exceed 8 hours; The total driving time over 7 consecutive days cannot exceed 44 hours, during which drivers must take effective rest breaks.

17

1

Share

Where is the tire pressure reset button for the Atenza?

The Atenza does not have a traditional tire pressure reset button; you need to find the tire settings in the central display. Tire pressure light reset steps: Locate the central display inside the car and touch the CAE button on the left. Enter the vehicle settings menu interface, select tire settings from the vehicle settings options. In the tire settings interface, click the SET button. Click "Confirm" on the pop-up prompt interface. At this point, the car's tire pressure monitoring system begins the initialization operation. Once the progress bar is completed, the Atenza's tire pressure light will reset to zero. Definition of tire pressure monitoring: Tire pressure monitoring is the real-time automatic monitoring of tire pressure during car driving, with alerts for tire leaks and low pressure to ensure driving safety.

2

1

Share

What is the speed limit on expressways?

How to Determine if a Car is New When Buying?

Why does the Sagitar always have noise from the right rear wheel?

Is there any compensation for the JAC Refine S3 recall?

Will the Model X be domestically produced?

What are the restricted hours for driving on highways?

Where is the tire pressure reset button for the Atenza?

Will LED Headlight Fan Failure Cause Spontaneous Combustion?

What is the reason for Volvo displaying low coolant when braking?

Is XPeng a Domestic Car?

Where is the wiper fuse located in the 2017 New Jetta?