What is the reason for the screw spinning in place and not coming out?

What are the differences between Lavida and Santana?

Santana and Lavida are both compact sedans under SAIC Volkswagen. The specific differences between them are as follows: 1. Vehicle price: The price range of Santana is 86,900 yuan to 115,900 yuan; The price range of Lavida is 107,900 yuan to 161,900 yuan. 2. Vehicle power: Santana is equipped with a 1.5L naturally aspirated engine across the entire lineup; Lavida offers not only a 1.5L naturally aspirated engine, but also optional 1.2L turbocharged and 1.4L turbocharged engines. 3. Body dimensions: The body dimensions of Santana are 4475*1706*1469mm; The body dimensions of Lavida are 4670*1806*1474mm.

1

5

Share

How to Remove the Lavida Electric Door Lock?

Lavida electric door lock removal steps are as follows: 1. Remove the door lock control device: When removing the lock, take off the fixing clip between the control device and the lock device. 2. Remove the door lock: Disconnect the central door lock wiring harness connector and the central door lock motor, unplug the wiring harness connector of the right rear door central door lock motor, and the removal is complete. 3. Install the lock: The installation method is the reverse of the removal method. Causes and solutions for Volkswagen Lavida door lock damage: The glass sealing strip is not tightly sealed, allowing water that seeps into the door to fall on the door lock motor, causing connector corrosion. Reinstall the door glass sealing strip to resolve the issue.

7

0

Share

Which button to press when there is fog in the car?

Press the front window defogger button when there is fog inside the car. When the temperature inside the car is higher than the outside temperature, fog forms. Here are some methods to remove fog: 1. Special defogging products: Spray this type of defogging agent on the inner surface of the car glass and wipe it clean. It not only removes dirt from the glass but also forms a transparent protective film on the glass, preventing water vapor from condensing and forming a fog layer. 2. Open windows for air circulation: If the fog is not heavy, you can open a gap in the windows on both sides (do not do this when it is raining). This allows air inside the car to circulate, and the temperature inside the car will gradually approach the outside temperature, causing the fog to dissipate.

1

Share

How to lock the rear trunk of Changan CS75?

To lock the rear trunk of the Changan CS75, simply close the trunk lid. Avoid using excessive force when closing, as this may cause component loosening over time. Below is an introduction to the functions of a car trunk: 1. Fully equipped tool kit: The trunk typically contains a spare tire, jack, headlight tools, warning triangle, first aid kit, etc. These are standard configurations in most vehicles. 2. Luggage storage net: When driving, small or fragile items can be difficult to organize neatly. Even if arranged properly, they may require re-packing after exiting the vehicle and risk damage from bumps. A trunk equipped with a luggage storage net eliminates these concerns and prevents unnecessary losses. 3. Trunk partition: Most hatchbacks, SUVs, and some MPV models come with a trunk partition as an original factory accessory. Installation points are reserved for this partition during manufacturing. The partition helps with visibility when reversing (even without a rearview camera) and prevents luggage from entering the passenger compartment during emergency braking, thereby protecting occupants from injury.

1

3

Share

What do the M and S gears mean?

M gear is the manual mode of the transmission. After shifting to M gear, you can manually control the upshift and downshift of the transmission. S gear is the sport mode of the car (S stands for sport). Many automatic transmission cars are equipped with S gear, and some high-end models of A-segment cars also have S gear design. The following are the introductions of other gears in automatic transmission cars: 1. P——Parking, the parking gear, also the starting gear. When the car is parked and not in use, the gear is in this position, and the wheels are mechanically locked to prevent rolling. 2. R——Reverse, the reverse gear. Used when reversing. 3. N——Neutral, the neutral gear. Used when temporarily parking. Note that this gear means neutral, and to prevent the car from rolling on a slope, you must step on the brake. 4. D——Drive, the forward gear, also known as the driving gear. Used when moving forward. 5. L——Low, the low gear. When going downhill or descending a long slope, shifting to this gear can limit the car's gear to only the lowest gear, allowing the car to use engine power for braking when going downhill, so the driver does not need to step on the brake for a long time, which could cause the brake pads to overheat and become dangerous. 6. OD——OD gear is the overdrive gear, used when driving at high speeds to achieve fuel-saving effects.

11

5

Share

What Causes Fluctuating Idle Speed After Throttle Body Cleaning?

Possible causes of fluctuating idle speed in a car include: 1. Excessive carbon buildup in the throttle body. 2. Leaks in the intake manifold or various valves. Such faults directly affect the quality of the fuel-air mixture and combustion efficiency. Potential leak points include the intake manifold, vacuum hoses, charcoal canister valve, exhaust gas recirculation (EGR) valve, positive crankcase ventilation (PCV) valve, etc., which require individual inspection. 3. Valve timing faults. Issues like incorrect valve timing, improperly installed timing belt, excessive carbon buildup on intake/exhaust valves, or broken valve springs can cause uneven air intake per cylinder, leading to unstable idle. 4. Clogged catalytic converter. A blocked catalytic converter not only causes idle fluctuation but also results in power loss. 5. Fuel injector malfunction. Problems like poor fuel atomization or clogged injectors may require injector cleaning. 6. Low fuel pressure. Mainly check for clogged fuel filters, fuel pump issues, or deformed fuel lines. 7. Engine misfire. 8. Incorrect ignition timing (too advanced or retarded). Mostly caused by faulty sensors such as MAF sensor, Hall effect sensor, knock sensor, or coolant temperature sensor, requiring diagnostic tool analysis.

4

0

Share

What is the reason for the screw spinning in place and not coming out?

What are the differences between Lavida and Santana?

How to Remove the Lavida Electric Door Lock?

Which button to press when there is fog in the car?

How to lock the rear trunk of Changan CS75?

What do the M and S gears mean?

What Causes Fluctuating Idle Speed After Throttle Body Cleaning?

What Causes the Engine Malfunction Light to Flash Frequently?

How to Verify the Authenticity of a Driver's License?

How to Deal with Headlight Scratches?

What does a range-extended electric vehicle mean?