What is the reason for the non-illumination of the Haval H2 center control screen?

Can the weight of an electronic power steering wheel be adjusted?

Yes, the weight of an electronic power steering wheel can be adjusted. By adjusting the pressure of the hydraulic system, the weight of the hydraulic power assistance can be modified. Most vehicles have a pressure adjustment device near the outlet of the power steering pump. Hydraulic power steering wheels include both mechanical and electronic types. The differences between electric power steering and electro-hydraulic power steering: Electro-hydraulic power steering replaces the traditional hydraulic pump with an electric pump, which is controlled electronically; whereas electric power steering directly uses an electric motor to provide auxiliary torque, completely eliminating the hydraulic system. Electric power steering systems do not use power steering fluid and rely solely on the motor to provide steering torque, so there is no need to periodically replace the power steering fluid. Reasons for heavy steering: Insufficient tire pressure or changing tire models. Insufficient tire pressure increases the contact area between the tire and the ground, leading to greater lateral rotational friction, which makes steering heavier. The same principle applies when changing tire models. Steering gear failure. For example, water ingress causing jamming. The steering gear is located on the front axle, with dust covers on both sides, and there is also a dust cover where it connects to the steering column. If the dust cover is damaged or improperly sealed, moisture can enter the steering gear, causing rust and making steering heavier. For hydraulic power steering systems, dirty, insufficient, or air-contaminated power steering fluid can affect steering force. For electric power steering systems, the torque sensor may not be calibrated. Deformation of the front wheel suspension or abnormal wheel alignment (camber angle). Steering column jamming can also cause the steering wheel to feel heavy.

5

4

Share

How Many Kilometers Should You Replace the Belt?

A car typically has two belts: the timing belt and the accessory belt. The replacement interval for the timing belt is almost the same for all vehicles, generally around three years or 60,000 kilometers. When replacing the belt, the tensioner pulley and idler pulley should also be replaced simultaneously, as their lifespan is similar to that of the belt. Even if the tensioner pulley still functions at the moment, its remaining lifespan is uncertain. Here’s additional information: The replacement interval for the accessory belt varies significantly among different vehicle brands, ranging from 3-6 years or 60,000-100,000 kilometers. The exact replacement time should be checked in your vehicle’s maintenance manual. During replacement, the tensioner pulley and idler pulley should also be replaced, as their lifespan is comparable to the belt. If the tensioner or idler pulley fails, it may lead to belt damage or even breakage.

6

2

Share

Where is the position light switch located?

Generally on the left side, where the headlight switch is adjusted. Turning to the first light position activates the position lights. There are two lights each at the front and rear of the vehicle. The dashboard displays two opposing small bulb-like indicators lighting up. Position lights are the outermost lights at the front and rear of the vehicle. Large trucks also have position lights on the roof and sides. Literally, 'position light' implies a warning function. Here are additional details: Position lights are installed along the edges of the vehicle's roof, indicating both height and width. Safety regulations mandate installation for vehicles exceeding 3 meters in height. Position lights must be white at the front and red at the rear. Vehicles wider than 2.10m must be equipped with them, while those between 1.80-2.10m may have them optionally. Chassis with cabs may optionally install rear position lights.

14

0

Share

Can I start practicing driving only after passing the first subject of the driving test?

You need to pass the first subject of the driving test and obtain a learning driving certificate before you can start practicing driving. When learning to drive on the road, applicants should carry the learning driving certificate with them, use a coach car or a self-learning vehicle marked with a special driving practice identifier, and practice under the guidance of a coach or a designated instructor with the special driving practice identifier, following the routes and times specified by the traffic management department of the public security organ. Here is some additional information: Relevant regulations: According to Article 38 of the "Regulations on the Application and Use of Motor Vehicle Driving Licenses", applicants learning to drive on training grounds and roads must obtain a learning driving certificate as required. The learning driving certificate is valid for three years, and applicants must complete the second and third subjects of the driving test within the validity period. If the tests are not completed within the validity period, the passed subjects will be invalidated.

19

5

Share

What are the six actions when getting off the car in Subject 3?

Subject 3 involves six actions when getting off the car: shift to neutral, engage the handbrake, reset the right turn signal, turn off the engine, release the clutch and brake pedals, and unfasten the seatbelt. Below are some parking tips for Subject 3: Observe the right rearview mirror: Learners can also judge the distance by using the right rearview mirror. When the current door handle aligns with the right roadside line and the car body is parallel to the line, the vehicle is approximately 30cm away from the right line. Check the wiper: When the raised part of the wiper coincides with the right line, the car body is about 30cm away from the right line.

15

0

Share

Will the Subject 2 Test Add New Items on October 1st?

2020 October 1st did not add new items to the Subject 2 test. According to Article 25 of the 'Regulations on the Application and Use of Motor Vehicle Driving Licenses' (Ministry of Public Security Order No. 123), the Subject 2 test includes the following items for small cars, small automatic transmission cars, small automatic transmission passenger cars for the disabled, and low-speed trucks: reversing into a garage, stopping and starting on a slope (canceled from June 1, 2021), parallel parking, curve driving, and right-angle turning. Below is additional information: Passing criteria: The full score is 100 points, with evaluation standards set for failing, deducting 20 points, deducting 10 points, and deducting 5 points. The test is passed if the following conditions are met: For large passenger cars, tractors, city buses, medium-sized passenger cars, and large trucks, a score of 90 is required; for other vehicle types, a score of 80 is required.

19

0

Share

What is the reason for the non-illumination of the Haval H2 center control screen?

Can the weight of an electronic power steering wheel be adjusted?

How Many Kilometers Should You Replace the Belt?

Where is the position light switch located?

Can I start practicing driving only after passing the first subject of the driving test?

What are the six actions when getting off the car in Subject 3?

Will the Subject 2 Test Add New Items on October 1st?

Will Stomping on the Clutch Cause the Engine to Stall?

What are the reasons for an EFI scooter failing to start?

How long can an electric car be charged after getting wet?

What is the fuel tank capacity of a pickup truck in liters?