What is the solution for Odyssey shaking?

1 Answers
StNaomi
07/30/25 8:51am
Odyssey shaking causes and solutions are as follows: 1. Severe engine carbon deposits The most common cause of car shaking is a dirty throttle body or excessive carbon buildup in the fuel injectors. When there is too much carbon deposit inside the engine, the gasoline sprayed by the cold start injector will be largely absorbed by the carbon deposits, resulting in an overly lean air-fuel mixture during cold starts and making it difficult to start. The solution is to clean the fuel system and check if the idle speed control valve has carbon deposits, which should be cleaned. 2. Ignition system problems Check the working condition of the spark plugs, high-voltage wires, and ignition coils. Poor performance of the ignition system or bad spark plug firing can also cause such faults. The solution is to check if the spark plugs have excessive carbon deposits and replace them if necessary.
Was this review help?
17
1
Share
More Forum Discussions

How to troubleshoot Tianlong EECU malfunctions?

Here are the specific methods for troubleshooting Tianlong EECU malfunctions: 1. Check and find that the shutdown switch wiring harness connector has water ingress (close to the front wheel), with corroded pins. 2. After derusting and anti-rust treatment of the pins, reconnect to resolve the malfunction. Here are the reasons for Tianlong EECU malfunctions: 1. Issues with the CAN bus. 2. Loose or poor contact in the CAN bus connector. Here is additional information on vehicle malfunctions: 1. When communication between the engine ECM and the instrument panel is interrupted, the instrument panel will report an EECU malfunction. 2. Faults in the vehicle's electronic system can affect the normal use of some vehicle functions and the proper operation of the engine.
10
3
Share

What should I do if the heating wire on the rear windshield of my car is broken?

When the heating wire is damaged, it cannot be repaired and the entire glass needs to be replaced. If the fuse is blown, only the fuse needs to be replaced. Here is a detailed introduction to the heating wire: The electric heating wire on the rear windshield of a car functions similarly to a heating resistor wire. Multiple linear heating resistor wires are evenly distributed on the rear windshield. During rainy, snowy, or foggy weather, when the driver turns on the defrost/fog control switch, the resistor wires are electrified and heat up, raising the temperature of the glass. The frost or fog attached to the glass melts due to the heat, turning into water droplets that flow down or evaporate as mist, thereby achieving the effect of defrosting and defogging. This allows the driver to clearly discern the traffic conditions behind and perform safe operations such as reversing.
11
0
Share

How to Lock the Fuel Tank Cap of the New Jetta?

To lock the fuel tank cap of the New Jetta, you need to use the car key. The specific steps are as follows: 1. The fuel tank cap of the New Jetta is located on the right rear side. When using it, ensure the vehicle is parked in a safe area; 2. There is a keyhole in the middle of the fuel tank cap with a lock mechanism for inserting the key; 3. Use the mechanical key part of the car key to operate the fuel tank cap. Press the button on the top left to pop out the key; 4. The popped-out key can be directly inserted into the keyhole of the fuel tank cap; 5. After inserting the key, rotate it clockwise to lock the fuel tank cap.
8
0
Share

What is the Break-in Period for a Car?

Car break-in period refers to the initial driving phase of a new car or after a major overhaul. Below is a detailed introduction to the break-in period: The break-in period for a car is generally 1000~1500 kilometers, which is the basic mileage required to ensure full contact, friction, adaptation, and shaping of mechanical components. During this period, the ability of various car parts to adapt to the environment can be adjusted and improved, and protrusions on the parts can be worn off. The quality of the break-in will have a significant impact on the car's lifespan, safety, and fuel efficiency. Although new cars have undergone a break-in before leaving the factory, the surfaces of the parts are still relatively rough. Additionally, there are certain deviations during processing and assembly, as well as some hidden defects that are difficult to detect. Moreover, many metal particles fall off between new parts and accessories. These metal particles not only increase wear between parts but also degrade the quality of the engine oil when they mix with it, affecting lubrication. The frictional resistance of new parts during operation is greater than during normal periods, and fuel consumption is also higher.
8
0
Share

How many kilometers can you drive when the vehicle prompts 'Change Engine Oil'?

When the vehicle prompts 'Change Engine Oil', here is a detailed introduction to the mileage that can be driven under different circumstances: 1. When the vehicle prompts 'Change Engine Oil Immediately', you can still drive approximately 10,000 kilometers. 2. For new cars under normal driving conditions, if synthetic oil is used, the oil can generally be changed every 10,000 kilometers, and some can even extend to 20,000 kilometers. Automotive maintenance professionals consider 'normal driving' to mean frequent highway driving with minimal stop-and-go traffic. 3. Engine oil is to a car what blood is to the human body, with the engine being the heart of the car. During engine operation, piston movement generates friction, and gasoline combustion in the cylinders can raise temperatures inside the engine to as high as 600°C, also producing metal particles and other waste from friction. 4. In such an extreme and harsh operating environment, engine oil plays a crucial role in lubricating, cooling, and cleaning the contaminants generated by engine friction, ensuring normal engine operation and extending the engine's lifespan.
9
2
Share

Is the Volkswagen Tiguan from FAW or SAIC?

The Volkswagen Tiguan belongs to SAIC's SUV models. The Volkswagen Tiguan features sharp and angular exterior lines, ample space, and is equipped with a panoramic sunroof. The trunk has a wide opening, and the interior is relatively conventional, with attention to detail in materials and craftsmanship. It also performs well in terms of fuel consumption, and the overall noise insulation is ideal. Here are some details about it: 1. Interior: The 2019 Tiguan L adopts Volkswagen's latest design language, with a polygonal design for the center console, moving away from the previous boxy and rigid style. The polygonal and multi-layered design highlights the sportiness and technological feel of the new Tiguan L. 2. Powertrain: The Tiguan L's 2.0T + 7-speed dual-clutch powertrain is already well-known and fully adequate for the vehicle's size. The turbo fully engages at around 1500 rpm, providing ample power feedback whether during acceleration or high-speed lane changes and overtaking. High-speed driving is generally maintained in the 80 km/h to 120 km/h range, with the engine and tire noise performance being quite ideal.
3
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.