What is the remote control pairing method for the Besturn X80?
3 Answers
The remote control pairing method for the Besturn X80: 1. Open the left front door and ensure all other doors are closed; 2. Insert the key and turn to ON, then switch between ACC and ON, repeating this 4 times; 3. Close and open the left front door 6 times, finally ensuring it is closed again; 4. Press the unlock button on the remote control to complete the pairing. The Besturn X80 is a compact SUV under FAW Besturn, with body dimensions of 4586mm in length, 1820mm in width, and 1695mm in height, and a wheelbase of 2675mm. The front suspension of the Besturn X80 is a MacPherson independent suspension, while the rear suspension is a torsion beam non-independent suspension. It is equipped with a 1.8L turbocharged engine, delivering a maximum horsepower of 186, a maximum power of 137 kW, and a maximum torque of 235 Nm, paired with a 6-speed automatic transmission.
I've previously helped someone with the remote matching for the Besturn X80, and the process was quite straightforward. First, get in the car, close the door, and lock it, ensuring the vehicle is not in operation. Insert the original car key into the ignition cylinder without starting the engine, then quickly turn the key to the ACC position about five times, with each turn taking less than a second, finally stopping at the ON position. Wait until you hear a short 'beep' sound, then immediately press and hold the unlock button on the new remote without releasing until the car lights flash twice or you hear the completion prompt. This completes the matching. If multiple remotes need to be matched, they must be done one by one. Before matching, check if the remote's battery is newly replaced, as insufficient power can affect the operation. The environment should ideally be quiet and free from interference sources like WiFi routers. When using the remote, be careful not to drop it in water or expose it to high temperatures, and regularly checking its functionality can prevent unexpected failures.
I've taken several long trips with my Besturn X80, and programming the remote isn't difficult but requires attention to detail. Before getting in the car, make sure all doors are properly closed. Sit in the driver's seat and insert the key. Quickly turn the switch to the ACC position three or four times (no more than five), then leave it in the ON position. When you hear the prompt tone, press and hold the unlock button on the new remote firmly until you see the vehicle's feedback with flashing lights. If programming multiple remotes, repeat this step for each one. Don't forget to test the actual lock/unlock functionality after programming to ensure responsiveness and avoid mid-trip failures. Here's a tip: replace the key battery annually to save money and hassle. Also, avoid fumbling with the keys while driving as this can wear out the circuit board and shorten the remote's lifespan. Safety first - always perform these operations with the vehicle parked securely in a safe location.
