What is the RPM of the Geely Xingrui at 120 km/h?

1 Answers
DelPeter
07/30/25 3:34am
Geely Xingrui's RPM at 120 km/h is 2000-2200. Introduction to RPM: Rotational Speed (or Rev) refers to the number of revolutions an object moving in a circular path makes around the center of the circle per unit time (different from frequency). Common types of rotational speed include rated speed and maximum speed. Rated Speed: Rated speed refers to the maximum rotational speed under rated power conditions. It is usually marked on the prominent part of the product as a main parameter when leaving the factory. Maximum Speed: Maximum speed is the highest rotational speed that can be achieved under specific conditions. For example, the spindle speed of a hard disk drive motor, which is the maximum speed the hard disk platter can reach under normal operating voltage conditions.
Was this review help?
4
3
Share
More Forum Discussions

What is a DTC fault?

Here is the relevant introduction about DTC faults: 1. Introduction to DTC: The full name of DTC is "Diagnostic-Trouble-Code", which means diagnostic trouble code. Nowadays, many car faults are diagnosed through fault codes, such as chassis detection, body and accessory detection, vehicle pollutants and noise treatment component detection, etc. The purpose is to identify the location and cause of car faults without dismantling the vehicle. 2. Solution: DTC is the abbreviation of fault diagnostic code. Faults related to the chassis, body, pollutants, noise, and other accessories are presented through this code, and it does not specifically indicate a fault in one particular place. Therefore, if a DTC fault code appears and you are not very familiar with cars, you should go to a repair shop to read and detect it with professional tools.
7
2
Share

What to Do When the Road Is Not Divided into Motor Vehicle Lanes and Non-Motor Vehicle Lanes?

On roads not divided into motor vehicle lanes and non-motor vehicle lanes, motor vehicles should travel in the middle of the road, while non-motor vehicles and pedestrians should travel on both sides of the road. Such legal provisions not only help improve traffic flow speed but also protect non-motor vehicles and pedestrians, objectively preventing traffic accidents. Below is additional information: 1. According to Article 35 of the "Road Traffic Safety Law of the People's Republic of China," motor vehicles and non-motor vehicles shall drive on the right side. 2. Article 36 stipulates that based on road conditions and traffic needs, roads shall be divided into motor vehicle lanes, non-motor vehicle lanes, and sidewalks. Motor vehicles, non-motor vehicles, and pedestrians shall travel in their respective lanes. If the road is not divided into motor vehicle lanes, non-motor vehicle lanes, and sidewalks, motor vehicles shall travel in the middle of the road, while non-motor vehicles and pedestrians shall travel on both sides. 3. Article 37 states that on roads with designated special lanes, only specified vehicles are allowed to travel within those lanes, and other vehicles shall not enter them.
4
4
Share

What does AC/ECO mean?

The following is the relevant introduction about AC/ECO: 1. AC: AC is the compressor switch of the car air conditioner, which is the cooling switch. To turn on the air conditioner for cooling in summer, you need to turn on the AC switch. The car air conditioner refers to the air conditioning device installed in the car, which can cool, heat, ventilate, and purify the air in the compartment, providing a comfortable riding environment for passengers, reducing the driver's fatigue, and improving driving safety. 2. ECO: ECO is the economy mode of automatic transmission cars. The ECO mode is derived from the synthesis of ecology, energy saving, and optimization. The main principle is: during the vehicle's movement, it comprehensively judges and analyzes conditions that affect fuel consumption, such as automatic transmission gear, engine speed, vehicle speed, braking, and transmission oil temperature. The ECU control unit calculates the optimal fuel amount to provide to the engine for work, effectively reducing fuel consumption compared to the normal driving mode.
20
4
Share

What are the hidden features of the Soueast V3 Lingyue?

Soueast V3 Lingyue hidden features include remote unlocking, trunk switch, sensitivity adjustment, speedometer, and fuel gauge light. Here are the details: 1. Speedometer: National regulations stipulate that the speedometer's indication must not be lower than the actual vehicle speed, and most models' speedometers show a speed about 10 km/h higher than the actual speed. 2. Fuel gauge light: After the fuel gauge light comes on, the car can still travel more than 20 kilometers. Beyond this range, other preparatory measures should be taken. 3. Configuration: The V3 Lingyue is equipped with four-wheel disc brakes, with front and rear brakes both being disc-type, paired with ABS+EBD, 2SRS, and four-door power windows.
19
2
Share

What does it mean when the ignition switch is in the ON position?

The ignition switch in the ON position means that all basic equipment except the starter is operating normally. If the key is also in the ON position, all components of the vehicle are powered, including the engine system. The dashboard lights will illuminate, and the fuel pump will begin to build up oil pressure. After approximately 5 to 10 seconds, the fuel pump will have fully built up oil pressure, and the dashboard needles will return to their original positions. Finally, pressing the start switch will start the vehicle. Meanings of other positions of the ignition switch: LOCK is for locking the car. Generally, when the key is in this position, the steering wheel is locked and cannot be moved significantly. ACC provides power to the entire vehicle, allowing the radio, lights, etc., to function normally, but the air conditioning cannot be used. The control process of the car's ignition switch: When the ignition switch is in the "OFF" position, turning the key to the "OFF" (off) position connects the two internal contact points in the horizontal position, which means the external wires "black-white wire" and "green wire" are connected. If you measure the two wires with an ohmmeter (Ω), they should be in a conductive state. In the actual vehicle, the connection of these two wires indicates that the entire circuit system stops working, the ignition system circuit is in a short-circuit state, and the engine is turned off.
17
1
Share

Is it okay to use the sunroof tilt function on rainy days?

No, this will allow water to enter. The uses of a car sunroof: 1. Change the traditional ventilation method: The car sunroof changes the traditional form of ventilation. Wind blows in to form an airflow that draws out the stale air inside the cabin. 2. Quickly remove fog inside the car: Using the sunroof to defog is a quick method of defogging. Especially in summer and autumn when there is more rain and higher humidity. 3. Rapid cooling to save energy: Using the sunroof also has energy-saving benefits. In the hot summer, a car left in the sun for an hour can easily reach an internal temperature of around 70°C. If you have a car with a sunroof, simply opening it can cool the car 2-3 times faster than using the air conditioning, and it also saves gasoline. 4. During traffic jams: In traffic jams, all vehicles are either stationary or moving slowly, and car exhaust inevitably becomes more concentrated than at any other time. Opening the sunroof and closing all side windows at this time can prevent exhaust fumes from entering the cabin. The negative pressure ventilation of the sunroof will expel the stale air from the car, preventing polluted air from entering the cabin. 5. Refreshing: Have you ever noticed while driving on the highway that once the car heater has been on for too long, it's easy to feel drowsy? If you open the side windows, you'll be bothered by the noise and crosswinds from the open windows.
19
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.