What is the reason why the electric tricycle does not move when it rains?

1 Answers
AnnieLynn
07/29/25 11:09am
Electric tricycle is normally powered but does not move may have the following reasons: Controller problem: Whether the controller is good or bad, it can be used to rotate the handle wire positive 5V short, if the handle rotates, it indicates that the controller is not a problem, the simplest method, if the controller is burnt, or bad, smell it. Check the rotating handle, use the wire to short the handle and the signal line. If the car turns, it proves that the rotating handle is broken, and it needs to be replaced or repaired urgently. Motor failure: Check the quality of the motor, contact error will cause it not to move. Line failure: Check whether the battery output of the electric vehicle is normal. If the output bottom confirms that the battery is bad, replace the battery urgently.
Was this review help?
11
4
Share
More Forum Discussions

Where is the OBD interface of Octavia located?

The OBD interface of Octavia is located in the fuse box under the steering wheel. To find it, lean down from the driver's seat and look at the bottom of the car; the OBD interface is positioned above the brake and accelerator pedals. OBD-II differs from all previous vehicle diagnostic systems in its strict focus on emissions. Its essential function is to monitor vehicle emissions by observing the car's powertrain and emission control systems. Below is relevant information about OBD: 1. The OBD system continuously monitors the engine's operation to check if the vehicle's exhaust exceeds standards, issuing an immediate warning if it does. 2. OBD monitors in real-time the engine, catalytic converter, particulate filter, oxygen sensors, emission control system, fuel system, EGR, and other components. It then connects various emission-related component information to the ECU. When an emission fault occurs, the ECU records the fault information and relevant codes, triggering a warning light to alert the driver.
8
1
Share

How many liters of transmission oil does a Toyota Prado need?

For a Prado, changing the transmission oil requires about 4 liters, while if the oil pan is removed, approximately 5 to 6 liters are needed. The functions of automotive transmission oil are as follows: 1. The primary role of transmission oil is to keep the gear system clean, lubricate the transmission components, and extend their lifespan. Due to different transmission designs, there are manual transmissions and automatic transmissions. Each transmission design has its specific technical requirements. Even the same model of transmission configured in different vehicles has its own designated original transmission oil. 2. Transmission oil serves to clean, lubricate, cool, and seal the transmission. Given the specific operating environment inside the transmission, the quality of the oil has a certain shelf life. Over time, the performance of the oil deteriorates, generating more impurities, which accelerates the wear of transmission components, leading to earlier failures or a higher failure rate.
14
0
Share

How to Reset the Audi Tire Pressure Light?

Audi tire pressure light reset method: First, turn on the ignition switch, then press and hold the tire pressure monitoring reset button until you hear a "beep" sound before releasing it. The tire pressure monitoring system will then store the current normal tire pressure data, automatically clear the previous data, and finally, the warning light on the dashboard will turn off, completing the tire pressure reset. Solutions for insufficient tire pressure: If no damage is visible, simply inflate the tire to the normal pressure and reset the tire pressure system. If a puncture is found upon inspection, drive to a tire shop promptly for repair, then reinflate the tire. If the tire pressure warning reappears some time after inflation without any punctures, it may be due to air leakage caused by a deformed wheel rim. It is recommended to check the wheel rim and replace it if necessary. Hazards of low tire pressure: Increased friction coefficient with the road surface, leading to higher fuel consumption. Causes the steering wheel to feel heavy and may lead to veering, among other factors detrimental to driving safety.
16
2
Share

How to distinguish between Reiz versions?

Reiz has only undergone two generational updates. Comparing the first-generation and second-generation models, the differences are as follows: 1. The first-generation models have slightly more powerful performance than the second-generation models: a. For the 2.5L models, the first-generation has a maximum horsepower of 197PS, while the second-generation has 193PS. b. For the 3.0L models, the first-generation has a maximum horsepower of 231PS, while the second-generation has 227PS. 2. The throttle response of the first-generation Reiz is more sensitive than that of the second-generation. Even with the 2.5L engine, the first-generation model responds very actively with just a light press on the accelerator. 3. The steering of the second-generation Reiz is better than that of the first-generation. The second-generation offers clearer steering feel, with heavier power steering, providing a more stable overall sensation.
9
3
Share

How much discount is available for the Audi A4?

Audi A4L currently has no discount for the base model. The following is an introduction about the Audi A4: 1. Introduction: As the first model to introduce the long wheelbase and turbo concept, from B5 to B8, the sales of A4L have remained strong. The new A4 has abandoned the teardrop design, added quattro four-wheel drive mode, and has a more fashionable and sporty appearance, with more outstanding power and handling. The interior of the model is exquisitely crafted, with rich technological configurations and ample space, offering good practicality among B-class models. 2. Achievements: The Audi A4 produced by FAW-Volkswagen is the first B-class sedan of an international luxury brand in China, filling the gap in the domestic B-class sedan market and strengthening FAW-Volkswagen's leading position in the domestic luxury car market. This was quite significant at the time, and judging from the sales of Audi A4 in China, it has indeed been successful.
10
0
Share

Why Did the Seventh-Generation Accord Become a Classic?

The reasons why the seventh-generation Accord became a classic are: 1. Operation: The seventh-generation Accord had the most moderate size, ensuring spacious rear seating while maintaining excellent handling flexibility. Moreover, Honda during that era offered a stronger sense of realism and directness in driving compared to today. 2. Power: In terms of power output, the 2.0L 4-cylinder model delivered 156ps/6,300rpm of power and 19.34kgm/4,300rpm of torque. This version of the Accord-7 also featured a 5-speed transmission. The 2.4L version of the Accord-7 produced 180ps/6,500rpm of power and 22.74kgm/4,300rpm of torque, with an upgraded transmission system that also reached a 5-speed configuration.
6
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.