What is the reason for the simultaneous illumination of the tire pressure and ABS lights on the Volkswagen Bora?

1 Answers
Edward
07/30/25 2:12am
The reasons for the simultaneous illumination of the tire pressure and ABS lights on the Volkswagen Bora are: 1. Air in the system pipelines; 2. System computer malfunction; 3. Vehicle speed sensor failure; 4. ABS wiring harness breakage. The working principle of the ABS system is: During emergency braking, the highly sensitive wheel speed sensors installed on each wheel detect wheel lock-up, and the computer immediately controls the pressure regulator to release pressure from the wheel's brake caliper, preventing wheel lock-up. The functions of the ABS system are: 1. To prevent loss of vehicle control, increase braking distance, and improve vehicle safety; 2. To enhance the overall braking performance of the vehicle; 3. To prevent wheel lock-up during braking; 4. To ensure the driver can control the direction during braking and prevent rear axle skidding.
Was this review help?
7
5
Share
More Forum Discussions

How to Reset the Fault Light on Haojue Motorcycles?

Check the connection from the generator's excitation winding lead-out terminal through the brushes to the regulator, and inspect the connection from the generator's stator three-phase winding lead-out terminal through the diodes. First, identify the fault location. Generally, start by checking whether the contacts are burnt or dirty and not conducting, and whether the contact return spring is faulty.
16
1
Share

How to Sell a Car with an Outstanding Loan?

You can approach professional used car trading platforms to evaluate a similar model of used car and understand the approximate price range. When selling the car, you must bring the relevant documents. Without them, the ownership cannot be transferred, and the transaction cannot be completed. You can sell the car to friends or acquaintances, post sales information online, or sell it through used car trading platforms.
19
2
Share

What Causes Leakage at the Roof Light?

Roof leakage can be caused by the following reasons: 1. Sunroof leakage: There are generally two scenarios for sunroof leakage. One is that small sand particles or dust in the sunroof drainage channel cause blockages. The other is that the sunroof sealing strip has been "lifted" or displaced. Therefore, it is advisable to regularly clean the sunroof to maintain the cleanliness around the drainage channel. Additionally, during routine car washes, use high-pressure air jet equipment to blow air in the direction of the drainage pipes to remove any accumulated dirt. 2. Failure of automotive waterproof adhesive causing leakage: Leakage often occurs at the openings of doors and the trunk. This is mostly due to issues with the waterproof strips, such as deterioration, aging, or cracking of the rubber waterproof strips, allowing rainwater to seep in. Reapplying adhesive specifically designed for waterproof strips can completely prevent leakage. 3. Blocked drainage pipes causing interior leakage: The most common cause of interior leakage is the blockage of the drainage pipes beneath the front windshield. Infrequent car washing or prolonged parking under trees can lead to the accumulation of dust, leaves, mud, and other debris in the drainage pipes. Over time, these blockages can obstruct the pipes, preventing proper drainage. During heavy rain, water may backflow into the car, causing leakage. 4. Failure of floor plug seals causing leakage: While rainwater usually leaks from above, it can also seep in from below due to issues with the floor plug seals. The floor has several holes where plug seals are embedded from above. If these seals become misaligned, the interior becomes directly connected to the ground, allowing rainwater to seep in during heavy rain. If the floor gets wet, this should be the first area to suspect.
14
5
Share

How to Lock the Car Doors from Inside So Others Can't Open Them?

First, ensure the environment is safe and the temperature is suitable. Before locking the doors, remember to open the windows or sunroof to leave a ventilation gap. Next, locate the lock button on the driver's side door and press it. If there is no lock button, you can use the car key to lock the doors.
3
2
Share

How to Quickly Ventilate When Smoking in the Car?

You can slightly crack open the window on the side where you are sitting. The positive pressure inside the car will help push the smoke out efficiently, but avoid opening it too wide. This method of opening the window is highly practical as it allows for rapid air circulation inside the car, effectively eliminating odors. When driving at high speeds on the highway, it's best not to open the windows too much. If you need to ventilate, it's advisable to only open the window on the side where the odor is present.
13
3
Share

What to Do When Your Car's Fuel Consumption Increases After Long-Term Use?

Without disassembling the engine, use a specialized engine cleaner to remove carbon deposits and sludge from the engine, which can help reduce fuel consumption. After prolonged use of the air conditioning, it's important to clean the system promptly using an air conditioning cleaner. It's best to wash the car body regularly and apply wax treatment afterward to protect the paint.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.