What is the recommended tire pressure for 185r14c tires?

1 Answers
VonBlakely
07/29/25 3:39pm
185-14 tires can typically be inflated to a maximum pressure of around 2.5mpa. Here are some relevant details: 1. Vehicle load capacity depends on tire pressure: According to the relationship between tire load index, tire pressure, and load capacity, higher tire pressure increases load-bearing capacity, while lower pressure reduces it. 2. Additional information: Precautions for tire inflation: Pay attention to safety during inflation. Always use a pressure gauge to check the pressure to avoid over-inflation, which could cause tire rupture. Inspect the valve stem. If the valve stem and core don't fit smoothly or have protrusions/depressions or other defects, it may hinder proper inflation and pressure measurement.
Was this review help?
18
0
Share
More Forum Discussions

What are the maintenance items at 50,000 kilometers?

Car maintenance refers to the preventive work of regularly inspecting, cleaning, supplying, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. The specific maintenance items required for a car at 50,000 kilometers are as follows: 1. Replace engine oil and oil filter: Generally, manufacturers recommend replacing the engine oil every 5,000 kilometers or six months. When replacing the engine oil, the oil filter must also be replaced simultaneously; otherwise, it will affect the quality of the lubricating oil. 2. Inspect and replace brake pads: During inspection, it is important to note that the thickness of new brake pads is usually around 1.5 cm. If the brake pads wear down to about 0.3 cm in thickness, they should be replaced promptly. 3. Inspect and replace spark plugs: If there is carbon buildup or black oil stains on the spark plugs, they should be cleaned, and replaced if necessary. 4. Check whether the air filter and cabin air filter can continue to be used. If they cannot, they need to be replaced.
15
0
Share

What to Do About Sunroof Rattling?

Car sunroof rattling causes and solutions are as follows: 1. Insufficient lubrication of the sunroof sliding track: The rattling may be due to poor lubrication in certain areas. Try applying some grease. 2. Dust accumulation in the sunroof track: Keeping the sunroof open for long periods can lead to dust buildup on the sliding track. Cleaning it should eliminate the noise. 3. Loose sunroof screws: Long-term use may cause some components or screws to loosen. Tightening the screws should stop the noise. 4. Aging rubber seals: Sunroof sealing strips exposed to rain or sun for extended periods can deteriorate, causing noise when opening/closing. Rubber conditioner can temporarily restore the seals' performance. Opening the sunroof fully and spraying rubber conditioner on the seals should eliminate the noise.
13
2
Share

How to Test if a Liquid Level Sensor is Working Properly?

Here are the methods to test if a car liquid level sensor is functioning properly: 1. If the fuel tank has fuel but the indicator light is on, it indicates a sensor malfunction. 2. If the fuel gauge gets stuck at a certain position and does not move, it indicates a sensor malfunction. 3. If the fuel level is inaccurate during driving (jumping or fluctuating significantly), it indicates a sensor malfunction. Additional Information: 1. A liquid level sensor (static pressure level gauge/level transmitter/liquid level sensor/water level sensor) is a pressure sensor used to measure liquid levels. 2. The liquid levels that need to be monitored in a car include fuel tank level, brake fluid level, washer fluid level, coolant level, and engine oil level.
5
5
Share

How to Remove the Front Grille of Baojun 730?

First, unscrew the bolts securing the front grille, then release the upper clips connecting the grille to the vehicle body. The lower clips of the grille are quite tight; you will need a flat-head screwdriver to press the position marked by the red circle in the diagram to release the clips, and finally remove the front grille.
15
5
Share

Where to insert USB drive in Audi A6L?

The front USB port is installed inside the CD compartment of the glove box on the right side of the dashboard. There's a cover at the USB port location, which can be gently opened to reveal the USB interface. The rear USB port is hidden in a compartment beneath the rear seat air conditioning. Opening it reveals a USB port and power outlet.
12
4
Share

How to Remove the Blower Motor in a BMW 5 Series?

BMW blower motor is located in front of the front passenger seat. First, you need to remove the two cup holders in front of the front passenger seat. Pull out the cup holder cover, then use a screwdriver to remove the four screws behind the cover. Next, use a screwdriver to remove the four screws on the storage compartment. After taking out the storage compartment, you can see the blower motor underneath it. Rotate the blower motor clockwise to unscrew it from the front passenger storage compartment.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.