What is the solution for D-gear stationary resonance?

What is the fuel tank capacity of the Jetta Spring?

The fuel tank capacity of the Jetta Spring is 55 liters. It is a compact car under the FAW-Volkswagen Jetta brand. In the same class of vehicles, the fuel tank capacity of the Nissan Sylphy is 55 liters, and the fuel tank capacity of the Volkswagen Santana is 52 liters. If the owner wants to know the remaining fuel level, they can observe the fuel gauge on the right side of the instrument panel, which is marked with E and F. When the pointer is close to E, it indicates that the fuel is almost empty, and when it is close to F, it indicates that the fuel level is sufficient. The maintenance of the fuel tank is as follows: Drain accumulated water and sediment from the fuel tank, and check for any oil leakage at the fuel pipe joints and switches. For fuel tank caps equipped with air valves and steam valves, also check whether the ventilation holes are clear. The filter screen at the fuel filler inlet should be kept intact to prevent impurities from entering the fuel tank during refueling, which could block the fuel lines. The sealing gasket of the fuel filler cap should also be intact to prevent fuel from overflowing during driving.

11

2

Share

What Causes the Jerking Sensation When Releasing the Accelerator?

Introduction to the causes of jerking sensation when releasing the accelerator in cars: 1. Engine oil passage blockage: The combustion of fuel is determined by the engine's ignition, intake, and fuel injectors, which are also the source of the engine's power. If the intake volume decreases, ignition weakens, or the amount of fuel injected reduces, the power will be insufficient, leading to a jerking sensation. 2. Jerking sensation when starting an automatic transmission car: When wanting to accelerate quickly while driving, you need to press the accelerator deeply. At this time, the automatic transmission will automatically downshift to increase the engine speed. When the speed reaches a certain level, it will upshift. After upshifting, because the speed will drop significantly, a relatively obvious jerking sensation will occur. This situation often occurs in automatic transmission models with fewer gears, such as 4-speed automatic models.

18

3

Share

Do Rear Wheels Have Shock Absorber Top Bushings?

All car rear wheels have shock absorber top bushings. Here are the relevant details: 1. Function of Top Bushings: The top bushing material is rubber plastic, primarily serving as a buffer and shock absorber. A well-maintained top bushing gives the sensation of the car body being lifted slightly after the tires fully land when going over speed bumps, providing excellent comfort. It also reduces direct impact forces on the car when the tires encounter uneven road surfaces. 2. Replacement of Top Bushings: The shock absorber top bushing can be replaced individually. It is necessary to check for deformation, severe wear, and cracks. It is recommended to replace both shock absorbers and top bushings as a pair to achieve balanced support on both sides. Methods to determine if the shock absorber top bushing needs replacement: Without the shock absorber, the spring rebound cannot be controlled, leading to more severe bouncing when driving on rough roads. Additionally, during cornering, the up-and-down oscillation of the springs can cause loss of tire grip and tracking performance.

8

4

Share

What Causes the Gap After Installing the Rear Bumper?

The reasons for the gap after installing the rear bumper are: the hood position is too high; the clips are aging; the bumper has come unclipped. Solutions for the gap in the front bumper: 1. Adjust the lock position: If the front hood is too high due to the lock, you can adjust the lock position on the hood to make it fit more tightly. 2. Replace the clips: There is a set of clips between the front bumper and the car. Check if the clips are tightly fastened or unclipped. If unclipped, you can visit a repair shop to replace the bumper clips. Bumper clips are very affordable, typically costing a few cents to a dollar each.

13

0

Share

How to Solve Weak Car Key Signal?

Generally, there might be two situations. First, it could be due to the car battery being low on power. If the car has no power, no matter how the key senses, it won't help. There are two methods to improve the car key signal: increasing the antenna length and increasing the transmission power. Detailed explanations are as follows: 1. Increasing the antenna length: To increase the antenna length, you need to open the car key. Since the method to open each car model's key is different, it won't be elaborated here. Find the antenna soldering point on the car key's mainboard and solder suitable antenna material. Some copper wires can be used as antenna material. 2. Increasing the transmission power: The most effective way to increase the radiation power is to replace the car's transmission power or write high-power transmission codes into the car key module. Another method is to replace the car key's battery, changing one battery to three batteries to increase the current technically, which also has a good effect.

13

0

Share

Which ring roads are motorcycles prohibited from entering?

Taking Beijing as an example, motorcycles with Jing B license plates are not allowed on roads within the Fourth Ring Road of Beijing. There are clear prohibition signs at the entrances of all overpass intersections along the Fourth Ring Road leading into the area within the Fourth Ring Road. Additionally, motorcycles are prohibited on the main roads of the Second, Third, Fourth, and Fifth Ring Roads. If a motorcycle has a Jing A license plate, be sure not to enter the main roads of the ring roads to avoid violating prohibition signs. Daily maintenance methods for motorcycles: 1. During the break-in period, keep the motorcycle idle at 100 rpm; 2. Match the motorcycle's gear with the speed; 3. When you need to brake due to a situation ahead, release the throttle, step on the brake with your right foot, and gently apply the brake with your right hand; 4. Regularly check the spark plug; 5. When installing a new spark plug, hand-tighten it until it can't be turned anymore, then use a spark plug socket to tighten it an additional quarter to half turn; 6. Regularly lubricate the chain.

3

0

Share

What is the solution for D-gear stationary resonance?

What is the fuel tank capacity of the Jetta Spring?

What Causes the Jerking Sensation When Releasing the Accelerator?

Do Rear Wheels Have Shock Absorber Top Bushings?

What Causes the Gap After Installing the Rear Bumper?

How to Solve Weak Car Key Signal?

Which ring roads are motorcycles prohibited from entering?

What is the fuel consumption of the Cavalier?

What is the difference between Aston Martin DBS and DB11?

Why can't the Kaiyi C3 use 92-octane gasoline?

What are the reasons for the Southeast DX3 not responding when starting?