···
Log in / Register

What is the size of the Xiali N7 wiper?

4 Answers
DeDaniel
07/29/25 7:40pm

The size of the Xiali N7 wiper is 18.18-18.19mm. Wiper size: The wiper sizes for the driver's side and passenger's side of the vehicle are different. Generally, the driver's side is longer, and the passenger's side is shorter. Pay attention to the installation direction when folding. Wiper installation position: Wipers are installed at the bottom of the windshield. For hatchbacks, the rear door and rear windshield are integrated, so placing the wiper on the rear door prevents interference between the two. For sedans, the rear door and rear windshield are not integrated, and opening the rear door causes a misalignment between the rear windshield and the wiper.

Was this review help?
15
5
Share
LaEmilia
08/14/25 2:57pm

I remember when I drove the Xiali N7, the wiper size was usually around 18 inches, depending on the year and model differences. Before replacing the wipers, I suggest you measure the length of your current wiper blades first. Use a soft tape measure to check from the connector to the very end to avoid buying the wrong size and affecting the wiping effect. If your vision is blurry on rainy days, mismatched wipers can leave streaks or fail to clean properly, which is a major safety hazard. From my experience, choosing the right size and a quality brand makes them more durable and cost-effective. Routine maintenance is simple too—check for wear every quarter and clean them with a damp cloth if dirty. This extends their lifespan and ensures safer driving. In short, don’t take it lightly; double-checking the size saves you the most hassle.

Was this review help?
15
2
Share
Expand All
VanLaila
10/15/25 6:41am

For friends who often repair cars, the wiper size for the Xiali N7 is typically 18 inches, but it may vary slightly by half an inch depending on the year. When measuring, ensure you measure from the wiper arm connection point to the rubber end for an accurate reading before placing an order. Installation is straightforward—lift the wiper, remove the old clip, and install the new one, but avoid using excessive force to prevent damaging parts. Incorrect sizing can leave blind spots or scratch the glass, causing major issues during rain or snow. Opt for domestic or OEM brands; no need for expensive options—affordable and practical is the way to go. Make it a habit to replace them every six months, combined with a vehicle condition check, to avoid last-minute issues affecting your trip. Remember, maintaining your wipers well saves money and ensures safety.

Was this review help?
20
2
Share
Expand All
CarmenAnn
11/28/25 7:32am

Dear Chery N7 owners, the wiper size is approximately 18 inches, and corresponding accessories can be easily purchased on Taobao or at auto parts stores. When replacing, simply measure the length of the old wiper to ensure consistency, which helps avoid poor wiping or scratching the windshield. With the right size, driving in the rain becomes much more pleasant, elevating your safety visibility. It's recommended to choose high-quality rubber materials when replacing wipers to extend their lifespan—just a few extra bucks can make a difference. Don't delay; replace them early for enhanced safety.

Was this review help?
3
4
Share
Expand All
More Forum Discussions

What Causes the Abnormal Noise When Starting an Automatic Transmission Car?

Reasons for abnormal noise when starting an automatic transmission car: 1. Engine abnormal noise: Symptom description: There are many possible sources of abnormal noise in the engine compartment. Most people judge it as engine compartment noise based on the sound source, usually characterized by a sharp metallic sound or a wind-like howling noise. Solution: Engine abnormal noise indicates that the technical state of a certain mechanism in the engine has changed. 2. Transmission abnormal noise symptoms: Description: If there is a "rustling" sound inside the transmission while driving, and the abnormal noise disappears when the clutch or accelerator is pressed, and there is a whistle-like sound when shifting gears. Solution: The transmission has many components, and the causes of noise are also complex, so careful analysis and judgment are required.
1
2
Share

What does car accessory mean?

Car accessory refers to the auxiliary mode of a car, generally used in high-end sedans. Its attachments are called ACC power supply, which is a type of power supply used in cars, controlled by the car key, to power certain components of entertainment devices such as car audio. Relevant information about the car auxiliary mode is as follows: 1. Applicable scenarios of car auxiliary mode: When the radio and cigarette lighter are in a powered state: the vehicle requires a strong current during ignition, at which point the accessory (ACC) will automatically stop the power supply and automatically restart the power supply when the vehicle is ignited. 2. The function of car auxiliary mode: In a car, ACC refers to the position before the car is started. If there is a key ACC position, simply turning the key to this position will power some devices that do not require much electricity, such as the radio, cigarette lighter, etc.
13
0
Share

Why Does the Steering Wheel Become Misaligned After Tire Replacement?

Here are the reasons why the steering wheel becomes misaligned after tire replacement: 1. Uneven tire pressure among the four tires. Solution: Inflate the tires to the same pressure. 2. Wheel weight imbalance. Solution: Perform a four-wheel alignment and dynamic balancing. 3. Steering gear malfunction. Solution: Replace the steering gear. The steering wheel is the round device used to control the direction of the vehicle, connected to the steering shaft via a spline. Its function is to convert the force applied by the driver on the edge of the steering wheel into torque, which is then transmitted to the steering shaft. Tires are circular elastic rubber products mounted on various vehicles or machinery, typically installed on metal rims. They support the vehicle body, absorb external shocks, maintain contact with the road surface, and ensure the vehicle's driving performance.
6
0
Share

How Many Keys Does a New Car Generally Come With?

Generally, a new car comes with two keys, which are the primary key and the spare key. Some models have different styles for the primary and spare keys, while others have identical ones. For example, the BMW 5 Series comes with a full LCD key as the primary key, while the spare key only has conventional functions (including trunk unlocking, locking, unlocking, and vehicle locating). Additional information: 1. Reason for providing two keys: Both the primary and spare keys can be used to lock and unlock the vehicle. If one key is accidentally lost, the other can still be used to start the vehicle. 2. Mechanical key: In addition to the primary key, a mechanical key is also provided. The so-called mechanical key is a conventional metal key. When the remote key runs out of battery, you can simply remove the mechanical key from the primary or spare key and insert it into the mechanical lock on the car door to unlock it.
4
3
Share

At What RPM Does Driving Not Harm the Car?

The car's engine should be kept within the economical RPM range. Generally, maintaining the engine speed between 2000 to 3000 RPM while driving will not harm the car. Here are some details about car RPM: 1. RPM Range: The maximum RPM for most family car engines is around 6000 or 6500 RPM. In fact, reaching this RPM occasionally will not cause serious damage to the engine, though it may slightly increase wear. Occasionally pushing the engine to its limit RPM does not harm the engine. 2. Precautions: Avoid running the engine at excessively high RPM immediately after starting, as the engine has not yet reached its normal operating temperature. Running at high RPM during this period can accelerate engine wear. 99% of engine wear occurs during cold starts when the oil has not yet reached all the surfaces that need lubrication, leaving the engine in a state of dry friction.
20
1
Share

Does a sedan need to undergo inspection after 6 years?

A sedan needs to undergo inspection in its 6th year. The 6-year exemption from inspection applies to non-operational sedans and other small and mini passenger vehicles, which are exempt from on-site inspection within the first 6 years. Here are the standards for sedan inspection: 1. Sedans within 6 years. If it's a new car still within the first 6 years, it can be exempt from inspection twice (requiring an inspection mark application every two years without on-site vehicle inspection); in the 6th and 8th years, the vehicle must undergo on-site inspection. 2. Sedans over 10 years old. Follow the original inspection cycle, i.e., once a year for vehicles aged 10 to 15 years, and every six months for vehicles over 15 years old. The vehicle owner can apply for an inspection mark at the vehicle registration office within 3 months before the expiration of the current inspection validity.
2
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.