What is the reason why the wiper of the new CRV cannot be turned off?
3 Answers
New CRV wipers cannot be turned off because the wiper is in automatic mode. The following is a related introduction about the wiper: Spraying windshield washer fluid: When using the wiper to remove dust from the windshield surface on a sunny day, be sure to spray windshield washer fluid and do not wipe dry. Hard dirt should be cleaned by hand: If there are other stubborn and hard dirt on the glass, it should be cleaned manually. These things can easily damage the wiper blade, causing the wiper to not clean properly. In severe cases, the wiper motor may also be affected. When lifting the wiper blade during car washing or daily cleaning, hold the "back" of the wiper and gently return it. Do not snap the wiper blade back suddenly.
I recently encountered a similar issue with my new CR-V where the wipers wouldn't turn off, which was really annoying. I think the most common causes are either the wiper switch getting stuck or damaged, since frequent use leads to wear. It could also be due to relay sticking, wiper motor overheating causing continuous operation, or poor wiring contact. Sometimes a blown fuse makes them not work at all, but failure to turn off is a different matter. Occasionally, software bugs in the body control module can cause this in new cars—ironically, higher intelligence sometimes creates more trouble. I suggest not forcing them to stop; first try gently operating the switch. If that doesn't work, temporarily disconnecting the battery's negative terminal might help. Last time, I drove to the dealership where they adjusted it for free—fixed in minutes. Regularly cleaning dust from the wiper system and preventing sand particles from jamming the switch gaps can save you a lot of money.
Regarding the issue of the new CR-V's wipers not turning off, from my experience, it's not uncommon. The wiper switch assembly may have internal contact oxidation or jamming, preventing the shutdown signal from being sent. Additionally, relay malfunction is a major problem, where sticking contacts cause the wipers to keep running. Wear on the wiper motor gears or bearing issues can also create a system deadlock. Short circuits or aging wiring harnesses are prone to triggering in high humidity, while blown fuses are relatively rare in this scenario. For new vehicles equipped with automatic sensing features, dirty sensors or software bugs may mistakenly detect rainy conditions. A simple check you can perform is to pull the wiper fuse (locate the corresponding position in the fuse box) to force shutdown. Safety first—don't let continuously running wipers distract your driving. It's better to send for timely repairs than to tinker blindly.
