···
Log in / Register

What is the reason why the Zotye E200 slow charging cannot charge?

1 Answers
SanMaximus
09/08/25 3:33am

This situation occurs when the charger is damaged. After this situation occurs, just replace the new charger. The following is detailed information about Zotye: Safety configuration: The Zotye E200 is equipped with ABS, EBD, ESC, EPB parking brake, hill start assist system, front airbags, pre-tensioned and force-limiting seat belts, seat belt reminder, automatic locking when driving, and front ventilated discs/rear solid discs four-wheel disc brakes in terms of active safety. In terms of passive safety, it is equipped with front/rear anti-collision beams, side door anti-collision beams, etc. The car adopts front MacPherson independent suspension and rear double A-arm cast aluminum independent suspension, which is the same level as the Audi R8. In mid-to-high-end cars, multi-link independent suspension is more commonly used. When the vehicle turns or brakes, the multi-link suspension structure can make the rear wheels form positive toe-in, reducing understeer and improving the vehicle's handling. The electronic parking brake is not available in other cars of the same level.

Was this review help?
16
4
Share
More Forum Discussions

How to distinguish imported Honda Free 50?

Domestic models are the cheapest; followed by parallel imported cars; the most expensive are regular imported cars. Parallel imported cars and imported cars have good quality and very complete configurations. Domestic cars, in order to cater to the tastes of domestic consumers and ensure cost, may have some reduced configurations.
19
2
Share

How to adjust the high and low beams of a motorcycle?

Loosen the two screws on the left and right sides of the headlight, then move the headlight up and down. The adjustment can also be made using the adjustment screws behind the headlight. There are usually two screws, one for adjusting the height and the other for adjusting the left-right position.
1
0
Share

How to Disassemble and Repair the Front Brake Pump of a Motorcycle?

Remove the half-shaft bolt, take out the half-shaft, lift the wheel, remove the hollow shaft bolt, and take out the half bearing together with the wheel; Remove the brake pads, disconnect the brake caliper hose, remove the brake pump, and then you can start the repair.
1
4
Share

How to Wire Additional Lights on a Motorcycle?

Take the charging wire (red/black), trigger wire (green/white), high-voltage coil input wire (yellow), or any one of the engine kill wires (black/white) and connect them in series with a switch. Connect in series with the positive battery input wire (red wire).
14
1
Share

How to Install a Chain?

Replace the worn-out old chain and cut the new chain to the same length as the old one. Place the chain on the largest chainring and the largest sprocket. For frames with rear suspension, position the rear suspension at the setting that requires the longest chain length.
5
5
Share

How to Check the Expiration Date of Motorcycle Insurance?

You can visit the official website of the insurance company and click on the corresponding link to check the relevant information about your motorcycle insurance. Alternatively, you can call the official customer service hotline of the insurance company, provide the necessary identity information for verification, and then proceed with the inquiry.
5
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.