What is the speed limit on elevated roads?

1 Answers
Gia
07/30/25 8:58am
The minimum speed on elevated roads is 60 km/h, and the maximum is 120 km/h. Below is relevant information about driving: 1. Precautions: Strictly adhere to traffic regulations, maintain proper control of the steering wheel while driving, perform vehicle maintenance before departure, and exercise caution when driving at night as a beginner. Vehicles must display license plates, inspection stickers, and insurance stickers, and the driver must carry the vehicle registration certificate. 2. Techniques: Switch to low beams when meeting another vehicle at night and avoid using high beams to illuminate oncoming traffic. If visibility is impaired by the high beams of an oncoming vehicle, stop and wait until the road is clearly visible before proceeding.
Was this review help?
12
0
Share
More Forum Discussions

What to Do if the Engine Cylinder Gasket Has a Slight Water Leak?

Engine cylinder gasket slight water leakage only requires replacing the cylinder gasket. With the continuous enhancement of internal combustion engines, both thermal and mechanical loads are increasing, making the sealing performance of cylinder gaskets increasingly important. Here is supplementary information about engine cylinder gaskets: 1. Metal-asbestos cylinder gasket: This type of gasket has metal wires or shavings sandwiched in asbestos, covered with copper or steel sheets, with a thickness of 1.2-2mm. It has good elasticity and heat resistance and can be reused, but its strength is relatively poor, and the thickness and quality are uneven. 2. Solid metal sheet cylinder gasket: Made of solid metal sheets, this type of gasket is commonly used in cars and racing cars. Sealing is achieved by stamping raised patterns of a certain height around the cylinder holes, water holes, and oil holes, utilizing the elastic deformation of the raised patterns to ensure sealing.
16
0
Share

Can Tires with Small Cracks Still Be Used?

When small cracks appear on car tires, they should not be used. Below is a detailed introduction regarding the use of car tires: 1. When cracks appear on tires, they need to be replaced promptly. Car tires are made of rubber, metal, fabric, and various chemical additives, with rubber being more prone to aging. The anti-aging components added to the rubber gradually lose effectiveness over time, leading to the appearance of fine cracks on the rubber. 2. Try to avoid turning the steering wheel while stationary, avoid driving over curbs, and steer clear of mounting curbs as this can easily cause tire bulges. Avoid potholes on the road; driving quickly over uneven surfaces can lead to tire bulges and tread detachment. Avoid scraping the tire sidewalls, as they are relatively fragile. Scraping against curbs while parking can easily cause bulges or ruptures.
15
1
Share

Do I Need to Replace the Car Lock If I Lost the Car Key?

If you lose your car key, you can either replace the lock or take the spare key to a locksmith to have a new one made. Here are some relevant details about car keys: Precautions for Mechanical Keys: Pure mechanical car keys are now rare and are mostly found in some low-end models. These keys are as simple as ordinary door lock keys, with one key capable of unlocking the car door, trunk, and starting the engine. Therefore, whether you have a spare key or not, it's best to replace all the locks on the car. Precautions for Using Car Keys: In daily use, car owners should take good care of their car keys. Dropping the key or getting it wet is common, but severe impacts can easily damage the internal chip of the key. Also, avoid exposing the key to liquids and keep it away from strong magnetic fields. Always keep the main key and spare key separate.
9
2
Share

What causes uneven cooling in the Mercedes-Benz R300 air conditioning system?

Uneven cooling in the Mercedes-Benz R300 air conditioning system may be caused by the following reasons: 1. Refrigerant shortage: Car air conditioners typically require refrigerant replenishment every 2-3 years. Most refrigerant loss occurs due to leaks. If the AC performance deteriorates after refrigerant recharge and then worsens again after some time, this requires attention. 2. Damaged air blend door: Failure of the air blend door actuator is relatively uncommon but not unheard of. When no air comes from any vents after turning on the AC, replacing the actuator requires dashboard removal. 3. Dirty condenser: During summer, when car AC systems fail to cool properly despite normal system pressure readings during inspection, dealerships often recommend radiator cleaning. The primary purpose of cleaning the radiator and condenser is to improve heat dissipation. Accumulation of springtime poplar and willow catkins on the condenser can cause engine overheating or poor AC performance.
5
1
Share

Which lane should a beginner drive on the highway?

For beginners driving on the highway, it is best to stay in the middle lane. Driving in the middle lane allows you to choose to change lanes to the left or right to avoid danger if an emergency occurs ahead. Highway speed limits: Highways should indicate the speed limits for each lane. The maximum speed should not exceed 120 kilometers per hour, and the minimum speed should not be lower than 60 kilometers per hour. On highways, the maximum speed for small passenger vehicles should not exceed 120 kilometers per hour, while other motor vehicles should not exceed 100 kilometers per hour, and motorcycles should not exceed 80 kilometers per hour. Precautions for the fast lane: When driving in the fast lane, be cautious when changing lanes or overtaking. You need to slow down in advance, as the process of changing lanes is quite dangerous. If you miss an exit, there is no way to make a U-turn or stop. Forcing a lane change can lead to traffic accidents.
14
4
Share

What to Do If Vehicle Registration Fails After Transfer?

Vehicle registration failure after transfer necessitates the replacement of license plates and the vehicle registration certificate. Below is a detailed explanation of what to do if vehicle registration fails after transfer: 1. When a vehicle is relocated from one city to another, a change in the governing vehicle management authority requires the completion of a new registration. 2. Vehicle transfer mandates the replacement of license plates and the vehicle registration certificate, with procedures to be completed at both the outgoing and incoming vehicle management authorities, including transfer-out and transfer-in processes. 3. Both the buyer and seller must sign the "Used Vehicle Sales Contract" supervised by the industrial and commercial department, with the contract issued in triplicate—one copy for each party and one retained by the industrial and commercial department. 4. Only after filing with the industrial and commercial department can the vehicle transfer or registration procedures proceed. 5. Once the evaluation report is available, the transfer process can begin. 6. The completed transfer certificate should be retained by the buyer, and the seller is advised to keep a copy for future reference.
3
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.