What is the speed limit in villages?

1 Answers
ORonan
07/29/25 5:45pm
Village driving speed for motor vehicles must not exceed 30 kilometers per hour. Below are specific speed limit regulations for vehicles: 1. Roads without center lines: Urban roads have a speed limit of 30 km/h, while highways have a limit of 40 km/h. 2. Roads with only one motor vehicle lane in the same direction: Urban roads have a speed limit of 50 km/h, while highways have a limit of 70 km/h. Below are extended regulations regarding temporary parking of motor vehicles on roads: 1. Sections with no-parking signs or markings: Parking is prohibited. 2. Intersections, railway crossings, and sharp curves: Parking is prohibited. 3. Areas in front of bus stops, emergency stations, gas stations, fire hydrants, or fire stations: Parking is prohibited.
Was this review help?
14
3
Share
More Forum Discussions

Why does the Tiguan always squeak after starting?

Tiguan cold start squeaking is a normal phenomenon. Due to dew and undried water from car washing adhering to the brake discs, the brake discs rust quickly. Additionally, after pulling the handbrake overnight, the sound will naturally disappear once the vehicle has run for a distance and the brake clearance returns to normal as the car warms up. The cooling system maintenance methods are as follows: 1. Check the water pump: First, visually inspect the water pump's drain hole, thermostat connection, upper and lower hose connections, drain port, radiator cap, and coolant reservoir for any signs of leakage. If leaks are found, identify the cause and address it immediately; never continue driving with the issue. 2. Check the antifreeze's freezing point: Generally, the antifreeze's freezing point should be 5 to 10°C lower than the lowest temperature in the vehicle's operating region. 3. Monitor the antifreeze level: The ideal level is about 10 mm below the radiator filler neck, or follow the standard markings on the coolant reservoir to top up with the same type of antifreeze. 4. Check the thermostat: If the thermostat is not functioning properly, the engine will operate at either too low or too high temperatures for extended periods, accelerating wear and shortening the engine's lifespan. Therefore, ensure the thermostat is in good condition.
1
4
Share

Does the Tayron have a particulate filter?

Tayron 2020 and 2021 models with the 280 engine are equipped with the EA211-DJS engine, which includes a particulate filter. A particulate filter is a ceramic filter installed in the diesel engine's emission system that captures particulate emissions before they enter the atmosphere. It can reduce soot emissions from diesel engines by more than 90%, and the captured particulate matter is subsequently burned off during vehicle operation. Working principle of the particulate filter: The diesel particulate filter is coated with metals such as platinum, rhodium, and palladium. The black smoke containing carbon particles emitted by the diesel engine enters the particulate filter through a dedicated pipe. Inside, a densely arranged bag-type filter captures the carbon particles on a metal fiber felt filter. When the accumulated particulate matter reaches a certain level, the burner at the end automatically ignites, burning off the captured carbon particles and converting them into harmless carbon dioxide. To check if the Tayron has a particulate filter, you can use the following three methods: Check the and to see if the particulate filter function is mentioned. Additionally, carefully review the fault codes in the manual to see if there is a "particulate filter" warning light indicator. Check the label on the oil cap. If the oil cap clearly states the use of 0W-20 grade oil, it indicates the presence of a particulate filter. Look behind the three-way catalytic converter to see if there is a cylindrical section on the exhaust pipe. If present, that is the particulate filter.
15
2
Share

What are the reasons for the BYD S6 air conditioner not cooling?

The reasons for the BYD S6 air conditioner not cooling include insufficient or too little refrigerant, which requires adding refrigerant or releasing excess refrigerant; the air conditioner compressor drive belt is loose, requiring tightening of the drive belt; the use of unqualified refrigerant and refrigeration oil, necessitating replacement; moisture has entered the refrigeration system, requiring replacement of the desiccant, followed by vacuuming the air conditioning system and refilling it with a new, appropriate amount of refrigerant. A common reason for car air conditioners not cooling is insufficient or too little refrigerant. The proportion of refrigerant in the air conditioning system has specific requirements; too much or too little will affect its heat dissipation. If there is too little, refrigerant can be added from the low-pressure side; if there is too much, some refrigerant can be slowly released from the maintenance port on the low-pressure side of the air conditioning system. If the drive belt is loose, the compressor will slip during operation, leading to reduced transmission efficiency, decreased compressor speed, and reduced delivery of compressed refrigerant, resulting in the car air conditioner not cooling. If the compressor drive belt is too loose, it needs to be tightened. If it cannot be turned by hand, it indicates the belt is too tight and should be slightly loosened. If tightening is ineffective or the belt has cracks, aging, or other damage, a new drive belt should be replaced. Excessive impurities in the refrigerant and refrigeration oil can also cause the car air conditioner's filter to become clogged, leading to the air conditioner not cooling. Increased resistance will reduce the flow of refrigerant to the expansion valve, resulting in insufficient cooling capacity. It is necessary to reselect qualified refrigerant for addition. If moisture enters the car air conditioner's refrigeration system, it can also cause insufficient cooling or no cooling. In this case, the desiccant or dryer in the car air conditioner needs to be replaced. At the same time, the system should be vacuumed again, and a new, appropriate amount of refrigerant should be injected.
11
1
Share

What Causes the Abnormal Noise in Passat?

Passat abnormal noise causes are as follows: Test Drive Inspection: Through test drive inspection, it can be determined that the clutch inside the transfer case is damaged, resulting in obvious shaking when the steering is turned to the limit. Component Damage: The malfunction is mainly caused by damage to the internal differential or clutch, leading to the issue. The primary symptom is mostly shaking, which often occurs severely during initial acceleration or when the steering is turned to the limit. Installation Adjustment: During installation, proper clearance adjustment is necessary to ensure the repaired transfer case functions correctly and completely resolves the shaking issue.
8
0
Share

Why Are the Brake Lights Still On When the Car Is Off?

If the brake lights remain on when the car is turned off, it is most likely due to a faulty brake switch. Here is some knowledge about brake lights: 1. Principle of brake lights: In simple car models, power flows through a fuse to the brake switch. When the brake pedal is pressed, the switch connects, sending electricity to the two brake lights and one high-mounted brake light, completing the circuit through the negative wire connected to the car body. 2. Function of brake lights: Brake lights are bright and highly visible, primarily used to alert following vehicles that the car is slowing down or stopping. Incorrect use or malfunction of brake lights can easily lead to rear-end collisions.
9
5
Share

Does Subaru have factories in China?

Subaru does not have factories in China. Subaru's powertrain: It is equipped with a 2.0L turbocharged direct-injection engine, which can deliver a maximum peak power of 177kw, with torque starting from 2400rpm and maintaining a peak of 350Nm up to 3600rpm. Subaru's exterior design: The hood features more muscular bulges, and the air intake previously exclusive to turbocharged models on the hood has been replaced with decorative strips on both sides of the bumper. The increasingly popular daytime running lights are not included in the new Forester's headlight design, while LED position lights cater to consumer preferences.
15
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.