What is the reason for the GLC's horn being prone to water ingress?

What does the yellow ABS light mean?

When the ABS light is displayed on a car, it indicates a malfunction in the vehicle's Anti-lock Braking System. During emergency braking, if the wheels lock up, the vehicle may lose control and skid, preventing the driver from slowing down or adjusting the vehicle's trajectory, which poses significant safety risks. There are various states in which the ABS light may illuminate, with different causes and solutions for each state. The details are as follows: State 1: ABS warning light stays on (most common). Cause 1: The ABS wheel speed sensor's sensing area is covered by dirt, mud, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from determining the vehicle speed and the wheel's slip rate, thus failing to issue appropriate commands to regulate braking. Solution: Clean the dirt from the wheel speed sensor and adjust the gap between the sensor and the signal ring to restore normal function. Cause 2: Loose connections in the system wiring or poor contact in the ABS relay can lead to signal issues and system failure. Solution: Check the wiring connections and reconnect any loose parts. State 2: ABS warning light intermittently illuminates but turns off when accelerating. Cause: When multiple vehicle electrical devices are in use, the battery voltage may drop below 10.5V. As the engine speed increases and the voltage rises, the ABS light turns off. This can also occur if the ABS system's power supply voltage is too low due to poor contact or grounding issues. Solution: Check the battery's specific gravity; inspect the charging system; examine the power supply (e.g., voltage relay or poor power contact). State 3: ABS warning light stays on after engine start and only turns off when the engine is turned off (IGFF). Cause: Poor grounding contact in the ABS hydraulic valve body; loose wiring connections in the ABS hydraulic valve body; ABS computer malfunction. Solution: Loosen and then retighten the grounding screws on the hydraulic valve body, cleaning the contact surfaces if necessary; check for enlarged gaps in the connectors; replace the ABS or ABS/ASR computer. State 4: ABS warning light illuminates during high-speed driving. Cause: During high-speed driving, the ABS computer detects a significant discrepancy between the rear and front wheel speed signals; incorrect tire or wheel rim specifications. Solution: Refer to the vehicle's tire and wheel rim specifications, as indicated on the label near the fuel tank cap. State 5: ABS warning light intermittently illuminates. Cause: Improper adjustment of the brake light switch; poor internal contact in the brake light. Solution: With the engine running, press the brake pedal and use a finger to push the brake switch linkage all the way down, then release the brake pedal to complete the self-setting position; replace the brake light switch if necessary.

14

4

Share

What is the fuel consumption of the Geely Vision X1?

Geely Vision X1 has a total of 4 models. Among them, the 2017 1.0L manual Youth Edition model equipped with a 68 horsepower engine has an NEDC fuel consumption of 5.1L per 100 kilometers. The other three models, including the 2017 1.3L manual Fun Edition, are equipped with an 88 horsepower engine and have an NEDC fuel consumption of 5.3L per 100 kilometers. The fuel tank capacity of different Geely Vision X1 models varies, and the distance that can be covered on a full tank of fuel is as follows: Models equipped with a 68 horsepower engine have a fuel tank capacity of 35L, and the distance that can be covered on a full tank is 35/5.1*100=686KM. Models equipped with an 88 horsepower engine have a fuel tank capacity of 35L, and the distance that can be covered on a full tank is 35/5.3*100=660KM. The fuel consumption of a car is directly related to five major factors: driving habits, the car itself, road conditions, natural wind, and environmental temperature. Specific factors that can increase fuel consumption are as follows: Driving habits: Aggressive driving, such as sudden acceleration, frequent overtaking, and not easing off the throttle before a red light, can increase fuel consumption. The car itself: Cars with larger engine displacements generally consume more fuel than those with smaller displacements because larger displacements usually mean higher power, requiring more gasoline to burn and perform work. Heavier cars also consume more fuel because greater weight requires more driving torque. Road conditions: Driving on dirt roads, muddy roads, soft surfaces, or mountainous roads increases resistance and fuel consumption. Natural wind: Driving against the wind or on windy days increases the car's resistance and fuel consumption. Low environmental temperatures: When the engine block temperature is low, the gasoline injected during a cold start does not atomize easily, requiring more gasoline to be injected for combustion, which increases fuel consumption. Additionally, at low temperatures, the engine's computer will control the engine to run at higher RPMs to warm up, which also increases fuel consumption.

16

1

Share

What Brand is Karlmann?

Karlmann is a brand under IAT, an independent Chinese automotive brand. Here are some key details about Karlmann: 1. Positioning: Karlmann is a high-end customized vehicle, with only ten units produced globally. It was designed in Europe and manufactured in Germany, classified as a super SUV model. 2. Powertrain: The vehicle is equipped with a 6.8-liter V10 engine, which is fitting for such a massive vehicle. 3. Exterior: The overall design of the vehicle incorporates sharp, angular lines, ensuring it stands out and turns heads when driven in urban settings.

2

5

Share

Can partial polishing be done?

Minor scratches can be treated with partial polishing, but this is only a temporary solution. Because polishing will inevitably damage the paint surface, after two times the paint will become very thin. After polishing, regular waxing is necessary, otherwise the paint surface will quickly develop cracks, become matte, or fade due to aging. Benefits of polishing: For vehicle paint surfaces that are oxidized, dull, or have scratches, polishing can remove oxides and contaminants, restoring the cleanliness of the paint surface. Drawbacks of polishing: Polishing will thin the car paint, and if not done carefully, it may even polish through to the primer.

2

0

Share

What are the signs of a failing transmission?

Signs of a failing transmission include: 1. Gear shifting impacts or jerks during driving; 2. Engine revs without acceleration when accelerating; 3. Overheating transmission fluid emitting unusual odors; 4. Gear shifting takes too long or too short. Functions of a transmission: 1. Allows the vehicle to reverse without changing the engine's rotation direction; 2. Interrupts power transmission with neutral gear, enabling engine start, idling, and facilitating gear shifting or power output; 3. Changes the transmission ratio to expand the range of torque and speed variations of the driving wheels, adapting to frequently changing driving conditions while keeping the engine operating under favorable conditions.

11

1

Share

How Thick Should Rubber Shock Absorber Pads Be to Be Effective?

Rubber shock absorber pads can function as long as they are dust-free. Here is some information about rubber shock absorber pads: 1. Function: Rubber shock absorber pads have excellent elasticity and shock absorption effects, as well as impact mitigation capabilities. They can be applied to shock absorbers based on size and shape. They are highly adaptable, very sturdy, and do not deform when adhered to the ground, making them popular among many users. 2. Production: Rubber shock absorber pads are manufactured according to user requirements, and the produced pads may vary depending on different customer needs.

10

2

Share

What is the reason for the GLC's horn being prone to water ingress?

What does the yellow ABS light mean?

What is the fuel consumption of the Geely Vision X1?

What Brand is Karlmann?

Can partial polishing be done?

What are the signs of a failing transmission?

How Thick Should Rubber Shock Absorber Pads Be to Be Effective?

BYD Tang DM Highway Fuel Consumption?

Does the Buick GL8 have a hybrid version?

Can a Truck Run Without Urea?

Where is the MG car engine from?