···
Log in / Register

What is the speed limit for four lanes in the same direction?

4 Answers
VanAdelyn
08/28/25 5:25am

Highway speed requirements and legal regulations for four lanes in the same direction are as follows: Speed requirements: For two lanes in the same direction: The minimum speed of the left lane is 100 kilometers per hour. For three or more lanes in the same direction, the minimum speed of the leftmost lane is 110 kilometers per hour, and the minimum speed of the middle lane is 90 kilometers per hour. For four lanes in the same direction, the maximum speed must not exceed 120 kilometers per hour. If the speed limit indicated by road signs is inconsistent with the above lane speed regulations, drivers should follow the speed limit indicated by the road signs. Legal regulations regarding speed: According to Article 78 of the "Implementation Regulations of the Road Traffic Safety Law of the People's Republic of China", highways should indicate the driving speed of each lane. The maximum speed must not exceed 120 kilometers per hour, and the minimum speed must not be lower than 60 kilometers per hour.

Was this review help?
20
0
Share
IsabelFitz
09/10/25 3:49am

Every time I drive on a four-lane highway, I pay special attention to the speed limits, which vary depending on the location but generally range between 70 to 110 kilometers per hour, depending on the road type and signage. For instance, in urban four-lane roads, the speed limit might be 50 km/h, while on suburban highways, it can go up to over 100 km/h. As a driver, I always believe that controlling speed is crucial for safety, primarily to avoid rear-end collisions; maintaining similar speeds across different lanes can reduce the risk of side-swiping. I often remind myself to observe the vehicle ahead and slow down when necessary. Additionally, speeding not only results in hefty fines but also increases the chance of accidents, so I prefer using cruise control to maintain a steady speed. In fact, speed is also affected by weather conditions—during rain or fog, I reduce my speed even further to ensure a shorter braking distance. During my early days as a new driver, I often drove too fast on four-lane roads and learned the hard way; now, I plan my route in advance and check speed limit signs carefully.

Was this review help?
15
4
Share
Expand All
DiAndrew
10/24/25 4:40am

In China, speed regulations primarily adhere to the GB7258 national standard and relevant local regulations. On the same four-lane road, speeds are typically allowed between 60 to 120 km/h. For instance, urban arterial roads may have a limit of 60 km/h, while highway tunnel zones could be restricted to 80 km/h. From experience, I know it's essential to obey the signs to avoid penalty points; it's advisable to glance at roadside prompts when starting. Significant speed differences between lanes can be hazardous, so while the inner fast lane permits higher speeds, abrupt acceleration should be avoided. Understanding tire and braking system performance is also crucial, as braking distance increases at higher speeds—I've tested that braking at 100 km/h can result in a skid of several dozen meters. Personally, I prioritize using navigation apps for real-time speed limit alerts. Modified car enthusiasts might disregard speed limits but risk tire blowouts; my car undergoes regular maintenance to ensure the speed limiter functions correctly.

Was this review help?
18
3
Share
Expand All
SavannahRose
12/07/25 5:04am

When driving daily on a four-lane road, I always worry about speed variations. Based on road conditions: urban busy areas are limited to 40-60 km/h, while suburban highways can exceed 100 km/h; the number of lanes has minimal impact, with the environment being the key factor. I believe maintaining a steady speed is safest—sudden acceleration not only wastes fuel but also increases the risk of losing control. As an average driver, I often calculate: if the speed difference exceeds 20 km/h, the risk of collision with the car ahead doubles, so I stay in the middle lane and avoid speeding. Related to this is checking brakes and suspension—older cars with worn tires should be driven slower. In heavy rain, I reduce speed by half to ensure clear visibility and minimize accidents. With frequent accidents these days, paying attention to speed at all times protects both myself and my family.

Was this review help?
3
1
Share
Expand All
More Forum Discussions

How to Shift from D Gear to S Gear?

While the car is in motion, you can directly shift from D gear to S gear. The D gear can also be engaged into S gear during acceleration. Here is an introduction to shifting from D gear to S gear in an automatic transmission car: 1. When shifting from D gear to S gear in an automatic transmission car, there is no need to press the brake or come to a complete stop. The car can directly shift from D gear to S gear while driving, and the D gear can also be engaged into S gear during acceleration. After shifting to S gear, the power output becomes more intense, and fuel consumption increases accordingly, with power and fuel consumption being directly proportional. 2. For normal driving, D gear is generally used, as it has a very wide range of applications. In situations requiring higher power, S gear or sport mode can be used.
11
5
Share

What is the difference between SOHC and DOHC engines?

SOHC engine refers to its intake system using a single overhead camshaft, which means one intake valve and one exhaust valve; DOHC engine refers to its intake system using double overhead camshafts, generally with multiple valves per cylinder, commonly 4 valves. DOHC has two overhead camshafts placed on the cylinder block, the first one drives the intake valves, and the second drives the exhaust valves; SOHC, a single overhead camshaft in the cylinder head uses one camshaft to directly drive the intake and exhaust valves, featuring a simple structure and is suitable for high-speed engines. The single camshaft has a simpler mechanical structure, fewer issues, and greater low-speed torque. The opening times of the intake and exhaust valves in a single camshaft are fixed, but its mechanical simplicity, ease of maintenance, and fuel efficiency are all advantages of SOHC. The double camshaft can adjust the valve overlap angle, thus delivering greater horsepower, but it lacks low-speed torque and, due to its more complex mechanical structure, has higher manufacturing costs and maintenance expenses. The double camshaft technology originates from racing, primarily to control the timing difference between the intake and exhaust valves. Neither is inherently better; single and double camshafts are just structurally different.
17
0
Share

Do You Still Need to Press the Brake Pedal to Shift Gears While Driving an Automatic Transmission Car?

For automatic transmission vehicles, you need to press the brake pedal and also press a switch on the gear lever when shifting into P (Park) or R (Reverse) gears. Other gears can be engaged directly without pressing the brake. Additional information is as follows: 1. The requirement to press the brake for shifting is to prevent driver misoperation. Park and Reverse are two critical gears in the transmission system. Mistakes during shifting could cause the vehicle to lurch forward or backward, so for safety reasons, it's mandated that the driver must press the brake. 2. When pressing the brake, avoid pressing too lightly. Otherwise, the brake pedal sensor may not detect that the driver has pressed the brake, and the gear will not be released. Additionally, the vehicle may not achieve optimal braking performance.
2
1
Share

The Meaning of 175/70R14

175 indicates the tire width, which is 175 millimeters; 70 is called the aspect ratio, meaning the ratio of the tire's sidewall height to its width is 70%; R is the international code for radial tires, representing "radial tire"; 14 refers to the diameter of the wheel rim, which is 14 inches. Here is some information about tires: 1. Support the entire weight of the vehicle, bear the load of the car, and transmit forces and moments in other directions; 2. Transmit traction and braking torque, ensuring good adhesion between the wheel and the road surface to improve the car's power, braking, and passability; work together with the car suspension to mitigate impacts during driving and dampen the resulting vibrations; 3. Prevent severe vibrations and early damage to car components, adapt to the vehicle's high-speed performance, reduce driving noise, and ensure driving safety, handling stability, comfort, and energy efficiency.
19
4
Share

How many points are deducted for the car head sweeping the line during reverse parking?

Body sweeping the line means the body is out of line, deducting 100 points, resulting in failure of the current test. Crossing the line, not parking in the designated area, stopping midway, not following the prescribed route or sequence, and exceeding the time limit also result in a 100-point deduction. The two subjects have a total score of 100 points, with evaluation criteria set for failure, 20-point deduction, 10-point deduction, and 5-point deduction. The rules for the subject two driving license test state that stopping midway, rolling back, or not following voice prompts result in failure. Wheel or body touching the line also leads to failure. Many learners encounter line-touching issues during subject two learning, with 'touching the line' being the most common reason for failure. The main cause of wheel touching the line is learners not mastering the correct timing for steering. Besides missing the steering timing, another reason could be the steering speed not matching the vehicle speed. Subject two deduction standards: Not wearing a seatbelt: deduct 100 points. Starting the engine without the gear in neutral: deduct 100 points. Not using turn signals (including starting, lane changing, overtaking, turning, and parking); turn signals not used for over three seconds (note this is easily overlooked!); forgetting to turn off or incorrect use of turn signals: deduct 10 points. Stalling once: deduct 10 points. Reverse parking: Not following the prescribed route sequence: deduct 100 points. Body out of line: deduct 100 points. Not parking in the designated area: deduct 100 points. Before reversing, if both front wheels do not pass the control line: deduct 100 points. Exceeding 210 seconds to complete: deduct 100 points. Stopping for over 2 seconds midway: deduct 5 points each time. Slope fixed-point parking and starting: After stopping, if the front bumper is not on the pole line and exceeds 50cm front or back: deduct 100 points. After stopping, if the front bumper is not on the pole line but does not exceed 50cm front or back: deduct 10 points. After stopping, if starting takes over 30 seconds: deduct 100 points. Wheels touching the road edge while driving: deduct 100 points. Rolling back over 30cm when starting: deduct 100 points. After stopping, if the body is over 50cm from the road edge: deduct 100 points. After parking, not tightening the parking brake: deduct 10 points each time. After stopping, if the body is over 30cm but not over 50cm from the road edge: deduct 10 points each time. Rolling back over 10cm but less than 30cm when starting: deduct 5 points each time. Parallel parking: After parking, if the body is out of line: deduct 100 points. Not using or incorrectly using turn signals when parking: deduct 10 points. Exceeding 90 seconds to complete: deduct 100 points. Body touching the parking space line while driving: deduct 10 points each time. Wheels touching the lane line while driving: deduct 10 points each time. Stopping for over 2 seconds midway: deduct 5 points each time. 90-degree turn: Wheels touching the road edge: deduct 100 points. Not using or incorrectly using turn signals during the turn, or not turning them off after: deduct 10 points. Stopping for over 2 seconds midway: deduct 5 points each time. Curve driving: Wheels touching the road edge: deduct 100 points. Stopping for over 2 seconds midway: deduct 100 points. Driving without the gear in second or above: deduct 5 points.
20
3
Share

Can the vehicle color be changed?

Owners are allowed to change the color of their vehicles first and then complete the registration process. Below is relevant information: 1. Handling method: The vehicle color can be changed, but within ten days after the color change, the owner must bring the "Motor Vehicle Change Registration/Record Application Form," the original and photocopy of the vehicle owner's identity proof, the original "Motor Vehicle Registration Certificate," the original "Motor Vehicle License," etc., to the vehicle management office to complete the change registration. 2. Relevant regulations: According to the new "Motor Vehicle Registration Regulations," owners do not need to apply to the vehicle management office for a color change. However, for safety reasons, owners can also register at the local vehicle management office before changing the color of their vehicle. After changing the body color, they can then go to the vehicle management office to update the vehicle photo on the driving license.
3
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.