What is the reason for the yellow light flashing on the Axela ISTOP?

Is a cut on the tire shoulder serious?

If it's just a small cut on the tread pattern, it's not a big issue. However, if the cut is deep, you should avoid driving on highways. If the damage is on the sidewall, it's strongly advised not to drive on highways. The tire sidewall is relatively thin, and once damaged, it cannot be repaired and must be replaced. Due to its thinness, any damage can easily lead to a blowout from the affected area. Tire replacement indicators: 1. Tire wear: Tires have tread wear indicators, which are slightly raised marks located at the bottom of the tread grooves. If the tread rubber wears down to the same height as these raised marks, the tire should be replaced immediately as continued driving is no longer safe. 2. Tire damage: Hitting a curb, falling into a pothole, or puncturing a nail can cause severe damage to the tire. A damaged tire might be repairable, but only a professional repair shop can accurately determine whether the tire can be repaired or needs to be replaced. 3. Tire aging: If you notice tread deformation or significant cracking, stop using the tire immediately and have it inspected by a professional repair shop to determine if it can continue to be used.

8

5

Share

What does 1.2T mean in cars?

1.2T refers to a turbocharged engine with a displacement of 1.2 liters. The preceding number indicates the engine's displacement—1.2 means 1.2 liters—while the 'T' stands for turbocharging, indicating that the engine employs forced induction technology, typically turbocharging for small-displacement engines. More details about turbocharged engines are as follows: 1. A turbocharged engine relies on a turbocharger to increase the engine's air intake. The turbocharger (Turbo) is essentially an air compressor. 2. A turbocharged engine uses exhaust gases expelled by the engine to drive the turbine in the turbine housing (located in the exhaust passage). The turbine, in turn, drives the coaxial impeller in the intake passage, which compresses fresh air delivered through the air filter and sends it into the cylinders. As the engine speed increases, the exhaust gas flow rate and turbine speed also rise, enhancing the compression of air, thereby increasing the engine's air intake and consequently boosting its output power. 3. The greatest advantage of a turbocharged engine is that it can significantly increase power and torque without enlarging the engine's displacement. After installing a turbocharger, an engine's maximum output power can increase by approximately 40% or more compared to a non-turbocharged version.

6

3

Share

What is the trunk size of the BMW X1?

The trunk size of the BMW X1 has a depth ranging from 870 to 1780mm, a width from 1000 to 1320mm, and a height of 740mm. BMW X1 2021 xDrive25Li Premium Edition: It is a compact 5-door, 5-seat SUV equipped with an 8-speed automatic transmission. Its dimensions are 4565mm in length, 1821mm in width, and 1620mm in height, with a wheelbase of 2780mm. The engine of the BMW X1 2021 xDrive25Li Premium Edition has a maximum torque of 280 Nm, a maximum power of 141 Nm, a top speed of 217 km/h, and a fuel tank capacity of 61L. BMW X1 exterior design: The new model adopts the brand's family-style design language. The updated exterior design gives the vehicle a more robust front appearance, complemented by vertical accents that not only enhance visual impact but also exude a sense of premium quality.

10

4

Share

How Long Is the First Maintenance Interval for the All-New Bora?

The first maintenance for the Volkswagen New Bora should be performed within six months or 7,500 kilometers, whichever comes first. Below are the relevant details: 1. The first maintenance follows the 'whichever comes first' principle. However, it is advisable to perform the first maintenance earlier, as the engine undergoes a break-in period during which metal particles accumulate more quickly in the oil and oil filter, causing the oil to become dirty faster. Continuing to use the vehicle under these conditions can accelerate engine wear. 2. The New Bora's entire vehicle warranty covers two years or 60,000 kilometers (whichever comes first). For the 1.6L model, routine maintenance is recommended every 15,000 kilometers, while the 1.4TSI model should undergo maintenance every 10,000 kilometers, including oil and oil filter replacement. Within 60,000 kilometers, both models are advised to replace the fuel filter, cabin air filter, and spark plugs every 30,000 kilometers, and the transmission fluid every 60,000 kilometers. However, there is a difference in the replacement intervals for the air filter: the 1.6L model should replace it every 30,000 kilometers, while the 1.4TSI model should do so every 20,000 kilometers.

19

2

Share

Is a Car with 110,000 Kilometers Considered Old?

Based solely on the mileage of 110,000 kilometers, it cannot be considered an old car. If the odometer has not been tampered with, a model that has covered 100,000 kilometers over 10 years is relatively lightly used. This mileage typically represents the usage intensity of an average family car. With such usage intensity and proper maintenance, the vehicle is unlikely to encounter significant issues. Methods to determine whether a car is new are as follows: 1. Check the manufacturing date: The vehicle's manufacturing date should match the date on the certificate of conformity, which is usually difficult to alter. If the manufacturing date exceeds 15 days, it is considered an old car. 2. Inspect the brake discs: Most modern small passenger vehicles use disc brakes (at least for the front brakes), making the brake discs a reliable indicator. Generally, after driving more than 200 kilometers, the brake pads will leave noticeable marks on the brake discs. There is usually a 1-2 mm gap between the brake pads and the outer edge of the brake disc. After a certain distance is driven, a so-called 'step' will form on the outer edge of the brake disc (the 'step' on a new car is very low).

15

5

Share

How to adjust the chassis lifting of BMW X5?

BMW X5's chassis lifting is adjusted by the suspension airbags, achieved by altering the height of the shock absorbers in the suspension system. There are two main methods: one is adjusting the height of the air shock absorbers, and the other is adjusting the height of the hydraulic shock absorbers. Below is an introduction related to chassis lifting: 1. Automatic chassis lifting in cars refers to the ability of air suspension to either raise or lower the chassis. Depending on road conditions, the chassis can be lifted or lowered to achieve greater ground clearance or a lower center of gravity. This adjustment is typically accomplished through the suspension airbags. 2. Currently, there are two primary methods for adjusting a car's body height, both achieved by changing the height of the shock absorbers in the suspension system. The first method involves adjusting the height of air shock absorbers, while the second involves adjusting the height of hydraulic shock absorbers. 3. The technical condition of a car's chassis significantly impacts fuel consumption. Any increase in resistance within the chassis, such as heat or noise, can lead to greater power loss and higher fuel consumption. Therefore, maintaining proper chassis lubrication, performing regular maintenance, and ensuring correct adjustments to minimize internal resistance can help save fuel.

14

5

Share

What is the reason for the yellow light flashing on the Axela ISTOP?

Is a cut on the tire shoulder serious?

What does 1.2T mean in cars?

What is the trunk size of the BMW X1?

How Long Is the First Maintenance Interval for the All-New Bora?

Is a Car with 110,000 Kilometers Considered Old?

How to adjust the chassis lifting of BMW X5?

What brand is the Wuling 1.5t engine?

Where is the Tire Pressure Reset Button on the Yaris L?

How often should the battery of a Magotan be replaced?

Is Mazda a Joint Venture Car?