What is the solution for the Buick P0172 system running too rich?

1 Answers
LaMartin
07/29/25 2:15pm
Buick P0172 system running too rich can be resolved by: 1. Abnormal fuel filter pressure: Replace the fuel filter; 2. High-pressure pump leakage or abnormal fuel injector flow: Professional inspection and repair can be done at a 4S shop; 3. Check if the spark plugs, ignition wires, intake manifold pressure sensor, and throttle are functioning normally; 4. Check if the fuel pressure is too high, if the temperature sensor is providing accurate readings, and if the oxygen sensor voltage is normal. Taking the Buick 2021 New Excelle GT 1.5L Automatic Pioneer Edition as an example: The car's dimensions are 4609mm in length, 1798mm in width, 1464mm in height, with a wheelbase of 2640mm. The manufacturer of this car is SAIC-GM Buick, classified as a compact car, with a naturally aspirated intake form, a maximum horsepower of 113ps, and a maximum torque of 141nm.
Was this review help?
2
5
Share
More Forum Discussions

Can You Start a Car While the Battery Is Charging?

You can start a car while the battery is charging. Here are some precautions to note when starting a car while the battery is charging: 1. However, during the initial charging stage (when the battery is not fully charged), it may be difficult to start the car. This is because the charger's voltage does not exceed 15V while charging the battery. 2. When starting the engine, the large current required mainly comes from the battery itself. If the battery is not fully charged, it will not be able to provide enough starting current, making it difficult to start the car. The charger has a current-limiting function; when the battery voltage is very low (during startup), the charger's current is limited to a certain range to prevent overload and damage to the charger. 3. After the car is started, the battery voltage rises to around 14V. At this point, the charger will assume the battery is fully charged and will reduce the charging current until it stops charging. Therefore, you can start a car while the battery is charging without damaging the charger.
17
4
Share

What to Do When a Truck's Brakes Pull to One Side?

Here are the methods to address a truck's brakes pulling to one side: 1. If the brakes pull to one side, it is necessary to check the braking force of each wheel, as well as inspect the master brake cylinder, wheel brake cylinders, and the brake lines. 2. If the braking force distribution is uneven, it can lead to the phenomenon of the brakes pulling to one side. The braking system is a crucial component of a vehicle, directly related to driving safety. 3. If the wheels on the left and right sides are of different ages, the tire grip will vary, causing the brakes to pull to one side during braking. Therefore, when experiencing this phenomenon, it is essential to inspect not only the braking system but also the tires.
10
1
Share

How often should the transmission fluid be changed for a K2?

For the Kia K2, it is recommended to change the transmission fluid every two years or 40,000 kilometers. Below is some relevant information about the transmission: 1. Transmission fluid is an oil product that keeps the gear system clean, ensuring the transmission operates normally and extending the lifespan of the transmission components. 2. Transmission fluid, also known as gear oil, is used inside the transmission. It provides power to the gears through hydraulic pressure while also lubricating and cleaning the transmission. Its quality directly affects the transmission's performance. Transmissions are divided into manual and automatic, and correspondingly, transmission fluids can be categorized into automatic transmission fluid (ATF) and manual transmission fluid. ATF is specifically designed for automatic transmissions, while manual transmission fluid is for manual transmissions. 3. Whether it's a manual or automatic transmission, all transmission fluids have a limited lifespan. Once the vehicle reaches a certain mileage or the maintenance interval is due, the fluid should be changed immediately. Over time, transmission fluid becomes dirty and loses viscosity, which means it can no longer effectively protect the transmission. This can lead to symptoms like rough shifting, abnormal acceleration, loud noises, and in severe cases, premature transmission failure, significantly shortening the transmission's lifespan.
4
3
Share

What size tires can be installed on 16-inch rims?

16-inch rims can accommodate 225 specification tires. The following is relevant information about rims: 1. In the past, the wheel hub bearings of cars were mostly used in pairs with single-row tapered roller or ball bearings. With the development of science and technology, cars have widely adopted wheel hub units. 2. The application scope and quantity of wheel hub bearing units are increasing, and they have developed to the third generation: the first generation consists of double-row angular contact bearings; the second generation has a flange on the outer raceway for fixing the bearing, allowing the bearing to be easily fitted onto the wheel shaft and secured with a nut, making car maintenance easier; the third-generation wheel hub bearing unit combines the bearing unit with an anti-lock braking system. 3. The wheel hub unit is designed with inner and outer flanges. The inner flange is bolted to the drive shaft, while the outer flange integrates the entire bearing assembly.
11
0
Share

Which Turn Signal to Use When Making a Right U-turn?

When making a right U-turn, the right turn signal should be activated. For a left U-turn, the left turn signal should be used. According to Article 57 of the Implementation Regulations of the Road Traffic Safety Law, motor vehicles must use turn signals as follows: Activate the left turn signal in advance when turning left, changing lanes to the left, preparing to overtake, leaving a parking spot, or making a U-turn. Activate the right turn signal in advance when turning right, changing lanes to the right, returning to the original lane after overtaking, or parking by the roadside. When approaching sharp curves, hilltops, or other sections with limited visibility that affect safety, or when overtaking or encountering emergencies, motor vehicles should slow down and sound the horn as a warning. Article 58: When driving at night without streetlights, under poor lighting conditions, or in low visibility situations such as fog, rain, snow, dust, or hail, motor vehicles must turn on their headlights, position lights, and tail lights. However, high beams should not be used when following another vehicle closely in the same direction. During foggy conditions, motor vehicles must also turn on their fog lights and hazard warning lights.
16
0
Share

What to Do When a Motorcycle Won't Start After Long-Term Storage?

Methods for starting a motorcycle that has been stored for a long time: Due to prolonged disuse, the gasoline in the carburetor evaporates and deteriorates, clogging the carburetor's jets. A thorough and careful cleaning of the carburetor should resolve the issue. Reasons why a motorcycle won't start: 1. Carburetor issues, typically due to prolonged use. 2. Spark plug problems, sometimes caused by fuel flooding the plug. 3. Weather conditions. For example, cold winter weather can make it difficult to start. 4. Frequent use of the electric starter can drain the battery if the motorcycle doesn't start, potentially damaging the battery. 5. Idle speed issues. Sometimes, failure to start may be due to low idle speed. In summer, the idle speed should be adjusted so the tachometer needle points to one mark or slightly more, while in winter, it should be adjusted to one and a half marks or below two.
9
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.