What is the size of the wiper rubber strip for the Refine M3?

Is it necessary to install cruise control?

From the perspective of the advantages of cruise control, it is necessary to install cruise control. For example, when driving long distances on highways, it can reduce fatigue. However, it is also important to note that cruise control is not truly constant speed. When the vehicle is going downhill, it may still exceed the set speed due to inertia. Therefore, it is best to use cruise control appropriately. Related information is as follows: About cruise control: The cruise control system (CRUISE-CONTROL-SYSTEM), abbreviated as CCS, is also known as a speed control device, speed control system, or autonomous driving system. The function of cruise control: After setting the desired speed by the driver, the vehicle can maintain that speed without the need to press the accelerator pedal, allowing the vehicle to travel at a fixed speed. With this device, when driving on highways for long periods, the driver no longer needs to control the accelerator pedal, reducing fatigue and unnecessary speed changes, which can save fuel.

2

Share

Where are the car airbags installed?

Car airbags are mainly distributed in three directions: the front of the vehicle (driver and front passenger seats), the sides (front and rear rows inside the vehicle), and the roof. Additionally, they are marked with "SRS/AIRBAG" labels on the exterior. Here is more information about car airbags: 1. Theoretically, airbags may deploy only when the vehicle impacts a fixed object within approximately 60 degrees to the left and right of the front center at a speed higher than 30 km/h. However, due to differences in vehicle design, this may vary among different models. For example, the upgraded version of the Santana 2000 will deploy airbags only when the vehicle suffers a severe impact within 30 degrees to the left or right of the front. 2. Airbags are actually a double-edged sword. If the airbags fail to deploy when they should or deploy under normal driving conditions, both scenarios can be fatal. Using inferior, defective, aged, or refurbished airbags can lead to irreversible consequences.

15

2

Share

What type of gasoline should the Borgward BX5 use?

Borgward BX5 uses 92-octane gasoline. The method and basis for gasoline selection are introduced as follows: Gasoline selection method: The difference between 92-octane and 95-octane gasoline is not significant, mainly in the octane rating, which affects the anti-knock performance. The choice should be based on the engine's compression ratio. You can refer to the vehicle's manual, which specifies the engine's compression ratio and the recommended gasoline grade. Basis for gasoline selection: Compact cars generally have engines with moderate requirements, with compression ratios between 8.6 and 9.9. Mid-size cars have engines with compression ratios between 10 and 11.5. For compression ratios exceeding 11.5, higher-octane gasoline may be considered, as these engines are typically found in luxury brand vehicles with strong performance. Engines with compression ratios between 8.6 and 9.8 are suitable for 92-octane gasoline, while those between 10 and 11.5 are suitable for 95-octane gasoline.

13

4

Share

Where is the radiator located on the Baojun 530?

The radiator of the Baojun 530 is located in the engine compartment, on the right side. The radiator is also called the antifreeze tank. What is actually filled in the car radiator is not water, but antifreeze. The coolant filled in the radiator is also a mixture of antifreeze concentrate and water in a certain standard ratio. The following is a related introduction to antifreeze: 1. The full name of antifreeze should be antifreeze coolant, meaning coolant with antifreeze function. Antifreeze can prevent the coolant from freezing and cracking the radiator or freezing the engine cylinder block or cover when parking in cold winter. 2. In addition to antifreeze, antifreeze also has anti-corrosion function. The engine and its cooling system are made of metal, including copper, iron, aluminum, steel and solder. These metals will be corroded and rusted after long-term contact with water at high temperatures. Antifreeze will not only not cause corrosion to the engine cooling system, but also has anti-corrosion and rust removal functions.

12

4

Share

What is the problem when the starter smokes?

The reasons for the starter smoking include battery short circuit, circuit aging, and separator damage. Here are the detailed explanations: Battery short circuit: It is most likely caused by poor quality or damage to the separator, allowing the active material of the electrode plates to pass through. If the separator is of poor quality, impurities will form when ions pass through it, leading to a short circuit between the two electrode plates. Due to the large short-circuit current, the separator will be scorched, causing further damage. The more severe the short circuit between the two plates, the greater the short-circuit current, creating a vicious cycle. Eventually, smoke will be emitted from the battery's vent hole, resulting in the phenomenon of the battery smoking. Additionally, conductive objects falling into the battery can also cause a connection between the positive and negative terminals, leading to a short circuit. Circuit aging: Smoking can also be caused by circuit aging. Most cases are due to the battery reaching the end of its lifespan. Separator damage: Separator damage is mostly caused by sparking between the electrode plates.

8

2

Share

What are the reasons why the five major assemblies cannot be sold?

Selling or buying the five major assemblies of used cars is illegal. According to the national "Regulations on the Recycling of Scrapped Automobiles", the engine assembly, steering gear assembly, transmission assembly, front and rear axles, and frame removed from scrapped vehicles cannot be bought or sold. In addition to the five major assemblies, purchased used parts should be carefully inspected by the installer. If the used parts have minor damage, deformation, or are not as good as the original parts, it is best to return or replace them immediately. The functions of the five major automobile assemblies: Engine: Converts petroleum fuels such as gasoline or diesel into rotational torque. Transmission: Uses neutral gear to interrupt power transmission, allowing the engine to start, idle, and facilitating gear shifting or power output. Front axle: Transmits the engine power, after being reduced in speed and increased in torque by the clutch and transmission, to the final power output—the wheels—through the front drive axle assembly. Rear axle: The rear axle is merely a follower axle, serving only a load-bearing function. Frame: The frame should be arranged close to the ground to lower the vehicle's center of gravity, thereby improving driving stability.

7

4

Share

What is the size of the wiper rubber strip for the Refine M3?

Is it necessary to install cruise control?

Where are the car airbags installed?

What type of gasoline should the Borgward BX5 use?

Where is the radiator located on the Baojun 530?

What is the problem when the starter smokes?

What are the reasons why the five major assemblies cannot be sold?

Can a Temporary License Plate Be Used Out of Province?

What does the iS-Top green light mean?

How to deal with 10% speeding while driving a motor vehicle?

What Causes Engine Control System Failure?