···
Log in / Register

What is the situation when there is water under the driver's seat?

1 Answers
Johnny
07/29/25 11:45pm

The reasons for water under the driver's seat are as follows: 1. Sunroof leakage due to poor sealing, check the sunroof. 2. Water from car washing that was not cleaned properly. 3. Corrosion and leakage of the interior heater core. Extended content handling methods: 1. Go to a car cleaning shop, remove the floor mats, and use a vacuum cleaner to remove most of the water. 2. Whether it's loop mats, leather mats, rubber mats, or full TPE mats, use dry towels alternately under the mats to absorb water until they are clean. Otherwise, they may smell or mold, affecting driving. 3. Use high-pressure air at a repair shop to blow through the pipes to clear them.

Was this review help?
7
0
Share
More Forum Discussions

What is the difference between 125cc and 150cc motorcycles?

The differences between 125cc and 150cc motorcycles lie in their displacement and power. The distinctions between 125cc and 150cc motorcycles are as follows: 1. Different displacement: When it comes to displacement, it's obvious that 150cc means a displacement of 150, while 125cc means a displacement of 125. Clearly, the displacement of 150cc is larger than that of 125cc, which naturally leads to an increase in power and greater energy output. 2. Different power: When comparing the performance of motorcycles, just like with cars, higher power means higher rotational speed. An increase in rotational speed also accelerates the internal rotation of the engine, thereby enhancing the power output. This logic applies equally to motorcycles. It's evident that, in addition to the aforementioned displacement, power also affects the performance of a motorcycle. Obviously, the power of a 150cc motorcycle is greater than that of a 125cc motorcycle.
17
3
Share

What are the consequences of leaving car headlights on overnight?

The consequence of leaving car headlights on overnight is that it will cause the car battery to be in a state of insufficient charge, thereby affecting the battery's lifespan, and may also result in the inability to start the engine. When parking at night, the car is usually in an off state, and in this situation, the generator cannot continuously supply power to the battery. Leaving the headlights on all night will drain the battery's power. When parking, it is important to check whether the car lights are turned off in time to avoid completely depleting the car battery. Headlights are installed on both sides of the front of the car and are used for illuminating the road during nighttime driving. They can be either two-light or four-light systems. The lighting effect of the headlights directly affects nighttime driving operations and traffic safety.
9
1
Share

How to Handle When the Car Displays kpa?

When the car displays kpa, the solution is to check the tire pressure. If the tire pressure is insufficient, use an onboard air pump to inflate the tires. If the tire pressure is too high, release some air. kpa is a unit of pressure, and when the car displays it, it indicates that the tire pressure may be uneven. Both overinflation and underinflation can shorten the lifespan of the tires. Low pressure increases tire deformation, leading to cracks on the sidewalls and enlarging the contact area, which accelerates shoulder wear. High pressure causes excessive stretching of the tire cords, reducing elasticity and increasing the load on the car while driving.
11
5
Share

What is the cause of the ticking noise in the BMW N20 engine?

The ticking noise in the BMW N20 engine is caused by the vibration of the high-pressure fuel injectors. This sound is not affected by the engine's temperature state and is always present. This engine produces relatively loud noise during cold starts, somewhat similar to the noise generated by diesel engines. This ticking noise is a common issue with this engine and is considered normal. Additional Information: 1. BMW N20 Engine System: The BMW N20 engine uses a direct injection system. The pressure generated during fuel injection in BMW engines is quite high, allowing the fuel in the engine to burn more completely and increasing power output. However, this can result in noise under low-speed conditions. 2. BMW N20 Engine Technology: The N20's most notable feature is its Twin-Scroll Single Turbocharger technology. Compared to other turbocharged engines, this engine has two turbo scrolls that separately guide exhaust gases from the engine cylinders into the turbo, making the turbo response more agile. The overall performance of this engine makes the ticking noise negligible in light of its advantages.
17
0
Share

How to Use the Rearview Mirror Heating on the Tiggo 8 Plus

The rearview mirror adjustment switch is located on the left side of the driver's instrument panel. Move the adjustment switch to the left to adjust the left exterior rearview mirror. Move the adjustment switch to the right to adjust the right exterior rearview mirror. The adjustment direction is consistent with the arrow direction.
9
4
Share

What are the steps for reversing into a parking space with a manual transmission?

Enter the area from the left side, keeping a distance of 30 cm between the edge of the car window and the left line of the lane, and strive to keep the car body parallel to the lane line. After pressing the right control line, stop, turn on the right turn signal, and slowly reverse. Estimate when the control line is reached.
20
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.