What is the reason for the malfunction of the Q5 lane change assist system?

Where does the vehicle body count as running a red light?

It is determined by capturing three photos with electronic cameras. The first photo shows the vehicle crossing the stop line at the intersection, including the red light and license plate number. The second photo shows the vehicle completely passing the stop line, including the red light and license plate number. The third photo shows the vehicle continuing to move, mainly by comparing the position change of the vehicle in the second photo, including the red light and license plate number. Capturing these three photos can determine that the vehicle ran a red light. Running a red light is clearly defined in the "Road Traffic Safety Law". Article 26 states that traffic signals consist of red, green, and yellow lights. A red light indicates prohibition of passage, a green light indicates permission to pass, and a yellow light serves as a warning. A red light is a traffic signal prohibiting passage, and if a vehicle passes through an intersection during a red light, it constitutes the traffic violation of running a red light. Six situations of running a red light: Stopping immediately after crossing the line at a red light (when the red light is on, the vehicle cannot stop in time, and the front of the vehicle crosses the stop line): If the vehicle only just crosses the stop line during a red light but stops immediately, this act of running a red light will not be penalized. However, if there is obvious movement after crossing the line, it will be penalized. The three photos captured by the electronic eye for running a red light are: the front wheels crossing the stop line, the rear wheels crossing the stop line, and the front wheels crossing the opposite stop line. Only when these three photos are complete will it be considered running a red light. According to Article 10 of the "Regulations on the Handling Procedures for Road Traffic Safety Violations", this will result in a deduction of 6 points. Running a red light under the direction of a traffic officer (the signal is red, but the traffic officer on duty indicates permission to pass): When there is a conflict between the traffic signal and the traffic officer's gesture, the driver must obey the on-site command of the traffic officer. If the driver runs a red light due to the traffic officer's on-site command, the driver can obtain a diversion certificate from the local traffic police station to avoid penalties. If the party disagrees with the penalty, they can appeal through administrative reconsideration or administrative litigation. Stopping after the entire vehicle body crosses the line at a red light (failing to brake in time, causing the entire vehicle body to cross the stop line): If the entire vehicle crosses the stop line and does not continue to move, this does not count as running a red light. Reversing after crossing the line (attempting to avoid penalties by reversing after crossing the line at a red light): Motor vehicles are not allowed to reverse at railway crossings, intersections, one-way roads, bridges, sharp curves, steep slopes, or tunnels. If a vehicle reverses illegally, it may be subject to a warning or fine. Mistakenly running a red light behind a large vehicle (due to the large vehicle blocking the view, following it through the intersection): Drivers must maintain sufficient visibility to see the traffic signals ahead and ensure a safe braking distance. Generally, if a motor vehicle is photographed following a large vehicle, it is because it rushed through the intersection to catch the signal. This behavior can only be penalized as running a red light. Passing through the intersection during a yellow light (passing through the intersection when the signal turns yellow): The traffic police department states that according to the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China", when the yellow light at an intersection is flashing, vehicles that have already crossed the stop line can continue to pass. If the yellow light is already on and the vehicle continues to rush through, it will be considered running a red light if photographed.

19

4

Share

What does TC mean in cars?

TC in cars stands for Traction Control System, which improves the vehicle's passability. When the ABS anti-lock braking system detects that some wheels are slipping, it applies braking to the slipping wheels to prevent the loss of traction on those wheels. When the system is active, a yellow TC indicator light on the dashboard flashes to alert the driver. TC: The full English name is Traction Control System, translated into Chinese as the anti-slip tracking control system. When the ABS anti-lock braking system detects that some wheels are slipping, it applies braking to the slipping wheels to prevent the loss of traction on those wheels. Traction Control System: Also known as the tracking control system. When a car brakes on a slippery surface, the wheels may slip, even causing loss of directional control. Similarly, during acceleration or sudden acceleration, the drive wheels may also slip, which can be dangerous on icy or other slippery surfaces by causing loss of directional control. The Traction Control System is designed to address this issue. The system relies on electronic sensors to detect when the driven wheels' speed is lower than that of the drive wheels (indicating slip), and then sends a signal to adjust ignition timing, reduce throttle opening, decrease fuel supply, downshift, or apply braking to the wheels, thereby preventing further slipping. The Traction Control System not only enhances driving stability but also improves acceleration and climbing ability.

11

4

Share

Why is the antifreeze level decreasing?

Reasons for decreasing antifreeze level: 1. Normal evaporation: Under the continuous high temperature of the engine, some antifreeze will inevitably evaporate, but the amount is usually minimal; 2. Faulty leakage: Damage to the radiator gasket or loosening of the overflow tank, water pump joint surface, and pipe connections in the cooling system can lead to antifreeze leakage; 3. Antifreeze entering the cylinder and participating in combustion, such as due to cylinder cracks, gasket erosion, or corrosion deformation. In such cases, check the oil dipstick for any emulsification. Antifreeze, also known as coolant, is designed to prevent freezing, ensuring the cooling system remains operational during cold winter temperatures without freezing.

5

2

Share

What is crugen tire?

crugen is a brand under the South Korean Kumho Tire company. As a high-performance urban off-road comfort tire, the Kumho CRUGEN features a longitudinal wave-like tread pattern design complemented by distinctive transverse capillary grooves. This semi-grooved design delivers notable noise reduction effects - during driving, the transverse capillary grooves filter out most rolling noise, providing excellent quiet comfort. Tires are circular elastic rubber products mounted on various vehicles or machinery to roll on surfaces, typically installed on metal rims. They support the vehicle body, cushion external impacts, maintain contact with the road surface, and ensure driving performance.

16

4

Share

How Often Should Car Window Tint Be Replaced?

Car window tint generally needs to be replaced every three years. Precautions for car window tinting: 1. After tinting, try to park the car in a sunny place to ensure sufficient evaporation of moisture under the film; 2. When stains are found on the tint, avoid using sharp or hard objects to scratch it, and do not use corrosive sprays to wipe it; 3. Avoid washing the car for a few days after tinting, as washing it prematurely may cause the film to peel off. Also, do not activate the rear window defroster for a week, as the heat generated can deform the tint. Car window tinting involves applying a thin film to the front and rear windshields, side windows, and sunroof. This film is also known as solar film or heat-insulating film. It helps reduce damage to interior items and passengers caused by UV rays, lowers the interior temperature through physical reflection, reduces the use of car air conditioning, thereby decreasing fuel consumption and saving costs.

12

0

Share

Where to Add Windshield Washer Fluid in the Encore?

Windshield washer fluid is added to the reservoir located at the bottom left corner of the engine compartment, which has a cap marked with a washer symbol. Here are some key points to note when adding windshield washer fluid to your car: Characteristics of your vehicle: Each car has different requirements for windshield washer fluid, such as concentration, molecular weight specifications, and the pressure it can provide. Only by understanding these factors can you make proper use of the washer fluid. These specifications should be based on your car's standards, usually detailed in the owner's manual, which may also include an introduction to the electrical circuits in the wiper system. Choosing windshield washer fluid: Depending on the car model, certain types of windshield washer fluid may be recommended for sale. This type of fluid can be added directly. If not available, you may need to purchase washer fluid and mix it in a certain proportion. When filling, remember not to overfill the reservoir—you can always add more if needed. Overfilling may cause issues. Additionally, try to use the same brand of washer fluid to minimize the risk of clogging the related pipes.

18

5

Share

What is the reason for the malfunction of the Q5 lane change assist system?

Where does the vehicle body count as running a red light?

What does TC mean in cars?

Why is the antifreeze level decreasing?

What is crugen tire?

How Often Should Car Window Tint Be Replaced?

Where to Add Windshield Washer Fluid in the Encore?

Is It Normal for Wheel Brake Discs to Rust?

Is the Taurus an imported model?

What is the battery model for Lavida?

Can the car be transferred if the owner is not present?