What is the reason for the non-display of the reversing camera in the Haval H6?
4 Answers
The reason for the non-display of the reversing camera in the Haval H6 may be due to damage or cracks in the camera or faults in the wiring. Below is an introduction to the 2021 Haval H6 National Tide Edition 1.5GDIT Automatic Luxury Version: Power System: Equipped with a 1.5L turbocharged 4-cylinder GW4B15A engine, paired with a 7-speed wet dual-clutch transmission. Body Dimensions: Length, width, and height are 4645mm, 1860mm, and 1720mm respectively. The wheelbase is 2680mm. Chassis: The drivetrain is front-wheel drive, with a front suspension of MacPherson independent suspension and a rear suspension of double-wishbone independent suspension.
I found that the Haval H6's reversing camera is not displaying, which could be due to several reasons. The most common issue is the camera lens being covered by dust or mud, especially after rainy days. Frequent opening and closing of the trunk may cause the camera's wiring connector to loosen, with wires at bends being most prone to breakage. Occasionally, the infotainment system might act up, similar to a frozen phone needing a restart. A blown fuse can also result in a complete loss of signal, which can be checked in the fuse box under the steering wheel. There's also the possibility that the camera itself is damaged from impact, particularly in vehicles where it's mounted low. It's advisable to start with simple fixes: clean the camera lens, restart the vehicle by turning it off and on, and inspect the wiring in the trunk. If these don't work, it's best to take it to a professional for inspection rather than attempting to dismantle the circuitry yourself.
A couple of days ago, my car's reversing camera suddenly stopped working. After fumbling around for a while, I finally figured out the issue. Turns out, the wires inside the rubber sleeve in the trunk had their insulation worn through, probably due to frequent opening and closing. If the camera lens gets dirty, just wipe it clean. If a fuse blows, you can replace it yourself—it's located in the small compartment in front of the passenger seat. In case the infotainment system freezes, simply disconnect the car's power for ten minutes and then try again. If the reversing lights also don't work, it might be a faulty reversing switch near the transmission. When handling these issues yourself, always prioritize safety—disconnecting the negative terminal of the battery before working on the wiring is the safest approach. If you can't pinpoint the problem, it's advisable to use a diagnostic tool to check for trouble codes for a more reliable solution.
A black screen on the reverse camera can be quite simple. The most common issue is a dirty camera lens—I often clean it with wet wipes. Wires near the trunk hinges are prone to breaking, so you need to peel back the rubber sleeve to check. Using the wrong fuse rating can cause burnout—stick to the factory 10-amp fuse and avoid swapping in a larger one. An outdated infotainment system version might occasionally cause conflicts, so an update usually fixes it. Check the camera's power cable near the license plate light if it's loose. If the parking sensors beep but there's no image when reversing, it’s likely a video cable issue. If other functions on the center screen work fine, that’s a clue. Don’t rush to replace it—inspecting the wiring connections is the most cost-effective fix.
