What is the reason for water dripping from the sunroof control panel of the Golf Sportsvan?

1 Answers
LeLeonardo
07/24/25 4:36am
There are several reasons for this situation: sunroof blockage and displacement of the sunroof sealing strip. Here are the relevant explanations: Sunroof leakage: Small sand particles or dust in the sunroof drainage channel can cause blockage. It is recommended to regularly clean the sunroof to maintain the cleanliness of the drainage channel. Additionally, during regular car washes, use high-pressure air equipment to blow air in the direction of the drainage pipe to remove dirt inside the pipe. Displacement of the sunroof sealing strip: If the sunroof sealing strip of the car has been "lifted," it indicates excessive friction between the strip and the roof. In this case, you can spray a small amount of plastic protectant or talcum powder on the sealing strip to reduce unnecessary friction while maintaining its sealing performance.
Was this review help?
16
5
Share
More Forum Discussions

How often should the belt on the Atenza be replaced?

The belt on the Atenza should be replaced approximately every 60,000 to 80,000 kilometers. The car belt, also known as the automotive drive belt, primarily functions for power transmission. The Atenza is a mid-size sedan with body dimensions of 4870mm in length, 1840mm in width, and 1445mm in height, a wheelbase of 2830mm, and a fuel tank capacity of 56.2 liters. The Atenza is equipped with a 2.0L naturally aspirated engine, delivering a maximum power of 116kW at 6400rpm and a maximum torque at 4000rpm. It features a MacPherson strut front suspension and a multi-link independent rear suspension.
3
1
Share

Which wire should be cut to start a motorcycle?

Alternating ignition with dual wires. Jump-start method: To start a motorcycle without a key, connect the red and black wires together. Locate the ignition wires - one red (positive) and one black (negative). Touch the two wire ends together to start the motorcycle. Ignition system: Consists of components like the ignition coil, CDI unit, high-voltage coil, and spark plug. The primary current from the motorcycle's ignition coil enters the ignition unit, then flows through the high-voltage coil where it's amplified. This high-intensity current reaches the spark plug to ignite the fuel-air mixture in the cylinder. The resulting high-pressure combustion drives the crankshaft to perform work.
10
2
Share

What is the 0-100 km/h acceleration time of the Mercedes-Benz S600?

The 0-100 km/h acceleration time of the Mercedes-Benz S600 is 4.6 seconds. The 0-100 km/h acceleration time refers to the time it takes for the car to accelerate from 0 to 100 km/h, which is an intuitive reflection of the car's power. The Mercedes-Benz S600 is equipped with a 6.0-liter V12 engine, handcrafted by the AMG factory, and features an all-aluminum crankcase, reinforced forged pistons, and dedicated ignition coils, with a peak torque of 830 Nm. The Mercedes-Benz S600 comes standard with a full LED intelligent lighting system, an enhanced collision prevention system, and a magic body control system. The dimensions of the Mercedes-Benz S600 are 5116 mm in length, 1899 mm in width, and 1496 mm in height, with a wheelbase of 3035 mm.
10
0
Share

How to Check the Oil Dipstick Scale on the Leiling?

The method to check the oil dipstick scale on the Leiling is: 1. Open the engine hood, pull out the oil dipstick, and clean it with paper or cloth; 2. Reinsert and pull it out again, the position where oil traces appear at the top of the dipstick indicates the oil level height. The Leiling is a compact car with body dimensions of 4640mm in length, 1780mm in width, and 1455mm in height, a wheelbase of 2700mm, and a fuel tank capacity of 50 liters. It is equipped with a 1.2L turbocharged engine, delivering a maximum power of 85kW at 5200 to 5600 rpm and a maximum torque at 1500 to 4000 rpm.
15
0
Share

Is it problematic for water to reach the car chassis?

If the water level just reaches the chassis, there is generally no significant impact as long as it is not submerged for an extended period. Hazards of water-damaged vehicles: The reliability of such vehicles cannot be guaranteed, and the likelihood of future malfunctions increases. Automobiles contain a large number of electronic components, and if submerged, the reliability of the vehicle in future use may be compromised. Even after replacement, reliability cannot be fully assured. Odor issues: After being submerged, water-damaged vehicles can usually only be treated through rinsing, drying, and sun exposure. As a result, some hidden areas can easily become breeding grounds for bacteria, potentially leading to unpleasant odors.
2
2
Share

Why do some cars have shark fin antennas while others don't?

Why do some cars have shark fin antennas while others don't: Traditional car antennas include telescopic antennas, whip antennas, and window-embedded antennas. If a car doesn't have a shark fin antenna, it likely uses one of these traditional types, and shark fins can be retrofitted. Another type is the hidden built-in antenna, which remains invisible while improving aesthetics and sometimes even aerodynamics. The shark fin antenna serves as an alternative and upgrade to conventional rod antennas, featuring a distinctive design that enhances the vehicle's sporty appearance. Functional shark fin antennas require connection to the car's internal wiring and can integrate various advanced automotive electronics like FM, GPS, and GSM systems.
6
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.