What is the reason for the Golf tire pressure warning but no visible abnormality in the tires?

2 Answers
SanGiselle
07/29/25 2:30pm
Golf tire pressure warning but no visible abnormality in the tires is caused by: 1. Extremely slow tire leakage; 2. False alarm due to tire pressure system malfunction. The solutions are: 1. Monitor the tire condition at all times and go to the repair shop for inspection if necessary; 2. There is a SET button in the car control panel settings for tire pressure reset, which can manually turn off the warning light. Taking the Volkswagen Golf 2021 200TSI DSG as an example, this car belongs to the compact car category and is a 5-door, 5-seat hatchback with a length, width, and height of 4296mm, 1788mm, and 1471mm respectively. It is equipped with a 1.2T inline four-cylinder turbocharged engine, with a maximum power of 85kW, a maximum torque of 200Nm, a maximum horsepower of 116PS, and a top speed of 200km/h.
Was this review help?
8
2
Share
KhloeLynn
08/13/25 6:51am
I've also driven a Golf and encountered the issue where the tire pressure warning light comes on but the tires are actually fine. This is quite common, and the reason usually lies with the TPMS sensor acting up: either the battery is drained from prolonged use and can't send signals, or the sensor itself is faulty and needs replacement. Large temperature fluctuations can also interfere—for example, when starting the car cold in the morning, the lower air pressure may trigger a false alarm. The Golf's tire pressure system requires a manual reset: drive to a gas station, measure the pressure to confirm it's at the standard value (e.g., 35 psi when cold), then locate the tire pressure monitoring reset button in the central control menu under "Vehicle Settings" or "Service" and press it. If the light stays on after resetting, the sensor might be aging or misplaced, and it's best to visit a professional shop to check for error codes with a diagnostic tool. Don't ignore it—safety first, as you might overlook a real leak.
Was this review help?
12
0
Share
Expand All
More Forum Discussions

Why is the Mercedes Parking Assist System Not Working?

Mercedes Parking Assist System may stop working due to the following reasons: use of a temporary spare tire; damaged sensors or bumper; sensors being blocked by components installed on the vehicle, such as bumper covers; the vehicle being used to transport loads exceeding its capacity. More details are as follows: 1. Parking Assist System: This system includes ultrasonic sensors embedded in the front and rear bumpers, with each sensor having a diameter of approximately 15mm. The ultrasonic signals emitted by the sensors reflect when they encounter obstacles. Upon receiving the reflected signals, the sensors promptly feed them back to the system for distance calculation. The system then alerts the driver about the distance to obstacles outside the visible range through sound or video. 2. Verifying the Fault After Receiving the Vehicle: When shifting the transmission into R (Reverse) gear, it was observed that the red indicator light on the Parking Assist System (PTS) button illuminated, and neither the front nor rear parking warning indicators responded, indicating that the parking assist system was in a disabled state.
16
3
Share

What Causes the Car Starter Motor to Not Respond?

Here are the specific reasons why a car starter motor may not respond: 1. Severe wear of starter carbon brushes: The symptom during startup is weak cranking, where the crankshaft rotation is visibly slow through the belt and pulley. When the wear is extremely severe, the starter cannot rotate the crankshaft at all, producing only an electric current sound. 2. Fault in the starter control mechanism: Apart from the starter motor, the starter assembly includes an electromagnetic control mechanism. When this mechanism fails, the pinion gear cannot engage with the flywheel gear, preventing engine startup. The symptom is turning the ignition key and hearing only the high-speed rotation sound of the starter without the sound of the engine crankshaft flywheel operating. 3. Damage to the starter clutch: Typically, the starter operates at around 120r/min, while the engine idles at approximately 900r/min after starting. The clutch prevents the engine from driving the starter if the driver fails to release the key promptly after startup, keeping the pinion and flywheel gears engaged, which could lead to starter burnout.
20
5
Share

Is a Wading Vehicle Considered a Flood-Damaged Car?

Wading vehicles are not considered flood-damaged cars. Flood-damaged cars generally refer to vehicles that have been soaked in water, typically where the wiring harness has been submerged, the water depth exceeds one-third of the wheel height, and the bottom components of the vehicle have been in prolonged contact with water. Below is additional information: 1. Flood-damaged cars: There is no strict definition for flood-damaged cars, but generally, if key components like the engine have accumulated water and internal parts are damaged, it can be considered a flood-damaged car. 2. Wading vehicles: Wading refers to driving through low-lying, waterlogged roads, typically during rainy weather when poor drainage leads to water accumulation in low-lying areas.
7
5
Share

What brand is the zeekr001?

zeekr001 is a model under the ZEEKR brand. Here are specific details about ZEEKR: 1. Introduction: ZEEKR, positioned as a trendy technology brand, represents an uncompromising pursuit of extreme product performance and user experience. ZE stands for ZERO, symbolizing both the starting point and the infinite possibilities at the end. E represents Electric (electricity)-Evolution (evolution)-Era (era), signifying the evolution of the electric-driven era. 2. Configuration: In terms of driving performance, ZEEKR is equipped with the Permanent Magnet Dual Motor System, capable of achieving full-scenario autonomous driving assistance. It also features luxury configurations such as a fully automatic air suspension, dynamic chassis control system, and sensor-activated frameless automatic doors.
1
5
Share

Does driving with the VVT valve disconnected consume more fuel?

Driving with the VVT valve disconnected consumes more fuel. Definition of the VVT valve: It refers to the Variable Valve Timing system, a technology used in automotive piston engines. The Variable Valve Timing system (OCV/VCT) consists of an electromagnetic valve (OCV) and a Variable Camshaft Timing (VCT) adjuster. By adjusting the camshaft phase of the engine, the intake volume can change with the engine speed, achieving optimal combustion efficiency and improving fuel economy. Working principle of the VVT valve: The crankshaft drives the camshaft through a timing belt, gears, or chain. The profile and position of the cam lobes on the camshaft are typically optimized for specific engine speeds, which usually reduces torque at low speeds and power at high speeds.
3
2
Share

Is a car that has been driven for half a year considered new?

A car that has been driven for half a year is not considered new. Definition of a new car: The most basic concept of a new car is that it has not been registered, insured, or titled. Such a car can generally be classified as new. Mileage is not necessarily the determining factor, as some vehicles may be transferred from another location and driven a long distance without being transported by a carrier. However, if a car has been registered or insured, and its usage data or information can be traced, it is classified as a used car. New car inspection cycle: New cars are exempt from inspection for the first six years. From the sixth to the tenth year, they require an on-site inspection every two years. After ten years, they must undergo an annual on-site inspection.
2
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.