What is the reason why the rear seat light of Volkswagen Bora cannot be turned off?
4 Answers
For the Volkswagen Bora, pressing the right side of the lampshade can turn off the rear seat light. Normally, you can adjust the rear light to DOOR mode, which will turn on when the door is opened and turn off when the door is closed, making it more convenient without the need to constantly adjust it. Relevant information about the car lights is as follows: Introduction: Car lights refer to the lamps on the vehicle, which are tools for road lighting during night driving and also serve as signals for various vehicle movements. Reversing light: The reversing light automatically turns on when the driver shifts into reverse gear. It is a white transparent light, mainly serving to alert vehicles behind that the car is reversing.
I've encountered many such issues while repairing cars. The most common reason for the rear seat light in a Volkswagen Bora not turning off is the aging or malfunctioning of the door switch rubber pad. When the door is closed, the switch should sense the pressure and turn off the light, but if the rubber pad is damaged, the system mistakenly thinks the door is still open, keeping the light on. Secondly, check if the switch button is stuck or if the internal contacts are oxidized. Sometimes, accidentally spilling drinks or water can cause a short circuit. Another possibility is loose wiring or a blown fuse. If the light doesn't turn off, it can drain the battery, and it's really frustrating when the light won't turn off before driving. It's recommended to gently press the switch on the door edge with your finger to see if the light turns off. If that doesn't work, quickly take it to a car repair shop to check the circuit. Don't let a small issue turn into a big problem.
As an ordinary person who loves road trips, I've been driving a Bora for five years. Last time, the rear seat light kept staying on, which ruined my sleep at night. Actually, it was the small switch in the door sensor that was broken—the system couldn't detect the door closing properly. It could also be that your car key wasn't removed correctly. Some cars automatically turn off the lights after the engine is off, but if the settings get messed up, it won't work. From my experience, I've developed a habit: pressing the switch twice to manually turn off the lights before shutting down the engine, or checking if the doors are tightly closed. A constantly lit light not only drains the battery but also shortens its lifespan—don't take it lightly. It's best to regularly clean the dust around the door locks to prevent premature aging. A few simple tricks can save you a lot of trouble.
From a DIY perspective, when I found that the rear seat light of the Bora couldn't be turned off, I first tried whether the manual switch was functioning properly; then checked if there were any obstructions near the door latch sensor; next, I looked through the fuse box to find a spare fuse and replaced it for testing. Worn door switch rubber pads are the main cause, which are low-cost but easily overlooked. I've encountered similar issues in my old car—the light stayed on, wasting energy unnecessarily. It's important to address it promptly to prevent battery drain and starting problems.
