What is the reason for the sudden loud noise in the Audi A6 as speed increases?

1 Answers
AdrianLynn
07/29/25 7:21pm
The reason for the sudden loud noise in the Audi A6 as speed increases is: wear of the sprocket bearing shaft head or transmission oil leakage and other faults. Applying soundproofing strips to doors and seams: For Audi A6 door frame soundproofing, you can use soundproofing cotton strips, soundproofing rubber strips, or soundproofing wool felt strips applied to the door frame seams to complete the door frame soundproofing. This can effectively suppress wind noise and some external noise. Installing trunk soundproofing: Applying soundproofing materials to the trunk of the Audi A6, as well as the wheel arch areas on both sides of the trunk, can effectively reduce tire noise, road noise, and exhaust noise. It will also significantly reduce low-frequency resonance noise caused by bass. Most of the tire and road noise during low-speed driving is suppressed, greatly improving the vehicle's stability. The feeling of rattling or falling apart when driving over uneven surfaces or potholes will disappear, and the vehicle's shock absorption and cushioning performance will also be noticeably improved.
Was this review help?
5
3
Share
More Forum Discussions

What to Bring for the First Maintenance of a New Car?

You need to bring the vehicle's driving certificate and the maintenance manual. If the car was purchased from a 4S store, check whether the maintenance manual has the 4S store's seal. If you have a free first maintenance card, you can go to a nearby same-brand 4S store for maintenance. If not, you need to go to the 4S store where you purchased the car for the first maintenance. Below is some information about car maintenance: 1. Maintenance Location: The first maintenance of the car must be completed at a 4S store of the car. All car manufacturers stipulate that only cars that have their first maintenance done at a 4S store can enjoy the car quality guarantee. However, the first maintenance does not necessarily have to be done at the 4S store where the car was purchased; it can also be completed at a same-brand 4S store, as all 4S stores are networked. 2. Maintenance Interval: The first maintenance of the car should be done within 5,000 kilometers or six months of driving. Generally, the best time for the first maintenance is when the car has been driven between 4,000 and 5,000 kilometers. If it exceeds six months, the 4S store will not perform the first maintenance.
14
4
Share

Which engine in the Weizhi is from Toyota?

The Weizhi 1.5L is equipped with the 5A engine, while the 1.3L model features the 8A+ engine, both of which belong to Toyota's A-series engines from Japan. Additionally, there are other models like the 4A and 6A. Here is some relevant information about the Weizhi: 1. A brief introduction to the Weizhi: The FAW Weizhi is powered by a four-cylinder, four-stroke, water-cooled, double overhead camshaft, 16-valve, electronically controlled fuel injection 8ACA4GB1 engine, paired with a mechanical 5-speed manual transmission. 2. Maintenance methods for the Weizhi engine: (1) Regularly clean the fuel system. During combustion, fuel inevitably forms deposits and carbon buildup in the fuel lines, carburetor, injectors, and combustion chamber, which can disrupt fuel flow, affect the air-fuel ratio, impair fuel atomization, and lead to engine issues like shaking, knocking, unstable idling, and poor acceleration. (2) Periodically clean the crankcase. While the engine is running, high-pressure unburned gases, acids, moisture, sulfur, and nitrogen oxides from the combustion chamber can enter the crankcase through the gap between the piston rings and cylinder walls, mixing with metal particles from wear and forming sludge.
16
4
Share

How to Downshift a Manual Transmission?

After reducing speed (specific speed depends on your judgment, but don't drop too much on highways—around 70-75 km/h is appropriate). Press the clutch and shift into neutral, pause for about two seconds, then shift into fourth gear, and slowly release the clutch. For low-speed driving when downshifting from third to second gear, it's simpler: just decelerate (or don't decelerate if preferred) and press the clutch directly. From third gear, push into neutral, wait two to three seconds, then shift into second gear while gradually releasing the clutch. Avoid releasing the clutch too quickly, as this may cause the car to jerk or lurch forward.
1
5
Share

How to Turn on the Heater in RAV4?

In the air conditioning control area, press the AUTO button to turn on the air conditioning system. Rotate the left knob to adjust the temperature. Turn it clockwise to set a temperature higher than the ambient temperature. Once the coolant temperature stabilizes, warm air will be blown out. Press the two fan icon buttons on the left and right to adjust the airflow intensity. Press the airflow direction icon button to select the desired vent direction. Switch between recirculation and fresh air modes to optimize cabin comfort. To proficiently operate the vehicle's heating system, it's essential to familiarize yourself with the air conditioning controls.
16
1
Share

How to Reset the Tire Pressure Monitoring Warning Light?

After the tire pressure indicator light comes on, you must safely pull over and check the tire pressure monitoring function on the car's navigation screen for any wheel abnormalities. Once it is confirmed that there is an issue with the wheels, we must check whether the tire pressure is too high or too low. If the alarm is triggered due to excessive tire pressure, you can release some air to bring the tire pressure back to the safe value. There is a tire pressure reset button; press it to reset the system. If the display indicates low tire pressure, you need to reset the system and then drive the car for a while. The tire pressure warning will then be cleared, and the issue will be resolved.
4
2
Share

What to Do If the Trunk of a Cruze Won't Open?

The reason why the trunk of a Cruze won't open may be due to a faulty trunk switch or a malfunctioning trunk lock mechanism. Methods to open the Cruze trunk: 1. Replace the lock: If the trunk door lock switch is broken, it may be caused by rainwater entering and corroding the trunk switch area. The failure rate is relatively high, and the only solution is to replace it with a new one. 2. Replace the lock mechanism If neither the remote control nor manual methods can open the trunk, it is likely that the trunk lock mechanism is faulty and needs to be replaced. Additionally, there is a master switch for the trunk lock above the lock mechanism. Be sure to check if the trunk not opening is due to the master switch being turned off. 3. Press the emergency escape switch There is an emergency escape switch above the Cruze trunk lock that can be pulled to open the trunk. This escape device is located at the lock cylinder of the trunk lock. On the upper part of the trunk lid, you will see a small cover. Pry open this cover to reveal a white pull tab inside. Pull this tab forcefully to trigger the switch, and the trunk will open automatically. Note that the method to open the trunk may vary depending on the brand and model of the vehicle.
18
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.