What is the reason for the wrench light flashing and failure to start in the Magotan?

1 Answers
LeReese
07/30/25 3:34am
Magotan's wrench light flashing and failure to start is due to the car not being serviced on time. The vehicle should be taken for regular maintenance immediately. If the owner has just completed the maintenance and the issue persists, it is likely that the maintenance technician forgot to reset the service mileage, and resetting it should resolve the problem. Method to eliminate the maintenance reminder light: Hold down the maintenance elimination shortcut button on the dashboard without releasing, press the vehicle's brake pedal, turn the key to the ON position, release the maintenance elimination shortcut button when the dashboard lights up again, and press it once more. Then press the OK button on the multifunction steering wheel to confirm the elimination. Functions of car maintenance: Filter impurities from the engine oil and gasoline to prevent them from entering the engine and affecting its normal operation. Regularly replacing these components can effectively extend the engine's service life, maintain the car's cleanliness, ensure normal technical conditions, eliminate potential hazards, prevent faults, and slow down the deterioration process.
Was this review help?
4
4
Share
More Forum Discussions

Is reversing into the parking space with the rear of the car over the line a deduction or a fail?

Body sweeping the line means the body is over the line, which results in a deduction of 100 points, making the test unsuccessful. Other actions that also result in a 100-point deduction include the vehicle crossing the line, not entering the parking space, stopping midway, not following the prescribed route, not following the sequence, or exceeding the prescribed time. The two subjects have a full score of 100 points, with evaluation criteria set for failure, 20-point deduction, 10-point deduction, and 5-point deduction. The rules for the subject two test of applying for a motor vehicle driver's license state that any mid-test stopping, rolling back, or not following the voice prompts will result in failure. Additionally, the wheels or body pressing the line will also result in test failure. Many students encounter the issue of pressing the line during subject two learning, with "pressing the line" being the most common mistake leading to failure. The main reason for wheels pressing the line is that students fail to grasp the correct timing for steering. Apart from missing the steering timing, another reason could be that the steering speed does not match the vehicle speed. Subject two deduction standards: Not wearing a seatbelt: 100-point deduction. Starting the engine without the gear in neutral: 100-point deduction. Not using the turn signal (including starting, changing lanes, overtaking, turning, and parking); using the turn signal for less than three seconds (note this is easily overlooked!); forgetting to turn off the turn signal or using it incorrectly: 10-point deduction. Stalling once: 10-point deduction. Reversing into the parking space: Not following the prescribed route sequence: 100-point deduction. Body over the line: 100-point deduction. Not fully reversing into the parking space: 100-point deduction. Before reversing, if the two front wheels do not pass the control line: 100-point deduction. Exceeding the 210-second time limit for the task: 100-point deduction. Stopping midway for more than 2 seconds: 5-point deduction each time. Slope parking and starting: After stopping, if the front bumper is not aligned with the pole line and exceeds 50cm front or back: 100-point deduction. After stopping, if the front bumper is not aligned with the pole line but does not exceed 50cm front or back: 10-point deduction. After stopping, if the starting time exceeds 30 seconds: 100-point deduction. Wheels pressing the road edge while driving: 100-point deduction. Rolling back more than 30cm when starting: 100-point deduction. After stopping, if the body is more than 50cm from the road edge: 100-point deduction. After parking, not tightening the parking brake: 10-point deduction per time. After stopping, if the body is more than 30cm but less than 50cm from the road edge: 10-point deduction per time. Rolling back more than 10cm but less than 30cm when starting: 5-point deduction per time. Parallel parking: After parking, if the body is over the line: 100-point deduction. Not using or incorrectly using the turn signal when entering the parking space: 10-point deduction. Exceeding the 90-second time limit for the task: 100-point deduction. Touching the parking space edge with the body while driving: 10-point deduction per time. Wheels pressing the lane edge while driving: 10-point deduction per time. Stopping midway for more than 2 seconds: 5-point deduction per time. 90-degree turn: Wheels pressing the road edge: 100-point deduction. Not using or incorrectly using the turn signal when turning, or not turning off the turn signal after turning: 10-point deduction. Stopping midway for more than 2 seconds: 5-point deduction per time. Curve driving: Wheels pressing the road edge: 100-point deduction. Stopping midway for more than 2 seconds: 100-point deduction. Driving without the gear in second or above: 5-point deduction.
7
2
Share

What Causes the Low-Pressure Pipe of Car Air Conditioning to Not Be Cold?

Car air conditioning low-pressure pipe not being cold is caused by: 1. Insufficient air conditioning refrigerant; 2. Inadequate air conditioning pressure or refrigerant line leakage. The car air conditioning system is a device that cools, heats, ventilates, and purifies the air inside the vehicle compartment. Its functions are: to provide a comfortable riding environment for passengers, reduce driver fatigue, and improve driving safety. The car air conditioning consists of a refrigeration system, heating system, air purification device, and control system, designed to adjust and control the temperature, humidity, air cleanliness, and air flow inside the vehicle compartment to an optimal state.
17
3
Share

What maintenance is required for a car at 15,000 kilometers?

Maintenance required for a car at 15,000 kilometers includes: 1. Engine oil and oil filter; 2. Engine oil; 3. Air filter; 4. Fuel filter. Inspection items for maintenance include: 1. Lighting, warning lights, turn signals, and car horn; 2. Performance of windshield wipers and cleaning devices; 3. Clutch pedal travel for manual transmission models; 4. Rear wheel hub bearing clearance and lubrication condition; 5. Condition of spark plugs; 6. Whether the seat belts are intact; 7. Whether the exhaust system is damaged; 8. Steering tie rod joint clearance, tightness, and dust cover sealing.
2
4
Share

What Octane Gasoline is Suitable for the Equinox?

The Equinox is suitable for 92-octane gasoline. Gasoline is a volatile, flammable hydrocarbon mixture liquid distilled or cracked from petroleum, used as fuel. The Equinox is a mid-size SUV produced by Chevrolet, with body dimensions of 4646mm in length, 1843mm in width, and 1684mm in height, a wheelbase of 2725mm, a fuel tank capacity of 56 liters, and a curb weight of 1535kg. The Equinox is equipped with a 1.5T turbocharged engine, delivering a maximum power of 124kW at 5600 rpm, paired with a 6-speed automatic transmission.
2
0
Share

How often should the brake fluid be replaced in an Audi A6?

Audi A6 brake fluid should be replaced every 2 years or 40,000 kilometers. Brake fluid is a liquid medium used in hydraulic braking systems to transmit braking pressure, employed in vehicles with hydraulic braking systems. Taking the 2004 Audi A6 as an example, its body dimensions are: length 4886 mm, width 1810 mm, height 1475 mm, wheelbase 2850 mm, minimum ground clearance 115 mm, and fuel tank capacity 70 liters. The 2004 Audi A6 is equipped with a 1.8T turbocharged engine, with a maximum power of 110 kW and a maximum torque of 210 Nm, paired with a 5-speed automatic transmission.
4
0
Share

What are the details of the Subject 3 driving test?

Details of the Subject 3 driving test are as follows: Detail 1: Before getting into the car for the test, remember to turn off your phone or set it to silent mode. If the phone rings during the test, the system may consider it cheating and cancel your results. Detail 2: After getting into the car, make sure to close the door tightly. Detail 3: During the light test, remember to respond within 5 seconds, otherwise you will fail immediately. After the light test, remember to turn off all the lights. Detail 4: When performing gear shifting operations, ensure that the gear matches the speed, and fully depress the clutch before shifting gears. Never look down while shifting gears, or you will fail immediately.
9
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.