What is the speed in first gear?

1 Answers
OColton
07/29/25 11:28am
First gear is the speed for starting, typically ranging from 0-5 km/h. Below are detailed explanations about it: 1. Explanation one: The general shifting point for most cars is when the engine speed reaches 2000 r/min, preferably not exceeding 2500 r/min. 2. Explanation two: For some high-displacement, high-power engines, the maximum efficiency range is often delayed, so shifting around 3000 r/min can be considered. 3. Explanation three: Different vehicles perform differently in terms of engine and transmission. Drivers can identify the shifting point by listening to the engine sound.
Was this review help?
12
0
Share
More Forum Discussions

What grade of gasoline should a BMW X1 use?

BMW recommends using 95-octane gasoline for the X1, with a fuel tank capacity of 61 liters. For safety, the engine must be turned off before refueling, and the fuel tank cap can be opened by pressing one side without locking the car. Additionally, when refueling the BMW X1, it's important not to overfill the tank to avoid expansion and spillage. Here is a brief introduction to the gasoline grade for the BMW X1: (1) The gasoline grade for the BMW X1 represents the ratio of the actual gasoline's anti-knock performance to that of standard gasoline, which is composed of isooctane and n-heptane. (2) The higher the grade, the stronger the anti-knock performance, but higher grades are not necessarily better. The appropriate gasoline grade should be selected based on the engine's compression ratio.
8
0
Share

How to Fold Down the Rear Seats in the Tenth-Generation Accord?

The method to fold down the rear seats in the tenth-generation Accord is as follows: There is a lever in the upper right corner of the trunk; pull it to fold down the rear seats. Below are some precautions regarding seat usage: 1. After all passengers have adjusted their seats and headrests and fastened their seat belts, they should continue to sit upright and lean back in their seats with their feet on the floor until the vehicle comes to a complete stop and the power system is turned off. 2. In the event of a collision, improperly seated passengers are more likely to be injured. For example, if a passenger is slouching, lying down, leaning to the side, sitting too far forward, leaning forward or sideways, or has one or both feet off the floor, this increases the risk of injury in a crash. 3. If a passenger in the front seat is improperly seated, they may suffer serious injuries during a collision due to impact with interior components or the force of the deploying front airbags.
3
1
Share

How to Remove the Door Panel of the Buick New Excelle?

First, remove the panel of the window regulator. Most of them are fixed with clips, so gently pry it off. Below are the relevant steps for removing the door panel of the Buick New Excelle: 1. Start by removing the panel of the window regulator, which is usually fixed with clips, so gently pry it off. The model year of the car may vary, so the process might differ slightly. Then, disconnect the adjustment wire, being careful not to damage the wiring. Next, remove the nearby fixing screws and dismantle the door armrest. Pry off the fixed panel of the door switch, applying light force to avoid damaging the interior. Once these steps are completed, you can begin removing the door. 2. The door panel is fixed with clips, so the edges generally have clips that need to be pried open slowly. After prying off the door panel, keep the fixing clips safe to avoid losing them. Then, disconnect the wiring plug of the interior panel.
19
0
Share

What brand of tires does the Jetta VS5 use?

The Jetta VS5 uses Linglong GREEN-MAX HP200 series tires with a specification of 225/50R18. Below is relevant information about the tires: 1. The Linglong tires used offer excellent quality and cost-performance. Linglong Group's tire products have obtained certifications such as CCC, DOT, ECE, GCC, INMETRO, and LATU. The quality management system has passed ISO9001 and TS16949 certifications, along with ISO14001 environmental management system certification, GB/T28001 occupational health and safety management system certification, and has established an SA8000 social responsibility management system. 2. The high-end version of the Jetta VS5 is equipped with 18-inch two-tone aluminum alloy wheels featuring a dynamic and stylish multi-spoke design. The tires are Linglong GREEN-MAX HP200 series with a size of 225/50R18, offering a visually appealing side profile. 3. The base model comes with 225/55R17-sized tires and youthful wheel designs, adopting a petal-style multi-spoke wheel that is very attractive, with a two-tone color scheme that exudes a sporty vibe.
11
5
Share

What is the fuel consumption per kilometer of the CS75?

1.5T model has a combined fuel consumption of 9.5L, and the 1.8T model has a combined fuel consumption of 10.5L. Here is some relevant information about the CS75: 1. Advantages of the Changan CS75: The overall space performance of the vehicle is very ample, especially spacious. The front and rear seating areas are comfortable for daily use, and the seats are adjustable. Many families choose this car for this reason. When going out for trips, the rear seats can be folded down, allowing people to lie down and even sleep directly in the car. 2. Disadvantages of the Changan CS75: The suspension and chassis are relatively large, but during daily driving over speed bumps or rough roads, the suspension feels a bit stiffly tuned, and the bump filtration is not very good.
16
3
Share

What is the difference between 5w30 and 10w30 engine oil?

10w30 engine oil and 5w30 engine oil differ in their temperature adaptability: 10w30 engine oil is suitable for temperatures above -18 degrees Celsius, while 5w30 engine oil is suitable for temperatures below -18 degrees Celsius. The functions of engine oil include: lubrication, auxiliary cooling, cleaning, sealing and leak prevention, rust and corrosion prevention, shock absorption, and wear resistance. The method for adding engine oil is as follows: 1. Place a container: Lift the car, remove the protective plate, and place a container of about 10 liters under the oil drain screw. 2. Check: Loosen the oil drain screw, use an air gun to blow into the oil filler port for two minutes, tighten the oil drain screw after draining, and wipe it with a tissue to check for leaks. 3. Add engine oil: Reinstall the protective plate and lower the car, then use a funnel to pour the engine oil into the filler port.
7
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.