What is the recommended tire pressure for passenger cars?

How to Drain Water from a Truck's Fuel-Water Separator?

Generally, trucks' fuel-water separators have a dedicated drain valve. You can drain the water by loosening the valve. The operation methods of fuel-water separators vary among different vehicle models, so it is recommended that drivers carefully read the instruction manual. Here is some relevant information: 1. Definition of a Fuel-Water Separator: A fuel-water separator is an essential device on trucks. It removes water from diesel, thereby extending the service life of the fuel injectors and the engine. Many trucks have two small white tanks on the side of the chassis, which are the fuel-water separators. 2. Checking the Condition of the Fuel-Water Separator: Truck drivers are advised to regularly check the condition of the fuel-water separator. If the fuel-water separator is damaged, it should be replaced promptly. If water in the diesel cannot be separated, it will affect the service life of the fuel injectors and the engine. 3. Hazards of Poor Fuel Quality: Truck engines are generally high-pressure common rail diesel engines, which have high requirements for diesel quality. This is because the high-pressure fuel injectors need to precisely control the fuel injection pressure, timing, and quantity. If the diesel contains impurities or water that are not filtered out, it can cause damage to the fuel injectors.

10

0

Share

Is a Cold Start RPM of 1800 Normal?

A cold start RPM of 1800 is normal. Here are the specific details about engine RPM: 1. 800/min~1200/min: During a cold start, if the idle RPM is below 800/min or above 1200/min, it indicates poor engine condition. 2. Below 2000r/min: While driving, try to avoid keeping the engine running below 2000r/min. If the RPM is too low, the engine will lack power, and the excessive load at low RPM can damage the engine and lead to carbon buildup. 3. Above 4000r/min: When the engine operates above 4000r/min, the combustion time shortens, leading to incomplete fuel combustion and a significant increase in fuel consumption. If driving in fifth gear at this RPM, the speed typically reaches 150km/h, which is already a dangerous speed. 4. 2200~3500r/min: The most economical and optimal engine operation occurs between 2200~3500r/min. It is recommended to maintain the RPM within this range during regular driving.

13

2

Share

What to do if the inspection validity period of the vehicle license has expired?

Handling methods for an expired vehicle license inspection validity period: The first thing to do is to stop driving the vehicle on the road and promptly complete the annual inspection procedures. For vehicles that have exceeded the annual inspection period by less than a year, failing to complete the inspection procedures at the vehicle management department will result in penalties. Here are the relevant details: 1. Expiration of validity period: If the inspection validity period of the vehicle license has expired, you should go to the inspection station as soon as possible to complete the annual inspection. According to the "Regulations on the Registration of Motor Vehicles" (Order No. 102 of the Ministry of Public Security), the owner of the motor vehicle can apply for inspection at the vehicle management office of the registration location within three months before the expiration of the motor vehicle inspection validity period. 2. Consequences of overdue annual inspection: The validity period on the vehicle license is the annual inspection date of the vehicle. Although the supplementary page of the vehicle license has a reminder for the annual inspection date, some vehicle owners may neglect it and forget the annual inspection time, resulting in an overdue annual inspection. The consequences of an overdue annual inspection include being fined for failing to provide a valid vehicle inspection certificate and encountering obstacles in insurance claims after an accident. Therefore, the vehicle must be sent for inspection before the expiration of the inspection validity period.

12

1

Share

Is 8 liters per 100 kilometers considered high fuel consumption?

Consuming 8 liters per 100 kilometers is generally considered a normal level. However, this depends on the vehicle model, engine displacement, and engine system, as well as the driving conditions. For micro or compact cars, 8 liters would be considered relatively high fuel consumption. For family sedans, this is within the normal range. For mid-sized cars, 8 liters per 100 kilometers would be considered very low fuel consumption. Here is some relevant information: 1. Factors affecting fuel consumption: Generally, the larger the engine displacement, the higher the fuel consumption. However, there is no direct conversion formula between the two, as many factors influence fuel consumption. These include not only the engine's powertrain but also the transmission, drag coefficient, vehicle weight, and tires. Driving habits, vehicle condition, and road conditions also play significant roles. 2. Key technologies related to fuel consumption: (1) Reducing vehicle weight: Vehicle weight and fuel consumption are directly proportional. It is said that a 10% reduction in vehicle weight can lead to a corresponding reduction in fuel consumption by several percentage points. (2) Improving vehicle aerodynamics: A lower drag coefficient can significantly reduce fuel consumption. These two factors are also directly proportional. (3) Maximizing engine thermal efficiency: The thermal efficiency of a typical gasoline engine (the proportion of fuel converted into useful work) is around 30%, while diesel engines exceed 40%. This is the main reason why diesel engines are more fuel-efficient than gasoline engines.

1

2

Share

What does 0-100 km/h acceleration mean?

0-100 km/h acceleration refers to the time it takes for a car to accelerate from a standstill to 100 km/h under maximum engine output. This measurement is an important indicator of a vehicle's dynamic performance. Here are some related explanations: 1. Standards for measuring car performance: There are several key standards for evaluating a car's performance: maximum horsepower (affects top speed), maximum torque (affects acceleration), 0-100 km/h acceleration time, fuel consumption per 100 km, approach and departure angles (affect off-road capability), etc. 2. Typical 0-100 km/h acceleration times: For regular family cars, the 0-100 km/h acceleration time typically ranges between 5-12 seconds. Sports cars can achieve 4-5 seconds, while supercars can reach 3-4 seconds. Racing vehicles can achieve astonishing acceleration times of around 2 seconds (especially rally cars and GT3 race cars). 3. Factors affecting 0-100 km/h acceleration: Many factors influence a car's 0-100 km/h acceleration, including vehicle weight, tire performance, aerodynamic drag coefficient, turbo spool-up time, torque, and transmission shift logic, all of which significantly impact acceleration performance.

15

1

Share

What does eco mean on a car and how to use it?

Eco in a car refers to the economic driving mode. The driver can activate it by pressing the eco mode switch. Here are the relevant details: 1. Definition of eco: Eco is an English abbreviation formed from Ecology (environmental protection), Conservation (energy saving), and Optimization (power). When the eco indicator light on the dashboard illuminates, it indicates that the vehicle's economic mode is activated. 2. Active eco mode: The active mode has a dedicated button, allowing the driver to choose whether to enable it. When the driver presses the eco mode switch, the dashboard indicator light turns on, and the vehicle automatically adjusts settings such as throttle opening, transmission shift logic, and air conditioning output power. 3. Passive eco mode: The passive eco mode does not have a dedicated button. When the eco indicator light on the dashboard illuminates, it serves as a reminder function. The eco mode automatically evaluates driving behavior. If the current driving operation achieves the optimal fuel supply, the dashboard will simultaneously display the eco indicator light. 4. Eco mode typically deactivates under the following conditions: (1) When the vehicle speed exceeds 120 km/h, the car prioritizes speed, and the eco mode automatically deactivates. (2) During idling or when in N/P gear or manual mode, the eco mode may also deactivate. (3) When high torque output is required, such as when climbing a slope, the engine control unit prioritizes delivering sufficient power to drive the vehicle, and the eco mode will not function.

13

5

Share

What is the recommended tire pressure for passenger cars?

How to Drain Water from a Truck's Fuel-Water Separator?

Is a Cold Start RPM of 1800 Normal?

What to do if the inspection validity period of the vehicle license has expired?

Is 8 liters per 100 kilometers considered high fuel consumption?

What does 0-100 km/h acceleration mean?

What does eco mean on a car and how to use it?

What is the penalty for speeding between 40% and 50% over the limit?

What does the online status show if the driver's license is revoked?

What is the one-touch window function?

Can You Suffocate by Sleeping in a Car Without Turning on the AC?