What is the recommended speed during the vehicle break-in period?

1 Answers
LeFrancisco
07/29/25 8:38pm
Vehicle break-in period speeds vary depending on different stages: 1. During the initial break-in phase, maintain speeds between 60-70 km/h with engine RPM not exceeding 2200 rpm; 2. In the mid-phase, speeds can be increased to 90-100 km/h with RPM not exceeding 2500 rpm; 3. During the late phase, speeds can reach up to 120 km/h with RPM not exceeding 3000 rpm. Precautions during vehicle break-in period include: 1. Warm up the engine before driving; 2. Avoid emergency braking; 3. Prevent overloading; 4. Avoid long-distance trips; 5. Refrain from high-speed driving; 6. Use high-quality gasoline; 7. Do not remove speed limiters prematurely; 8. Shift gears timely; 9. Properly adjust ignition and fuel systems.
Was this review help?
7
1
Share
More Forum Discussions

How many seconds does the Civic take to accelerate from 0 to 100 km/h?

The actual measured time for the Civic to accelerate from 0 to 100 km/h is 7.08 seconds. The Civic is equipped with a 1.5T engine, delivering a maximum power of 177 horsepower and a maximum torque of 220 N·m. The Fista, on the other hand, comes with a 1.6T engine, producing a maximum power of 204 horsepower and a maximum torque of 265 N·m. Below is relevant information: 1. The 0-100 km/h acceleration time refers to the time taken to accelerate from 0 to 100 km/h, which is the most intuitive reflection of a car's power. Generally, compact cars with a 1.6L engine achieve 0-100 km/h acceleration times between 11 to 13 seconds, mid-size cars with a 2.0T engine between 7 to 8 seconds, while supercars mostly have acceleration times of less than 3.8 seconds. 2. Among vehicles with the same displacement, those equipped with turbocharged engines have a significant advantage in the 0-100 km/h acceleration test, as they deliver more powerful output and have a very wide range of maximum torque output, allowing the vehicle to maximize acceleration capability at very low RPMs.
18
5
Share

How many points will be deducted for driving at 130 km/h on the highway?

Driving at 130 km/h when passing a speed camera on the highway is a speeding violation, but it may not result in point deductions or fines. For example, driving at 130 km/h on a highway with a speed limit of 120 km/h constitutes an 8% overspeed, which does not reach the 10% threshold. According to relevant regulations, exceeding the speed limit by less than 10% will not result in point deductions or fines but will only warrant a warning. Below are the relevant details: 1. Point deductions for speeding on the highway: The number of points deducted for speeding on the highway depends on how much the vehicle's speed exceeds the prescribed limit. Any speed exceeding 10% of the limit will result in point deductions, with different ranges incurring different penalties. 2. Liability for accidents caused by speeding: If a traffic accident is caused by speeding and the other party has no driving faults, the speeding driver shall bear full responsibility. If both parties have committed violations, neither will be deemed fully responsible. The liability will be divided based on the role and severity of each party's violations in causing the accident, assigning primary responsibility, equal responsibility, or secondary responsibility accordingly. The specific division of responsibility will be determined by the traffic police department. If dissatisfied with the traffic police's decision, one may apply for a review or directly file a lawsuit in court.
8
2
Share

Is it necessary to add cleaner to the car fuel tank?

Adding cleaner to the car fuel tank is necessary. The fuel tank cleaner can remove dirt from the fuel tank and also clean the carbon deposits in the engine. After a period of use, carbon deposits inevitably form in the engine, settling on the intake valves, fuel injectors, and combustion chamber walls. Using fuel cleaner can help remove these carbon deposits from the engine. The specific details are as follows: 1. Adding cleaner to the car fuel tank is useful, but it should not be added indiscriminately. Generally, for two types of engines—port fuel injection (intake manifold injection) and direct injection (high-pressure direct injection in the cylinder)—the parts that can be cleaned are different. 2. Since the cleaner is mixed with gasoline, for a regular port fuel injection car, the fuel mist is sprayed from the injector in the manifold, passing through the fuel injector, manifold, intake valve, cylinder block, inner cylinder head, and piston head, all of which can be cleaned. However, for direct injection, the fuel mist is directly injected into the cylinder, so only the direct injector, cylinder block, and piston head can be cleaned. Therefore, adding cleaner to the car fuel tank is more effective for regular port fuel injection cars.
20
0
Share

What to Do When a Diesel Vehicle Runs Out of Fuel

When refueling a diesel engine, pay attention to the venting points. The newly added fuel must fill the entire fuel supply line using a priming tube or pump. Below are the precautions for refueling a diesel vehicle: 1. Specific method: Unscrew the cap of the fuel inlet filter, guide the fuel here, and when fuel overflows from this point, tighten the filter. Open the cap of the high-pressure fuel pump, use a screwdriver to pump fuel several times under the plunger seat of each fuel pump until a clear pumping sound is heard in the cylinder. Each cylinder's fuel pump must be pumped. If everything remains unchanged, the engine should start. Check if the throttle linkage is loose, if the idle speed has changed, and if the battery has sufficient power. 2. Multi-cylinder engine: After refueling, there is no fuel in the section from the fuel tank to the fuel bowl. The solution for multi-cylinder vehicles is to first locate the fuel filter, loosen the vent screw connected to the fuel bowl with a wrench (one turn is sufficient), and manually pump fuel until a strong jet forms at the fuel pipe screw, then tighten the screw to start the engine. 3. Single-cylinder engine: For a single-cylinder engine, also locate the filter, loosen the corresponding screw on the main fuel line with a wrench until fuel flows out, then tighten the screw to start the engine.
16
3
Share

Does 2020 Auto Damage Insurance Cover Water Damage?

2020 motor vehicle damage insurance includes coverage for water damage. After the 2020 auto insurance reform, water damage insurance, spontaneous combustion insurance, glass insurance, theft insurance, no-deductible insurance, and third-party-not-found insurance were all bundled into auto damage insurance for sale. Therefore, by purchasing auto damage insurance, you can simultaneously obtain coverage for multiple types of auto insurance, which is very cost-effective. More information on auto damage insurance is as follows: 1. Introduction: Auto damage insurance, short for vehicle damage insurance, is the most widely used type of auto insurance. Whether it's minor scratches or serious damage, the insurance company will cover the repair costs. However, auto damage insurance also has various exclusions. For example, if the vehicle continues to be used after a collision, resulting in further damage, the insurance company may refuse to pay. In the event of an insurance claim, the insurer will cover the necessary and reasonable rescue expenses paid by the insured to prevent or reduce the loss of the insured vehicle, up to the insured amount. 2. Features: Auto damage insurance is a type of commercial insurance. After the insurance reform, auto insurance has expanded to include many additional coverages, such as auto damage insurance, theft insurance, spontaneous combustion insurance, engine water damage insurance, glass insurance, third-party-not-found insurance, and no-deductible insurance. Additionally, commercial insurance also includes third-party liability insurance, scratch insurance, passenger insurance, and absolute deductible exclusion insurance.
19
2
Share

Is it normal for the BMW 525 engine oil temperature to reach 120 degrees?

Partial high engine oil temperature is normal. If there is a consistent trend of exceeding 120 degrees, the cause should be investigated. Below is more information about engine oil: 1. Mineral oil: Mineral oil is the residual oil left after gasoline and heavy oil are extracted from petroleum. In fact, mineral oil is also a natural oil with many impurities. It is cheaper compared to semi-synthetic and full-synthetic oils, but it has poor lubrication properties for the engine and a short service life. 2. Semi-synthetic oil: Semi-synthetic oil falls between mineral oil and full-synthetic oil. It contains a large amount of anti-corrosion additives to enhance the stability and high oxidation resistance of the oil. 3. Full-synthetic oil: Among these three types of oil, full-synthetic oil is the highest in quality and durability, and it is also the most expensive. Generally, it can be used in passenger cars for 10,000 to 12,000 kilometers without deteriorating. 4. Hazards of water in engine oil: If a small amount of water enters the engine and mixes with the oil, the oil quality deteriorates. Oil containing water can increase wear on engine components, potentially leading to increased engine noise and vibration during future vehicle operation.
16
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.