What is the situation when the rear charging port of Jetour X90 has no power?

What to Do If the Car Stalls When Starting?

When starting, be sure to slowly release the foot brake to allow the car to move forward gradually, which can generally prevent stalling. Here are specific techniques for starting a car: 1. While pressing the accelerator and slowly releasing the clutch, carefully listen to the sound of the engine. During clutch release, there are three distinct sounds: 'high-pitched,' 'steady,' and 'low-pitched.' The 'high-pitched' sound indicates a free travel distance of the clutch; during 'steady' and 'low-pitched' sounds, the speed of releasing the clutch must be slowed down. 2. For starting on flat roads or downhill, you can first release the handbrake, then press the accelerator and release the clutch. For uphill starts, the handbrake should only be released when the engine sound changes to 'steady,' otherwise, the car may roll backward. 3. On flat roads or downhill, a slight press on the accelerator is sufficient to start the car. For uphill starts, the amount of accelerator pressure depends on the steepness of the slope—the steeper the slope, the more pressure is needed. 4. At the moment of releasing the handbrake, momentarily hold the clutch (do not release it further) and apply more accelerator to prevent the car from shaking or becoming unstable. 5. If the car stalls during a downhill start and the slope is steep, you can directly shift to third gear without starting the engine, then release the brake to start. The car can automatically start as the wheel speed increases.

14

2

Share

What are the contents of Subject 3 in driving test?

Subject 3 consists of 16 items, including: preparation before starting, starting, driving in a straight line, shifting gears, changing lanes, going straight through intersections, passing pedestrian crossings, passing bus stops, passing school zones, turning left at intersections, turning right at intersections, meeting oncoming vehicles, overtaking, making U-turns, pulling over, and driving at night. Precautions during the Subject 3 test are as follows: 1. Before starting, after confirming identity information, walk around the vehicle to observe the vehicle condition and surrounding traffic. After getting in the car, adjust the left and right rearview mirrors, seat, and fasten the seat belt. 2. When starting, turn on the left turn signal, press the clutch and brake properly, and start smoothly in first gear. Shift gears according to the speed. When driving straight, pay attention to the front, keep driving between the two marked lines, and avoid holding the steering wheel too tightly. If the vehicle deviates, slightly adjust the steering wheel and observe the rearview mirror briefly from time to time. 3. Before changing lanes, turn on the turn signal five seconds in advance, observe the road conditions through the rearview mirror, and look back to confirm safety before changing lanes. Before overtaking, turn on the turn signal five seconds in advance, observe the rear and left road conditions through the rearview mirror, and look back to confirm safety. After completing the overtaking and returning to the original lane, observe the rear and right road conditions and look back to confirm safety.

16

4

Share

What are the features of the 10-speed transmission in the 2020 RAV4?

2020 RAV4 is equipped with a 10-speed CVT continuously variable transmission. The features of the 10-speed CVT are as follows: Good fuel economy: CVT can achieve stepless speed change within a fairly wide range, obtaining the best match between the transmission system and engine conditions. By relying on the transmission's stepless speed regulation to adapt to various vehicle speeds, the engine can operate under optimal conditions for a long time, thereby improving combustion efficiency and correspondingly enhancing fuel economy. Excellent power performance: CVT can achieve closed-loop control with the engine, fully utilizing the engine's maximum torque. Its performance in deceleration and torque increase is significantly better than MT and AT. The characteristics of CVT make its power performance notably superior to manual and automatic transmissions. Superior comfort: CVT can improve driving comfort. With no gears, the shifting process is continuous and linear, providing smooth acceleration without gear shift shocks. There is no downshift jerking phenomenon like in AT during rapid acceleration. The CVT system has a wide transmission ratio range, generally between 2.400-0.395, resulting in low engine speed and reduced noise during high-speed driving, allowing drivers and passengers to enjoy a quiet and relaxed comfortable feeling during the journey.

4

Share

What are the precautions after applying film to a new car?

Here are the precautions after applying film to a new car: 1. Do not roll down the windows: After applying the car film, the film has not fully adhered to the car glass, so avoid rolling down the windows within three days. 2. Do not wash the car: Avoid washing the car within three days and do not wipe the film with hard objects. 3. Water bubble phenomenon: On the second day after applying the film, water mist and bubbles usually appear, which is normal. The moisture will evaporate after exposure to sunlight. 4. Applying film in winter: If the film is applied in winter, do not roll down the windows or wash the car within a week. In winter, moisture evaporates more slowly, and the front and rear windows may take a month to dry completely. The rear window heating wires should not be turned on within a month.

16

1

Share

What Causes the Mazda6 to Shake at Idle?

Mazda6 idle shaking causes are as follows: 1. Severe engine carbon buildup: The most common cause of car shaking is a dirty throttle body or excessive carbon deposits on the fuel injectors. When there is too much carbon buildup inside the engine, the gasoline sprayed by the cold-start injector is largely absorbed by the carbon deposits, resulting in an overly lean air-fuel mixture during cold starts, making it difficult to start. After starting, the gasoline adsorbed on the carbon deposits is drawn into the cylinders by the engine's vacuum suction force and burned, making the mixture too rich. The engine's combustible mixture alternates between lean and rich, causing idle shaking after a cold start. 2. Ignition system issues: Check the condition of the spark plugs, high-voltage wires, and ignition coils. Poor performance of the ignition system or faulty spark plug firing can also lead to such symptoms. The solution is to check if the spark plugs have excessive carbon buildup and replace them if necessary. 3. Unstable fuel pressure: If you have already cleaned the engine carbon deposits, throttle body, replaced the oil gasket and spark plugs, but still notice shaking at idle, it is recommended to visit a 4S shop to check the fuel supply pressure and the intake pressure sensor for normal operation. 4. Aging engine components: Car shaking can also be related to worn engine mounts. Engine mounts are part of the engine's vibration damping system, responsible for absorbing minor vibrations during engine operation. If the engine mounts are faulty, these vibrations will be transmitted to the steering wheel and the cabin, causing shaking at idle.

3

4

Share

Can I directly apply for a Class A3 driver's license?

You can either directly apply for a Class A3 driver's license or obtain it through license upgrading. Here is more information about driver's licenses: 1. Introduction: A driver's license (full name: motor vehicle driver's license), also known as a "driving license," is a document issued by the government transportation department to individuals who meet the driving qualifications, usually in the form of a card. 2. Requirements for holding: To obtain a driver's license, you need to meet the minimum age requirement and pass the driving test. The driver's license usually specifies the types of motor vehicles the holder is allowed to drive. 3. Legal basis: "Regulations on the Application and Use of Motor Vehicle Driver's Licenses." 4. Examination subjects: The examination includes four subjects: traffic laws and related knowledge, field driving, road driving (including safe and civilized driving), etc.

3

5

Share

What is the situation when the rear charging port of Jetour X90 has no power?

What to Do If the Car Stalls When Starting?

What are the contents of Subject 3 in driving test?

What are the features of the 10-speed transmission in the 2020 RAV4?

What are the precautions after applying film to a new car?

What Causes the Mazda6 to Shake at Idle?

Can I directly apply for a Class A3 driver's license?

What are Type B and Type C RVs?

Can You Turn Right on a Straight Red Arrow?

What is the purpose of a vehicle certificate of conformity?

Can the car emblem be repainted?