What is the reason for the red triangle light to illuminate?

1 Answers
HaydenLee
07/30/25 9:03am
Introduction to the reasons for the red triangle light illumination: The car's dual-clutch transmission has experienced overheating, causing the fuel cut-off system to malfunction. Common warning lights in cars include the tire pressure warning light, engine coolant temperature indicator, oil pressure indicator, and brake system warning light. Below is an introduction to related content: 1. Tire pressure warning light: Used to indicate tire pressure. 2. Engine coolant temperature indicator: Used to display the engine coolant temperature. When the temperature is too high, the car should not continue to be driven. Additional information: These indicators are generally integrated into the car's dashboard. If any indicator light comes on, it means there is a fault in that system, and the driver needs to be vigilant and seek timely repairs.
Was this review help?
1
5
Share
More Forum Discussions

Where is the oil-water separator located on the Great Wall Fengjun 5?

The oil-water separator for the Fengjun 5 diesel vehicle is installed between the compressor outlet and the condenser inlet. Upon careful inspection of the engine compartment, the oil-water separator can be seen. Specific details are as follows: 1. Working principle: The oil-water separator operates by taking the high-pressure gas from the compressor, which includes the gaseous working medium and lubricating oil. After entering the exhaust valve, it flows into the guide vane of the exhaust valve, moving in a spiral pattern along the vane. Through centrifugal force and gravity, the lubricating oil is separated from the working medium gas and flows down along the inner wall of the cylinder. 2. Oil-water separator: The requirements for the working quality of the vehicle's exhaust valve include a large gas-liquid interface and a long retention time; the oil-gas mixture should be close to a phase equilibrium state. It should have good mechanical separation effects, with minimal liquid in the gas and minimal gas in the liquid. The oil-water separator improves the heat transfer effect in the condenser and evaporator through separation.
7
4
Share

What is the fuel consumption of the Chevrolet Blazer?

The fuel consumption of this vehicle is 10.6 liters per 100 kilometers. Below is relevant information about the Chevrolet Blazer: 1. Body dimensions: The Chevrolet Blazer is a mid-to-large-sized SUV under the Chevrolet brand, with a wheelbase of 2863 mm, and length, width, and height of 4999 mm, 1953 mm, and 1727 mm respectively. 2. Powertrain: The Chevrolet Blazer is equipped with a 2.0-liter turbocharged engine across all models, with the engine code LSY, which is a new 2.0T engine from the General Motors group. 3. 2.0-liter turbocharged engine: This engine in the Chevrolet Blazer delivers a maximum power of 174 kW and a maximum torque of 350 Nm. The engine reaches its peak power at 5000 rpm and its peak torque between 1500 to 4000 rpm. It features variable cylinder technology and direct fuel injection, with an aluminum alloy cylinder head and block. The engine is paired with a 9-speed automatic transmission (9AT), which enhances both ride comfort and fuel efficiency. 4. Configuration: The Chevrolet Blazer uses a MacPherson independent suspension at the front and a five-link independent suspension at the rear. The five-link independent suspension improves both ride comfort and handling performance.
17
2
Share

What does an exclamation mark in the car mean?

The appearance of an exclamation mark on the car dashboard indicates an abnormality or malfunction in the corresponding system. There are many indicator lights on the car dashboard with exclamation marks, such as the tire pressure indicator light, lighting fault indicator light, steering system fault indicator light, brake system fault light, transmission fault indicator light, and wiper fault indicator light. The following is a detailed introduction to the exclamation mark warning lights: General faults: A triangle with an exclamation mark inside. If this symbol lights up, it indicates a fault in the car's general performance or components and functions. Mainly includes parking sensor failure, fuel cut-off system intervention or failure, external light failure, engine oil pressure sensor failure, etc. It is necessary to go to a 4S shop for inspection to identify the source of the fault. Automatic transmission fault: A yellow gear with an exclamation mark inside. This is the automatic transmission fault warning light, indicating that there is a fault in the transmission or the transmission lubricant is below the normal range. The transmission oil should be replaced in time. Brake system fault: A circle with parentheses and an exclamation mark in the middle. This represents a warning for the brake system, mainly indicating a fault in the brake system or low brake fluid level. The brake system should be inspected immediately to avoid accidents. Tire pressure abnormality: A horizontal line under parentheses with an exclamation mark in the middle. This represents the tire pressure monitoring warning light, which lights up when the car's tire pressure is too low. Check the car's tire pressure and restore it to the normal range. Lighting fault: A yellow bulb with an exclamation mark. This is the lighting fault indicator light, indicating that a car light has failed. Solution: Go to a 4S shop for inspection as soon as possible, or check it yourself, focusing on commonly used bulbs such as turn signals, fog lights, and interior lights, to identify the problem. In addition, during daily use of the vehicle, the warning lights displayed on the vehicle dashboard are divided into two different colors, yellow and red: Yellow indicates that there is a fault in the corresponding system, but the problem is not very serious. It is necessary to slow down and proceed to the corresponding repair point for maintenance to eliminate potential safety hazards in time. Red indicates that there is a very serious problem in the corresponding system. In this case, do not continue driving. You should pull over immediately and call for professional help to prevent unpredictable dangers to the vehicle and personal safety caused by forced driving. It should be noted that when the car is started, all lights will turn on, and the system will perform an automatic check. After the check is completed, the lights will automatically turn off. If a light does not turn on when the ignition is turned on, or stays on without turning off, or lights up while driving, it indicates a fault in the related system. In such cases, professional help should be sought immediately for car inspection to eliminate potential safety hazards.
7
4
Share

How to activate the one-touch window lift for the Civic Sport?

The one-touch window lift function of the Civic Sport does not require activation and can be used directly after purchase. The features of the Civic Sport are as follows: 1. Keyless entry: When the owner approaches the door with the key, the key's inherent frequency matches the signal sent by the car's controller, allowing the owner to directly touch the one-touch lock button on the door handle to open the door. 2. Anti-pinch window function: When the AUTO button is pressed and the window automatically rises, if an obstacle is encountered, the window glass will stop rising and instead descend immediately. Additionally, upon sensing an obstacle, it will reduce the upward force.
8
3
Share

What is the oil specification for Toyota RAV4?

Toyota RAV4 uses engine oil with the specification 5W-40. The following is a detailed introduction to automotive engine oil usage: 1. The type of engine oil used in a vehicle should be determined by the engine it employs, as different types of oil serve different purposes and offer varying levels of engine protection. 2. There are three types of engine oil for vehicles: mineral oil, semi-synthetic oil, and fully synthetic oil. 3. For vehicles equipped with small-displacement naturally aspirated engines, mineral oil or semi-synthetic oil is recommended. For vehicles with turbocharged engines, fully synthetic oil or semi-synthetic oil should be used.
12
1
Share

Can Windshield Washer Fluid Be Diluted with Water?

Generally, windshield washer fluid does not need to be diluted with water and can be added directly. Below is relevant information about automotive windshield washer fluid: 1. Automotive windshield washer fluid is typically categorized into summer-use 0°C fluid and winter-use -20°C or -35°C fluid; 2. Automotive windshield washer fluid is made from deionized water combined with various environmentally friendly additives. It functions to clean, wet, prevent freezing, reduce static electricity, and resist corrosion, effectively removing dust, lubricants, gasoline, diesel, residual polishing wax, chewing gum, bird droppings, and highway insect residue; 3. It can quickly disperse rainwater on the windshield, preventing blurred vision for drivers during heavy rain.
2
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.