What is the size of the Tuano wiper?

2 Answers
BethanyAnn
07/29/25 5:32am
Tuano wiper size is 400mm. Wiper: It is a tool on the front glass of motor vehicles to prevent rain and other dirt from affecting the driver's vision. There are roughly two types of wipers: one is the traditional intermittent type, which is the most common wiper, with three to four segments, adjusted by the driver according to the rain and visibility conditions; the other is the rain-sensing type, mostly used in mid-to-high-end models. Tuano: Developed by the Stuttgart R&D Center in Germany. Tuano has chosen the strict international evaluation and certification system of German TUV Rheinland. In terms of load capacity, braking system, suspension system, transmission system, handling performance, and NVH optimization, Tuano meets German design standards and has obtained certification.
Was this review help?
20
2
Share
MacCody
08/12/25 9:06am
When I drove the Tuyaano before, I specifically measured the wiper sizes. The driver's side is 24 inches, and the passenger side is 18 inches. These sizes are quite standard, similar to the specs of the older Transit models. However, I should mention that there might be slight variations between different model years—my neighbor's car was off by half an inch compared to mine. When replacing wiper blades, it's best to measure them yourself first. Lift the wiper arm and measure from the connection point to the outermost tip of the rubber blade. Choosing new wipers isn’t just about size; the rubber material matters too—graphite-coated blades glide especially quietly. If you’re doing the replacement yourself, remember to clear out any debris like twigs or leaves from the old blade slot. Last time, I had a leaf stuck in there, and it made a terrible squeaking noise on the windshield.
Was this review help?
4
3
Share
Expand All
More Forum Discussions

What are the driving tips for turbocharged cars?

There are three main driving tips for turbocharged cars: 1. When a turbocharged car is just started, the engine oil temperature is low, and the turbocharger cannot be fully lubricated. At this time, do not press the accelerator pedal sharply. Let the engine idle for about three minutes first, which can quickly increase the oil temperature and improve its fluidity, thereby ensuring full lubrication of the turbocharger. Only then can the engine speed be increased to start driving. 2. Before turning off the car, let the engine idle for about three minutes (idle for about three minutes), mainly to allow the turbo to cool down. When the engine is running, part of the engine oil is used to lubricate and cool the turbocharger rotor bearings. If the running engine is suddenly shut down, the oil pressure will quickly drop to zero, interrupting oil lubrication. The heat inside the turbocharger cannot be carried away by the oil, and the high temperature of the turbo part will transfer to the center. The heat in the bearing support housing cannot be quickly dissipated, while the turbocharger rotor is still rotating at high speed due to inertia. This can cause the turbocharger shaft and bushing to "seize" and damage the bearings and shaft. 3. For daily oil use, strictly follow the model specified in the user manual. It is recommended that car owners invest more in this aspect and switch to fully synthetic oil for their vehicles. This type of oil has excellent oxidation resistance, wear resistance, high-temperature resistance, and provides better lubrication and heat dissipation.
13
1
Share

What is the standard tire pressure for the Lavida sedan?

The normal tire pressure for the Volkswagen Lavida is 2.4-2.5 bar. Due to seasonal factors, the tire pressure can be appropriately increased by 0.2 bar in winter and reduced by 0.1 bar in summer. The Volkswagen Lavida's tire pressure monitoring system is displayed on the dashboard and is enabled by default. When the tire pressure is abnormal, the tire pressure warning light will illuminate to alert the driver. There is no physical button for the tire pressure monitoring system in the vehicle. If the tire pressure monitoring indicator light comes on (a yellow symbol with an irregular circle, no stamp on top, four small spikes at the bottom, and an exclamation mark inside), there are generally three possible reasons: 1. Abnormal tire pressure. The system typically alerts when the pressure is below 1.8 bar or above 3.0 bar. In this case, the tires need to be checked and the pressure adjusted. 2. The tire pressure monitoring system has not been reset. After inflating the tires, if the tire pressure is not reset in time, the system will still record the previous data, causing the tire pressure monitoring indicator to light up. Simply reset the tire pressure to resolve this issue. 3. The tire pressure sensor is damaged. The tire pressure sensor, which is used to monitor tire pressure, is installed directly inside the tire and connected to the tire inflation valve. If the sensor is damaged due to impact while driving, the tire pressure warning light will also illuminate. In case of sensor damage, the only solution is to replace it with a new one.
4
0
Share

Why does the steering wheel shake left and right on bumpy roads?

When driving on bumpy roads, it is normal for the steering wheel to sway left and right. Here is the relevant information: 1. The steering wheel sways left and right on bumpy roads because the uneven road surface reacts on the tires, which then transmits through the wheel hub, steering axle, steering linkage, power assist mechanism, steering column, and other steering components, causing slight rotation or vibration of the steering wheel. 2. Due to extreme road undulations, the steering wheel will sway left and right along with the tire movement. The safest way is to hold the steering wheel with your fingers following its direction. Avoid placing your fingers on the inner side of the steering wheel or gripping it inversely to prevent injury to your fingers or wrists.
4
0
Share

Reasons for Slow Throttle Response in Edge?

Slow throttle response in the Edge may be due to issues with the car's intake system. If there are leaks or blockages in the intake system, the vehicle may experience reduced power and difficulty in increasing RPM when accelerating. Another possible cause is incomplete fuel combustion. Using low-quality gasoline can damage the fuel pump, directly affecting engine performance. Below is an introduction to slow throttle response in cars: 1. Turbocharged cars may exhibit sluggish throttle response, primarily due to turbo lag. Turbocharged engines require reaching a certain RPM before power increases. If a naturally aspirated engine shows slow throttle response, the issue might lie with the intake system. 2. Blockages in the engine's intake or exhaust systems can lead to abnormal engine operation. Reduced air intake lowers oxygen content in the engine, affecting performance. Slow throttle response can also be related to fuel quality. Using substandard fuel can cause incomplete combustion, leading to carbon buildup and reduced fuel efficiency, ultimately failing to provide sufficient power. 3. Ignition system issues are less likely to stem from ignition wires but rather from the ignition coils and spark plugs, which are wear-prone components. Degraded spark plug performance or the use of inferior spark plugs can result in slow throttle response, weak acceleration, and acceleration shudder.
3
3
Share

How to Use the Remote Start Feature on the Honda Avancier?

Honda Avancier models all support the remote start function, which can be enabled or disabled in the central multimedia information system. By default, the system is set to enable this feature. The remote start operation for the Avancier is very convenient and can be performed using the remote key. The specific steps are: first press the lock button, then press the button marked with a circular arrow to start the engine. Below is an introduction to the Honda Avancier's remote start feature: 1. The settings for the Honda Avancier's remote start are located in the multimedia information screen. Select 'Vehicle', then 'Smart Key System Settings', and choose to enable or disable the remote start system. 2. When using remote start on the Avancier, the exterior lights will flash as a prompt, and the engine will idle for 10 minutes. If the brake pedal is not pressed and the ignition switch is not activated within this time, the engine will shut off. Performing the remote start operation again within the 10-minute window can extend the idle time by another 10 minutes, with the exterior lights flashing 6 times as a confirmation of successful extension. 3. In addition to starting the engine and allowing it to idle, the remote start also activates the air conditioning and heating system, seat heaters, and windshield defogging function, making it particularly useful during cold seasons.
12
5
Share

Where to Buy the Leapmotor S01?

The Leapmotor S01 can be purchased by logging into the official Leapmotor website. Simply search for the official Leapmotor website using a search engine, and you can enter the site to purchase the vehicle. The Leapmotor S01 is a domestically produced pure electric vehicle, featuring a three-door, two-seat hatchback design. Below is an introduction to the Leapmotor S01: 1. The Leapmotor S01 is a domestically produced pure electric vehicle with a three-door, two-seat hatchback design. It measures 4075 mm in length, 1760 mm in width, and 1380 mm in height. 2. This vehicle is equipped with an electric motor that delivers a maximum power of 125 kW and a maximum torque of 250 Nm. It uses a ternary lithium battery. The MIIT-rated range for the base model is 300 km, while the high-end model offers a range of 380 km. 3. The base version of this vehicle's battery has an energy capacity of 36 kWh, while the high-end version features a 48 kWh battery. 4. The Leapmotor S01 uses a MacPherson independent suspension at the front and a torsion beam non-independent suspension at the rear.
20
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.