What is the reason for the engine fault light coming on and then turning off after restarting?

Will points be deducted for not wearing a seat belt?

Points will be deducted for not wearing a seat belt. If caught by electronic surveillance, the violation can generally be detected within two to three days, as these records require manual review (electronic captures involve data collection, organization, review, entry, transmission, and final manual verification), but it should not exceed 15 days at the latest. Below is an introduction to the point deductions for not wearing a seat belt on various roads: When driving on urban expressways: When driving on urban expressways, if the driver fails to wear a seat belt as required, 2 points will be deducted. When driving on roads other than highways or urban expressways: When driving on roads other than highways or urban expressways, if the driver fails to wear a seat belt as required, 2 points will be deducted. Driving in urban areas with speed limits below 50 km/h without wearing a seat belt: When driving a motor vehicle in urban areas with speed limits below 50 km/h, if passengers fail to wear a seat belt as required and correct the behavior immediately after being pointed out, they will receive a verbal warning.

1

5

Share

Where is the cigarette lighter located in the Geely Boyue?

The Geely Boyue is equipped with three power outlets for cigarette lighters, located in the center console armrest, the rear air vent area, and the trunk. The metal outer shell of the cigarette lighter serves as the negative terminal, while the central heating wire acts as the positive terminal. When the lighter is inserted and pressed down to lock, the heating element contacts the positive terminal of the socket, initiating the heating process. Once the heating element reaches the required temperature, the temperature-sensitive spring deforms, releasing the lighter, which then pops out. Here’s how to use the cigarette lighter: Open the car door: Sit in the driver’s seat and locate any of the three cigarette lighters. Press the cigarette lighter to heat: When you need to light a cigarette, press the lighter down. Wait for it to heat up, after which it will automatically pop out with the other end glowing red, ready for use. Additionally, adjust the spring angle of the voltage regulator moderately—just enough to lock the lighter in place for heating. Avoid excessive angles, as they may hinder insertion and removal. Insert and remove the lighter vertically without shaking it, as frequent wiggling during removal can lead to loosening, short circuits, and damage to fuses or external devices.

17

3

Share

What is the reason for the Mercedes-Benz brake pad wear warning?

The reasons for the Mercedes-Benz brake pad wear warning are: 1. The brake pads have worn down to the warning position. The brake pads are equipped with a metal piece for warning purposes. When the brake pads become thin, the metal piece generates abnormal noise, indicating that replacement is needed; 2. There is a warning circuit embedded between the friction material of the brake pads and the metal backing plate. When the brake pads wear down to a certain thickness, the warning circuit is worn through, creating an open circuit, which triggers the brake pad warning. Taking the Mercedes-Benz C-Class 2021 model as an example, it belongs to the mid-size car category, with body dimensions of: length 4784mm, width 1810mm, height 1457mm, and a wheelbase of 2920mm. The fuel tank capacity is 66 liters. The Mercedes-Benz C-Class 2021 model features a multi-link independent suspension at the front and a multi-link independent suspension at the rear. It is equipped with a 1.5L turbocharged engine, delivering a maximum horsepower of 156PS, a maximum power of 115kW, and a maximum torque of 250Nm, paired with an automatic transmission.

13

1

Share

What is the process of the Subject 3 driving test?

Subject 3 road driving skills test generally includes: preparation before getting on the car, simulated lighting test, starting, driving in a straight line, shifting gears, changing lanes, parking by the side of the road, going straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school zones, passing bus stops, meeting oncoming vehicles, overtaking, making U-turns, and driving at night. The safety and civilized driving knowledge test generally includes: safety and civilized driving operation requirements, safe driving knowledge under adverse weather and complex road conditions, emergency handling methods for situations such as tire blowouts, and post-accident handling knowledge. Basic test precautions: Students are strictly prohibited from getting off the car during the test. You can only get off the car after the results are announced. Students must strictly follow the voice prompts in the test car during the test. Starting essentials: strictly follow the operation steps. Turn signals must be turned on 3 seconds in advance when starting, turning left (right), changing lanes, making U-turns, or parking by the side of the road; (count silently for 3 seconds) If the turn signal is not used or is used for less than 3 seconds, "turning without using the turn signal or turning less than 3 seconds after turning on the turn signal", 10 points will be deducted.

10

1

Share

How Long After Car Paint Repair Can You Leave?

For small-area quick paint repairs, the car can be driven away on the same day. However, for large-area spray painting, it typically takes about 2 days before the car can be driven. It is important to note that after paint repair, the repaired areas should avoid contact with corrosive cleaners such as adhesive removers or asphalt removers, as these can severely melt the newly applied paint. Precautions during paint repair: Always go to a specialized large repair shop or a dedicated repair shop, and avoid choosing repair shops without dedicated paint drying rooms. The color of the repair paint is mixed before the repair. As the vehicle is driven, the paint gradually fades, which may not be noticeable to the naked eye. However, under outdoor sunlight, the degree of fading may vary slightly from different angles. To match the original color as closely as possible, the paint must be mixed on the spot. Precautions after paint repair: Do not use high-pressure water to wash the car body directly. The hardness of the repaired paint is lower compared to the original factory paint, and excessive water pressure can damage the car's paint surface. Avoid using random cleaning agents. While driving, the car may accumulate asphalt, oil stains, or insects, which should be handled with care. Check if the paint color matches the original car paint. Even if it's not 100% identical, it should be largely consistent with the original factory paint color. This can be checked under sunlight, as color is greatly affected by light. Inspect the smoothness of the paint surface. A normal paint surface should have no pitting, impurities, or dripping paint.

8

1

Share

What does Raptor aux1234 mean?

AUX is an audio input interface. The basic working principle of the AUX interface is that after connecting to the AUX interface, the audio in electronic products can be connected to the car audio through the headphone jack and AUX interface, allowing the audio to be played on the car audio broadcasting facilities. The USB interface can be used to insert a USB drive to play audio. When using it, insert one end into the AUX interface and connect the other end to a mobile phone, MP3, MP4, or other video players. This allows you to listen to songs or niche music anytime, anywhere, without being limited to car music discs. However, if the playback device runs out of power, the music will also stop (the interface is generally a 3.5mm labeled headphone jack). Aux is the abbreviation for Auxiliary, which refers to an additional signal line design. In general audio equipment, besides the standard output and input terminals, there are often several terminals labeled Aux, serving as backup connection points. When there is a special application, such as requiring additional audio output or input, these terminals can be used. These backup terminals or lines, whether for input or output, are collectively referred to as Aux. Function: The AUX port is an asynchronous port, mainly used for remote configuration, dial-up connections, or connecting with a MODEM via a transceiver. It supports hardware flow control. The AUX port and CONSOLE port are usually placed together because their respective applicable configuration environments differ. The AUX interface establishes a command-line connection between the user and the device, enabling operations that are usually impossible in user mode, such as initialization, restoring default configurations, or correcting abnormal user modes. It provides a fixed port for the device, which can be used as a standard asynchronous serial port with a maximum speed of 115200bit/s. Using the AUX interface, remote configuration and line backup functions for hardware products can be achieved. Note: When using the AUX interface, ensure you purchase the correct connecting cable and avoid plugging the audio cable into the wrong port. It is best to follow the steps outlined in the product's user manual. If you are still unsure, consult the product's official website or call for assistance.

1

3

Share

What is the reason for the engine fault light coming on and then turning off after restarting?

Will points be deducted for not wearing a seat belt?

Where is the cigarette lighter located in the Geely Boyue?

What is the reason for the Mercedes-Benz brake pad wear warning?

What is the process of the Subject 3 driving test?

How Long After Car Paint Repair Can You Leave?

What does Raptor aux1234 mean?

Can I switch from 92 gasoline to 95 gasoline?

Is the RAV4's Engine an Imported Product?

How to Turn on the Air Conditioning in the Baojun 510?

Why is tree sap difficult to remove after being on the car for too long?