···
Log in / Register

What is the reason why the old Buick GL8 can unlock but not lock the car?

3 Answers
IvanLynn
09/02/25 3:08am
Old Buick GL8 can unlock but not lock the car may be due to a problem with the central control box or the central lock being stuck, the owner needs to check and repair it. The dimensions of the Buick GL8 are 5219mm in length, 1878mm in width, and 1799mm in height, with a wheelbase of 3088mm. The following is an introduction to the Buick GL8: Configuration: Equipped with Buick's advanced intelligent driving assistance system, providing 20 advanced intelligent driving assistance functions including LCC Lane Centering Intelligent Cruise, TJA Traffic Jam Assist, HOD Hands-Off Detection, DOW Door Opening Warning, etc. Power: Equipped with General Motors' latest Smart-Propulsion intelligent driving technology, featuring a flagship powertrain combination of the eighth-generation Ecotec 2.0T variable cylinder turbocharged engine and a 9-speed HYDRA-MATIC intelligent transmission, capable of outputting 174kW and 350Nm, with a combined fuel consumption of only 7.9L/7.8L per 100km. The 9-speed intelligent transmission and the newly equipped ETRS electronic gearshift make gear shifting more responsive and power output smoother and more stable.
Was this review help?
6
2
Share
LaEmery
09/14/25 5:26am
I've been driving a Buick GL8 for almost ten years and have encountered similar issues several times. The car can be unlocked but not locked, mainly due to problems with the door lock system, which is common in older vehicles. First, check the battery in the remote control; low power can cause signal transmission failure. Try replacing it with a new one—it only costs a few bucks. If that doesn't work, it might be the lock actuator motor that's broken; that little thing gets stuck and doesn't move, so pressing the lock button gets no response. Loose wiring connections can also be the culprit, especially in older cars where the wiring harness has aged and causes poor contact. I recommend manually locking the doors at night to avoid too much risk. This issue is quite common in older cars, and timely maintenance can solve it. If you're handy, you can remove the door panel and adjust it yourself—it's a hassle-free solution.
Was this review help?
16
5
Share
Expand All
DiElaina
10/28/25 6:09am
From repair experience, the Buick GL8's inability to lock is mostly due to the locking components. Normal unlocking indicates no issue with the remote receiver, while locking failures are often caused by wear in the lock actuator motor—if the motor burns out, it won't function. The inspection steps are straightforward: test the remote's output signal and use a multimeter to check if the voltage is correct; if there's no response, try replacing the battery first. Then, listen for a 'click' sound when pressing the lock button—if silent, check the fuse or motor. Wiring aging and short circuits are also common, and loose wiring harness connectors can have a significant impact. Older vehicles are prone to this issue—don't delay, visit a professional shop early. Replacing the lock actuator doesn't cost much and ensures safety.
Was this review help?
6
5
Share
Expand All
More Forum Discussions

Has the Size of the New Odyssey Changed?

There are no changes in the dimensions of the new Odyssey, with its length, width, and height remaining at 4847mm, 1820mm, and 1712mm respectively. Exterior: The new Odyssey features a completely redesigned front grille, with a jagged chrome grille paired with a sporty shovel-shaped front bumper and matrix headlight clusters, creating a stronger sense of quality and impact. The blackened B-pillars, C-pillars, and privacy glass on the sides maintain the strong family MPV characteristics, while the internal matrix light arrangement ensures high visibility when lit. Powertrain: The new Odyssey continues to be equipped with Honda's i-MMD hybrid system, delivering a maximum combined output of 215 horsepower, matched with an E-CVT transmission.
8
3
Share

What are the causes of shock absorber noise in the XPeng P7?

XPeng P7 shock absorber noise is caused by: foreign objects getting caught in the chassis; damage to chassis components; or shock absorber failure. Appearance: The XPeng P7 features a distinctive front and rear continuous light strip design, with smooth and flowing body lines. The front face adopts a fully enclosed grille design exclusive to electric vehicles, with split-type LED headlights positioned at both ends of the front, capable of emitting sharp light in narrow spaces, giving it a futuristic appearance. Performance: The XPeng P7 is equipped with two high and low power motor units as power output. The mid and low trim models use rear-mounted motor drive, with a maximum power of 196 kW and a maximum torque of 390 Nm.
4
5
Share

Where is the low beam fuse located in the Baojun 730?

The low beam fuse in the Baojun 730 is located in the engine compartment of the car, as well as on the left side of the steering wheel and near the driver's knee position. Introduction to automotive fuses: Automotive fuses are a type of current fuse. When the circuit current exceeds twice the rated current of the fuse, it will melt within seconds, serving to protect the circuit. They are commonly used for overcurrent protection in automotive circuits and also for overcurrent protection in industrial equipment. Precautions for replacement: When replacing a fuse, it is necessary to use one with the rated current value specified on the fuse box cover. Do not replace it with a fuse that has a higher rated current. If the new fuse blows immediately, it indicates that there may be a fault in the circuit system, and it should be inspected and repaired as soon as possible.
5
5
Share

Where is the jack located on the LaCrosse?

The jack of the LaCrosse is located under the trunk mat. Configuration of the LaCrosse: Features such as an openable panoramic sunroof, LED lights, multi-layer soundproof glass, an 8-inch touch screen, smartphone connectivity, vehicle networking, and OTA upgrades are all standard. The Avenir flagship version additionally includes a HUD head-up display, adjustable suspension stiffness, rear multimedia controls, front and rear seat heating, ventilation, massage functions, and rear independent air conditioning. Powertrain of the LaCrosse: It is equipped with the eighth-generation Ecotec 2.0T variable cylinder turbocharged engine, model LSY, with a maximum rated power of 174 kW and a maximum torque of 350 Nm, paired with a 9AT transmission. The official 0-100 km/h acceleration time is 7.5 seconds.
1
2
Share

How many liters of engine oil are needed for Mercedes-Benz G63 maintenance?

Mercedes-Benz G63 maintenance requires 8 liters of engine oil if completely drained, and 7 liters if not fully drained. Introduction to Engine Oil: Currently, engine oils are categorized into three types: conventional mineral oil, semi-synthetic oil, and full synthetic oil. Engine oils are primarily classified by quality grades into SG, SJ, SL, SM, and SP, with SP being the highest grade in automotive engine oils, meeting the lubrication needs of most vehicle engines. Precautions for Engine Oil Replacement: Choose the appropriate engine oil grade based on the local temperature to prevent the oil from freezing in cold weather. Additionally, engine oil must be replaced regularly according to the type of oil used, with replacement cycles corresponding to six months, nine months, and twelve months respectively.
16
5
Share

What Causes the Sunroof Rattle in BMW 740?

BMW 740 sunroof rattle is caused by: insufficient lubricant in the sunroof tracks or the presence of dust and foreign objects on the tracks. Daily lubrication of the sunroof: Fully open the car sunroof, wipe off dust on the tracks with a clean soft cloth, and apply a dust-resistant lubricant to the sunroof tracks and transmission channels. Sunroof cleaning precautions: In spring and autumn, clean the sealing rings with a damp sponge every quarter. Before long-term parking, thoroughly clean the sunroof with talcum powder to prevent chemical aging of the rubber seals due to prolonged exposure. High-pressure car wash: When washing the car with a high-pressure water gun, avoid directing the water jet directly at the sunroof's sealing rings, as this may cause deformation under high water pressure.
10
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.