What is the safety factor for vehicle slope descent?

1 Answers
StKinsley
07/29/25 2:18pm
Safety factor for vehicle slope descent: Generally, it ranges from 1.1 to 1.25, while for more critical slopes, it is between 1.25 and 1.35. Parking position on slopes: Before parking, carefully observe the intended parking spot, turn on the indicator lights, slowly approach the parking space, avoid excessive speed, and pay attention to the surroundings to prevent collisions with people or other vehicles. Parking slope gradient: If the parking spot has a steep slope, after exiting the vehicle, find a sufficiently large stone or brick to place under the wheel to prevent rolling. When placing the stone or brick, position it behind the wheel when on an uphill slope and in front of the wheel when on a downhill slope.
Was this review help?
6
5
Share
More Forum Discussions

What is the tire model of the Buick Envision?

Buick Envision uses Bridgestone DUELER HL400 series tires, with front and rear tire specifications of 225/65R17. Tires are circular elastic rubber products assembled on various vehicles or machinery to roll on the ground. Tires are often used under complex and harsh conditions, enduring various deformations, loads, forces, and high and low temperature effects during driving. Therefore, they must have high load-bearing performance, traction performance, and cushioning performance. The Buick Envision is positioned as a midsize SUV, with body dimensions of 4667mm in length, 1839mm in width, and 1696mm in height.
18
5
Share

How to Replace the Battery in a Vezel Car Key?

The method to replace the battery in a Vezel car key is: 1. Locate the small switch on the car key and flip it; 2. Pull out the metal mechanical key; 3. Use the extracted mechanical key to pry open the car key cover, separating it; 4. After opening the car key cover, the key splits into two halves, with the battery housed in one of them; 5. Remove the old battery and insert the new one; 6. Reattach the key cover. The Vezel is GAC Honda's first SUV, with exterior dimensions of 4294mm in length, 1772mm in width, and 1605mm in height. It is equipped with a 1.8L i-VTEC naturally aspirated four-cylinder engine.
11
2
Share

Can a car be repainted?

Vehicles can be repainted, but within ten days after the color change, you must bring the "Motor Vehicle Change Registration/Record Application Form", the original and copy of the vehicle owner's identity proof, the original "Motor Vehicle Registration Certificate", the original "Motor Vehicle Driving License", and other required documents to the vehicle management office to complete the change registration. Before repainting, consult the vehicle management office to confirm whether the chosen color is permitted for change. Only after receiving a positive response should you proceed with repainting the vehicle, and then schedule an appointment to complete the change registration procedures. Below are some precautions regarding vehicle repainting: 1. The body color must not be identical or similar to that of special-purpose vehicles; 2. Vinyl wrapping for color change must not exceed one-third of the vehicle's surface area; 3. The body color must not exceed three different colors.
3
5
Share

What is the difference between Castrol Magnatec and Edge?

Here is the introduction to the differences between Castrol Magnatec and Edge: 1. Different base oils. The base oil of Magnatec is made from Group III oil through hydrogenation treatment; the base oil of Edge 0w series is 100% Group IV, and the base oil of 5w series is a mixture of Group IV and Group III hydrocracking. 2. Different synthetic categories. Magnatec is semi-synthetic, while Edge is fully synthetic. 3. Different engines. Edge provides comprehensive protection for the engine, with API/viscosity of SN/0W-40, SN/5W-40, SN/5W-30, and SN/10W-60; Magnatec protects the engine during cold starts/frequent start-stop conditions, with API/viscosity of SN/5W-40.
18
0
Share

What to Do About Brake Caliper Noise?

Caliper noise is most likely caused by a loose brake caliper. This happens when the brake caliper fixing pin is much smaller in diameter than its sheath, creating excessive clearance between them, which results in a clanking sound when shaken. Here are the solutions for brake caliper noise: 1. Use sturdy zip ties to secure the caliper, but ensure the tightness is moderate—neither too loose nor too tight—otherwise, the noise issue won't be effectively resolved. 2. Apply grease to the fixing pin to increase its overall diameter, thereby reducing the gap between the pin and its sheath. 3. Replace the fixing pin with a new one. Before purchasing, be sure to measure the dimensions with a vernier caliper to ensure the clearance data matches.
10
1
Share

How to Use the Honda Vezel Handbrake?

To use the Honda Vezel handbrake, simply lift or press the lever. The Honda Vezel is a compact SUV under GAC Honda, with exterior dimensions of 4328mm in length, 1772mm in width, and 1605mm in height, and a wheelbase of 2610mm. It features a 5-door, 5-seat SUV body structure. The Vezel is equipped with a 1.5L 131-horsepower L4 engine, paired with a 6-speed manual transmission, delivering a maximum power of 96 kW and a maximum torque of 155 Nm. It comes with a front MacPherson strut independent suspension and a rear torsion beam suspension, with a front-wheel drive system.
3
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.