What is the reason why the Mazda 6 key can only unlock but not lock?

What is the procedure after a rear-end collision?

Procedure after a rear-end collision: 1. Immediately call 110 to report the accident and obtain a traffic accident liability determination certificate (police proof); 2. Both parties notify their respective insurance companies; 3. Wait for the insurance company to send personnel to conduct an on-site inspection and fill out the on-site inspection record; 4. Prepare four sets of documents: valid vehicle license, original and copy of driver's license, ID card of the insured, and insurance policy (including commercial insurance and compulsory traffic insurance policy). Be sure to obtain a copy of the other party's compulsory traffic insurance policy and submit it to the professional insurance staff at the 4S shop; 5. The party primarily at fault should advance the cost of damages for both vehicles and submit the complete documentation to the insurance company for reimbursement.

19

2

Share

Can the Fit use 95-octane gasoline?

The Fit can use 95-octane gasoline. This vehicle requires a minimum of 92-octane gasoline. Gasoline is a volatile, flammable hydrocarbon mixture liquid distilled or cracked from petroleum, used as fuel. The Fit is a hatchback launched by GAC Honda, with a body length of 4065mm, width of 1695mm, height of 1525mm, and a wheelbase of 2530mm. The Fit is equipped with a 1.5L direct-injection DOHC i-VTEC engine, delivering a maximum power of 96kW and maximum torque of 155Nm, paired with a CVT transmission. It features direct fuel injection technology and uses an aluminum alloy cylinder head and block.

8

3

Share

How to Check Fuel Level on a Mercedes-Benz Fuel Gauge?

The fuel gauge shows the fuel level in the vehicle's tank. When the needle points to 0, it indicates that the fuel tank is low on fuel. When the needle points to 1, it means the fuel tank is full. If the needle is between 0 and 1, it indicates that the tank is half full. Based on the fuel level, it is recommended to add fuel in a timely manner and not wait until the fuel warning light comes on. Here is some relevant information about the vehicle's fuel tank: 1. Introduction: The automotive fuel tank is the full name of the car's fuel container. Currently, with the development of the automotive industry and the revitalization of the domestic automobile sector, the demand for automotive fuel tanks from major automobile manufacturers has shown a significant upward trend. 2. Design Principle: The design utilizes the heat energy generated by the engine during operation, incorporating a thermal circulation system between the engine, fuel tank, and radiator. The original single fuel tank is redesigned into a combined fuel tank consisting of a main tank and an auxiliary tank.

1

2

Share

Mustang: Should You Use 92 or 95 Octane Fuel?

According to the official vehicle manual recommendation, the Mustang should use 95 octane fuel. In addition to checking the appropriate fuel grade in the vehicle manual, the Mustang owner can also find this information on the fuel tank cap, which is usually labeled. Generally, the fuel grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 octane fuel, while those with a compression ratio between 10.0-11.5 should use 95 octane fuel. However, with the application of new technologies, the compression ratio alone cannot determine the fuel grade—high compression ratios can still be tuned to use lower octane fuel. This is because other factors, such as ignition timing, turbocharging technology, and Atkinson cycle technology, also play a role. Generally, the higher the fuel octane number, the higher the octane value and the better the anti-knock performance. 92 octane fuel contains 92% isooctane and 8% n-heptane, while 95 octane fuel contains 95% isooctane and 5% n-heptane. If the Mustang occasionally uses the wrong fuel grade, simply switch back to the correct grade after consumption. However, long-term use of the wrong fuel grade can have the following effects: For vehicles recommended for low-octane fuel, using higher octane fuel will not cause damage, but the increased octane value alters the fuel's ignition point, leading to delayed combustion in the engine. This reduces both the engine's power output and thermal efficiency, resulting in poorer performance. For vehicles recommended for high-octane fuel, using lower octane fuel can cause engine knocking. Due to the significantly lower octane value, the fuel ignites prematurely during the compression stroke. If combustion occurs before the spark plug fires, resistance is generated during the upward stroke. This resistance makes the engine run very unevenly. If the knocking is mild, it may only increase noise without obvious engine damage. However, severe knocking indicates critical engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in extreme cases, cylinder scoring.

3

0

Share

What is the tire model of BYD Han?

BYD Han's tire model is 245/45R19. The first number 245 indicates the tire width is 245MM, 45 means the aspect ratio of the tire section is 45%, that is, the section height is 45% of the width, and 19 represents the rim diameter is 19 inches. The middle letters or symbols have special meanings: "X" denotes high-pressure tires; "R", "Z" indicate radial tires; "-" represents low-pressure tires. BYD Han can accelerate from 0 to 100 km/h in 7.9 seconds. In addition to the model, tires are also marked with the following common data: Tire cord material: Represented by Chinese pinyin, such as M-cotton cord, R-rayon cord, N-nylon cord, G-steel cord, ZG-steel radial cord. Speed rating: Indicates the maximum speed at which the tire can carry a specified load under specified conditions. Letters A to Z represent certified speed ratings from 4.8km/h to 300km/h. Common speed ratings include: Q: 160km/h; H: 210km/h; V: 240km/h; W: 270km/h; Y: 300km/h; Rim specification: Shows the rim size compatible with the tire for practical use, such as "Standard Rim 5.00F".

13

1

Share

How to Replace the Battery in a Kia K5 Key Fob?

Method for replacing the battery in a Kia K5 key fob: 1. Remove the mechanical key, then insert a flat-head screwdriver into the slot marked by the red circle and pry it open with force; 2. Once a gap is created, use both hands to pull the key fob apart; 3. After opening, you will see one half containing the circuit board and the other half with the coin cell battery, where the positive side of the battery faces down; 4. Use the screwdriver to pry out the coin cell battery. When installing the new battery, ensure the side with the text faces downward. After replacing the battery, snap the two halves of the key fob back together. The Kia K5 is a mid-size sedan under Dongfeng Yueda Kia, with body dimensions of 4845mm in length, 1835mm in width, 1455mm in height, and a wheelbase of 2795mm.

13

1

Share

What is the reason why the Mazda 6 key can only unlock but not lock?

What is the procedure after a rear-end collision?

Can the Fit use 95-octane gasoline?

How to Check Fuel Level on a Mercedes-Benz Fuel Gauge?

Mustang: Should You Use 92 or 95 Octane Fuel?

What is the tire model of BYD Han?

How to Replace the Battery in a Kia K5 Key Fob?

What Causes Transmission Oil Leakage?

Where is the tire pressure monitoring device located in the Volkswagen Tayron?

What is the engine number of the Lexus 350?

Where is JASSITOW Tires produced?